Краткое содержание страницы № 1
OWNER'S MANUAL
MODEL #:
DSB-F183L
S1
S/N : 3113909900
Краткое содержание страницы № 2
SAFETY INSTRUCTIONS PLEASE READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE INSTALLING AND OPERATING THE UNIT: This air conditioner meets strict safety and operating standards. The Precautions When Wiring: installer of this unit must install or service this unit so it operates safe- • Do not plug in the unit until all connections (tubing, drain hose, ly and efficiently. mounting, etc.) have been made and double-checked. • High voltages are present in this unit and are very dangerous. Please refer t
Краткое содержание страницы № 3
OPERATING SECTION LOCATION OF CONTROLS INDOOR UNIT Electric Dust Collector (Air clean Plasma) Removes small dust and generates (-) ions. Deodorizing Filter Removes bad smells from the air. AIR IN Sensor Wire Indoor Cover Air Cleaning Filters Removes dust and prohibits germs. AIR OUT Remote Fan Direction Sensor (Up/Down) Emergency/Remote Switch Indicators Indicate the Fan Direction AC setting. (Left/Right) LCD Remote Power Plug Controller OUTDOOR UNIT AIR IN Connection Cover Remove cover to acc
Краткое содержание страницы № 4
INDOOR UNIT DISPLAY Indoor Unit Display Switch Panel Remote Control Signal Receiver This place is the part to receive the signal if it receives the signal, you can hear the signal “beep. beep”. EMERGENCY REMOCON REMOCON EMERGENCY Air clean Timer (Yellow) (Green) Lights during the time reservation mode. There is a switch panel at inside of Front Panel. ON (Red) Quick (Red) At the time of operating, open the Front Panel. Lights when the Lights during the operation is going on. time Quick Emer
Краткое содержание страницы № 5
REMOTE CONTROLLER DSB-F183L AUTO Display Displays information pertaining to unit. ON/OFF Button (Blue) Press to turn the unit on or off. TEMPERATURE Buttons Press to raise or lower FAN SPEED Button the desired temperature. Press to select the fan speed (High " ", Middle " ", Low " "). MODE FAN SPEED FAN DIR. FAN DIR. Button Press to select up/down MODE Button direction for fan. SLEEP Press to cycle through the modes TIMER (Auto/Quick/Cool/Fan/Dehumidifier) ON/OFF ENTER/ TURBO/MIL
Краткое содержание страницы № 6
OPERATION CONNECTING THE AC CORD The outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the indoor unit to AC, follow the procedures below: 1. Insert the attached AC NOTES: plug into a 2-pronged • Never connect the AC line cord plug to other than the speci- Only 220V or fied voltage (Only 220V or 220V~240V). AC Outlet 220V~240V AC outlet. • Use the attached power cord only. and Plug • If the outlet is a 3-pronged type or other, have an elec
Краткое содержание страницы № 7
SETTING THE UNIT FOR REMOTE OPERATION After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation, follow the procedures below: 1. Open the indoor unit’s cover and make sure the EMER- 2. Press the ON/OFF button on the remote controller to turn GENCY/REMOTE switch on the unit. The On LED will light on the indoor unit and is set to the REMOTE “ON” will light in the remote display. position; this will allow the To select the various mo
Краткое содержание страницы № 8
SET UNIT TO QUICK MODE To set this unit to cool or heat (Heat pump model only) at the highest power, follow the procedures below: 1.Press the ON/OFF button on the remote control to 2.Press the MODE button until the Quick (“”) indi- turn the unit on; the On LED will light on the indoor cator blinks. unit and “ON” will light in the remote display. 3.The unit will then start cooling or heating the room at the highest power. TO SET UNIT TO COOL MODE To set the unit to cool the room to a desired temp
Краткое содержание страницы № 9
TO OPERATE ONLY FAN To operate only the fan so the unit will circulate the air, proceed as follows: 1.Press the ON/OFF button on the remote control to 2.Press the MODE button until the Fan indicator turn the unit on; the On LED will light on the indoor appears in the display. No allowance setting unit and “ON” will light in the remote display. temperature 3.To select a fan speed, press the FAN SPEED button until the desired speed appears in the display (see below). FAN SPEEDS “” The fan will op
Краткое содержание страницы № 10
TO SET UNIT TO HEAT MODE (ONLY HEAT PUMP MODEL) To set the unit to heat the room to a desired temperature, follow the procedures below: 1.Press the ON/OFF button on the remote control to 2.Press the MODE button until the Heat turn the unit on; the On LED will light on the indoor indicator appears in the display. unit and “ON” will light in In the heat mode, the fan direction (UP, the remote display. DOWN) is further downward than that in the cool mode for the good circulation. 3. Using the TEMP
Краткое содержание страницы № 11
TO SET THE ON TIMER MODE This unit can be set to automatically turn on after a predetermined amount of hours (up to 24) in the order of 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 5, 6, 8, 10, 12, 16, 20, 24. 1.Press the ON/OFF button of timer on the remote control to set the on timer mode, “HOUR” and “ON” on the remote display will be displayed and “TIMER” will be flicked. When you increase to press “ON/OFF” you will get desired time. Then, if pressing “ENTER/CANCEL” button, ON TIMER Mode will be started.
Краткое содержание страницы № 12
TO SET THE OFF TIMER MODE This unit can be set to automatically turn off after a predetermined amount of hours (up to 12) in the order of 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, 8, 8.5, 9, 9.5, 10, 11, 12. 1.Press the ON/OFF button of timer on the remote control to set the off timer mode, “HOUR” and “OFF” on the remote display will be displayed and “TIMER” will be flicked. When you increase to press “ON/OFF” you will get desired time. Then, if pressing “ENTER/CANCEL” button,
Краткое содержание страницы № 13
TO SET UNIT TO SLEEP MODE When you are going to sleep, select this feature and the unit will cool off the room to the desired temperature and then increase that temperature throughout the night. 1.Press the ON/OFF button on the remote control to 2.Press the MODE button to select the desired mode. turn the unit on; the On LED will light on the indoor Then, set the desired temperature using the TEMP. unit and “ON” will light in the remote display. or buttons. Press the SLEEP button on the remo
Краткое содержание страницы № 14
CHANGING/CLEANING THE AIR FILTERS To change or clean the two black air filters, follow the procedures below: 1. Open the indoor unit’s cover and remove both black 2. Remove the two small filters (Deodorizing and air filters by bending them slightly backward and the Electrostatic) from the indoor unit. lifting out. 3. Examine the filters and determine if they need to be 4. Insert cleaned or new small filters (Deodorizing and cleaned or replaced. To clean filters, use a vacuum Electrostatic) back
Краткое содержание страницы № 15
CLEANING THE INDOOR COVER To clean the indoor cover, follow the procedures below 1. Remove the left and right side to open the indoor 2. Open the door until 80 degree cover upward by two hand 80° NOTE: Please remove and insert the indoor by two hand 3. Pull right side to remove indoor cover hinge from 4. Remove the indoor cover frame grille hinge hole 5. Cleaning the indoor NOTES: • Wipe the indoor cover with soft sponge or soft cloth. • When cleaning up it in the state of opening the indoor cov
Краткое содержание страницы № 16
CARE AND MAINTENANCE warning • Make sure the AC cord is unplugged and the unit is off before cleaning. • Do not use water on the unit to clean it. This is a shock hazard and the unit can be damaged. Clean the casing and front of the indoor unit with a vacuum brush or wipe with a clean damp cloth. • NEVER USE Solvents, harsh chemicals or hot water to clean the unit. • Some metal edges on the unit are sharp. Be careful when cleaning or handling. • Internal parts in the outdoor unit may need cleani
Краткое содержание страницы № 17
TROUBLESHOOTING GUIDE Before requesting service, please refer to the chart below for possible solutions: SYSPTOMS POSSIBLE CAUSE POSSIBLE SOLUTIONS No power. Power failure. Restore the power Line voltage too low. Contact electrician to install new outlet. Unit is unplugged or not completely Insert plug all the way. plugged in. Unit is off. Turn unit on. Batteries in remote are weak or dead. Replace remote’s batteries. EMERGENCY/REMOTE Slide EMERGENCY/REMOTE switch is not set to REMOTE. to REMOTE
Краткое содержание страницы № 18
60 cm INSTRUCTION OF INSTALLATION Below is an overview for the connection of the Indoor unit to the Outdoor unit. OVERVIEW This appliance must be installed according to national power supply acquirement. 10cm (3.95in) from ceiling 30cm (11.8in) from side wall 10cm (3.95in) from Wall side wall Wall Drain Bracket Hose Wall Cap Oxygen tube At least 30cm (11.8in) from unit Pipes (Not Supplied) AC Connection AC Outlet (Not Supplied) and Plug Wrap with Tape Plug into 220V~240V AC Outlet Maximum Heig
