Руководство по эксплуатации Aqua Flo Tub-Master Series

Краткое содержание страницы № 1

OWNER'S MANUAL
®
TUB-MASTER SERIES PUMPS
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions
should always be followed, including the following:
A storable pool is constructed so that it may be readily
1. READ AND FOLLOW ALL
disassembled for storage and reassembled to its
INSTRUCTIONS. original integrity and has a maximum dimension of
18 feet (5.49m) and a maximum wall height of 42
inches (1.07m).
2. WARNING - To reduce the risk of inju

Краткое содержание страницы № 2

INSTALLATION & OPERATING INSTRUCTIONS GENERAL Your AQUA-FLO pump has been quality built and Joint Stick or any other sealants formulated specifically engineered to give maximum efficiency under normal for plastics. water pumping conditions. Consult the manufacturer for any other applications. STARTING & PRIMING PUMP Do not run unit dry. Always be certain that the pump LOCATION OF PUMP casing and/or trap is filled with water before starting the For best pump performance, locate the system as cl

Краткое содержание страницы № 3

® FLO-MASTER "TMCP" REPLACEMENT PARTS REF. REF. PART NO. DESCRIPTION PART NO. DESCRIPTION NO. NO. 1 Motor 7A 56910060 Replacement Kit, Cover Complete 2 92770603 Volute, TMCP Series 8 99730050 Screw, 8/32" x 5/8" 3 92500150 Seal, Replacement, #200 9 92200140 O'ring, #226 4 *See Chart Below * Impeller 10 91431050 Fitting, Tail Piece, 1-1/2" 5 92200270 O'ring, Volute, #251 11 91431000 Fitting, Union Nut, 1-1/2" 6 92830062 Wear Ring 12 52201000 Fitting, Compression Complete, 1-1/2" 7 569

Краткое содержание страницы № 4

ASSEMBLY INSTRUCTIONS (Including Impeller & Seal Replacement)
WARNING ELECTRIC SHOCK: ALWAYS DISCONNECT THE ELECTRICAL POWER FROM THE PUMP MOTOR BEFORE PERFORMING ANY WORK ON THE PUMP UNIT. To Disassemble Pump CAUTION: DRAIN THE WATER FROM THE PLUMBING LINES BEFORE DISCONNECTING THE PUMP. ALWAYS PROTECT THE MOTOR FROM POSSIBLE WATER DAMAGE. Removing the Suction Cover 1. Remove the cover by removing the screws securing the cover to the volute (casing). These screws are located at the perimete

Краткое содержание страницы № 5

with ceramic ring. Caution: Do not grip impeller sleeve. 3. Reinstall the wear ring over the impeller hub in correct orientation. Reinstalling the Suction Cover 1. Inspect the o-ring for damage. Replace if necessary. 2. Properly install the o-ring on the cover before mounting the cover to the volute. 3. Cover can be mounted to the volute in one orientation only. An ‘aligning’ feature is built-in with each part, to ensure proper mounting. When properly aligned, the cover should slide in easily. 4