Краткое содержание страницы № 1
Room Air Conditioner
MANUAL
OWNER'S
Models :
LG-BKE 7500 D - LG-BKE 7600 D
LG-BKE 7650 D - LG-BKE 7700 D
LG-BKE 7800 D
Prior to installation, this air-conditioning
unit must be submitted for approval by the
utility service which provides electricity
(EN 6055-3 Norm).
IMP OR T A NT
€ Pleas e read this owner's manual carefully and thoroughly
before ins talling and operating your room air conditioner.
€ Pleas e retain this owner's manual for future reference after
reading it thoroughly.
Краткое содержание страницы № 2
Room Air Conditioner Owner’s Manual TABLE OF CONTENTS FOR YOUR RECORDS Safety Precautions.........................3 Write the model and serial numbers here: Model # Serial # Prior to Operation ..........................9 You can find them on a label on the side of each unit. Dealer's Name Date Purchased Introduction ..................................10 Staple your receipt to this page in the event you need it to prove date of purchase or for warranty issues. Electrical Safety .................
Краткое содержание страницы № 3
ENGLISH Safety Precautions Safety Precautions To prevent the injury of the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications. This symbol indicates the possibility of death or serious injury. This symbol indicates the possibility of injury or damage to properties only. The meanings of the symbols used in this manual are as
Краткое содержание страницы № 4
Safety Precautions Be cautious when For installation, always Do not install the product unpacking and installing contact the dealer or an on a defective installation the product. Authorized Service Center. stand. • Sharp edges could cause injury. • There is risk of fire, electric • It may cause injury, accident, or Be especially careful of the shock, explosion, or injury. damage to the product. case edges and the fins on the condenser and evaporator. Be sure the installation area Do not let th
Краткое содержание страницы № 5
ENGLISH Safety Precautions Use a dedicated outlet for Grasp the plug to remove Do not place a heater or this appliance. the cord from the outlet. Do other appliances near the not touch it with wet hands. power cable. • There is risk of fire or electrical • There is risk of fire or electrical • There is risk of fire and electric shock. shock. shock. Do not allow water to run Do not store or use Do not use the product in a into electric parts. flammable gas or tightly closed space for a combustib
Краткое содержание страницы № 6
Safety Precautions Do not open the inlet grill of When the product is soaked Ventilate the product from the product during (flooded or submerged), time to time when operating operation. (Do not touch the contact an Authorized it together with a stove, etc. electrostatic filter, if the unit Service Center. is so equipped.) • There is risk of physical injury, • There is risk of fire or eletric • There is risk of fire or electrical electric shock, or product shock. shock. failure. Unplug the ap
Краткое содержание страницы № 7
ENGLISH Safety Precautions Do not install the product Use two or more people to Do not install the product where the noise or hot air lift and transport the air where it will be exposed to from the outdoor unit could conditioner. sea wind (salt spray) damage the neighborhoods. directly. • It may cause a problem for your • Avoid personal injury. • It may cause corrosion on the neighbors. product. Corrosion, particularly on the condenser and evaporator fins, could cause product malfunction or in
Краткое содержание страницы № 8
Safety Precautions Always insert the filter Do not insert hands or other Do not drink the water securely. Clean the filter objects through the air inlet drained from the unit. every two weeks or more or outlet while the air often if necessary. conditioner is plugged in. • A dirty filter reduces the • There are sharp and moving • It is not sanitary and could efficiency of the air conditioner parts that could cause personal cause serious health issues. and could cause product injury. malfunctio
Краткое содержание страницы № 9
ENGLISH Prior to Operation Prior to Operation Preparing for Operation 1. Contact an installation specialist for installation. 2. Plug in the power plug properly. 3. Use a dedicated circuit. 4. Do not use an extension cord. 5. Do not start/stop operation by plugging/unplugging the power cord. 6. If the cord/plug is damaged, replace it with only an authorized replacement part. Usage 1. Being exposed to direct airflow for a long time may be hazardous to your health. Do not expose occupants, pets, o
Краткое содержание страницы № 10
Introduction Introduction Symbols used in this Manual This symbol alerts you to the risk of electric shock. This symbol alerts you to hazards that may cause harm to the air conditioner. This symbol indicates special notes. NOTICE Features This appliance should be installed in accordance with national wiring regulations. This guide acts as a guide to help to explain product features. Indoor Air Inlet Front Panel Air Filter Signal Receptor Outdoor Air Intake Vents Connecting Wires Piping Air Outl
Краткое содержание страницы № 11
ENGLISH Electrical Safety Electrical Safety • This appliance must be properly grounded. To minimize the risk of electric shock, you must alway plug into a grounded oulet. • Do not cut or remove the grounding prong from the power plug. • Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal and not insulated, and the wall receptacle is grounded through the house wiring. • If you have any doubt whether the air condi
Краткое содержание страницы № 12
Operating Instructions Operating Instructions How to insert the Batteries 1. Remove the battery cover by pulling it according to the arrow direction. 2. Insert new batteries making sure that the (+) and (-) of battery are installed correctly. 3. Reattach the cover by sliding it back into position. NOTICE Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. Storage and Tips for using the Remote Controller • The remote controller may be stored by mounting • To operate the room air con
Краткое содержание страницы № 13
ENGLISH Operating Instructions Remote Control Operations The controls will look like the following. 1. START/STOP BUTTON Controls Operation starts when this button is pressed and stops when the button is pressed again. Signal transmitter 2. OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3. ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. 4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS. 5. JET COOL Used to st
Краткое содержание страницы № 14
Operating Instructions Cooling operation Press the Start/Stop button. 1 The unit will respond with a beep. Open the door of the remote controller. To select Cooling 2 Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Healthy Heating Changeover Dehumidification (Heat pump model only) Close the door of the remote controller. Set the temperature 3 lower than the room temperature. The te
Краткое содержание страницы № 15
ENGLISH Operating Instructions Auto operation (Optional) Press the Start/Stop button. 1 The unit will respond with a beep. Open the door of the remote controller. To select Auto 2 Operation, press the operation mode selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Healthy Heating Dehumidification (Heat pump model only) The temperature and fan speed are automatically set by the ON 3 electronic controls based on the act
Краткое содержание страницы № 16
Operating Instructions Auto changeover operation(Optional) Press the Start/Stop button. 1 The unit will respond with a beep. Open the door of the remote controller. To select Auto Changeover 2 Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Healthy Heating Changeover Dehumidification (Heat pump model only) Close the door of the remote controller. Set the temperature 3 lower than th
Краткое содержание страницы № 17
ENGLISH Operating Instructions Healthy dehumidification operation Press the Start/Stop button. 1 The unit will respond with a beep. Open the door of the remote controller. To select Healthy 2 Dehumidification Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Healthy Heating Changeover Dehumidification (Heat pump model only) Set the fan speed again with the door 3 of the remote control
Краткое содержание страницы № 18
Operating Instructions Heating operation (Heat pump model only) Press the Start/Stop button. 1 The unit will respond with a beep. Open the door of the remote controller. To select Heating 2 Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Healthy Heating Changeover Dehumidification (Heat pump model only) Close the door of the remote controller. 3 Set the temperature higher than the r
Краткое содержание страницы № 19
ENGLISH Operating Instructions Jet cool operation Press the Start/Stop button. 1 The unit will respond with a beep. Press the Jet Cool button to operate 2 the speed cooling mode and the unit will operate at super high fan speed on cooling mode for 30 minutes. For this operation P0 appears on the display. (Pl asma model only) To cancel the Jet Cool mode, press the Jet Cool button, the 3 fan speed button or the room temperature setting button again and the unit will operate at high fan speed o
Краткое содержание страницы № 20
Operating Instructions NEO PLASMA purification operation(Optional) Press the Start/Stop button. 1 The unit will respond with a beep. Open the door of the remote 2 controller. Press the PLASMA button. Operation will start when the button is pressed and stop when the button is pressed again. Make sure the plasma led lights up. Set the fan speed again with the door of the remote 3 controller closed. You can select the fan speed in four steps-low, medium, high or CHAOS. Each time the button is pre
