Краткое содержание страницы № 1
VoIP Analog Telephone Adapter
VIP-156/VIP156PE/VIP-157/VIP-157S
User’s manual
Version 3.1
1
Краткое содержание страницы № 2
Copyright Copyright (C) 2008 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable for
Краткое содержание страницы № 3
Revision User’s Manual for PLANET VoIP Analog Telephone Adapter: Model: ATA Rev: 3.1 (2008, February) Part No. EM-VIP_ATAV3.1 3
Краткое содержание страницы № 4
TABLE OF CONTENTS Chapter 1...................................................................................................................................6 Introduction ..............................................................................................................................6 Overview....................................................................................................................................................... 6 Package Content ...............
Краткое содержание страницы № 5
Codec ID Setting ................................................................................................................................37 DTMF Setting .................................................................................................................................... 38 RPort Settings..................................................................................................................................... 38 Other Settings...................................
Краткое содержание страницы № 6
Chapter 1 1 Introduction Overview Based on years of VoIP manufacturing experiences, PLANET Technology VoIP total solutions are known for advanced implementation of standards based telephony with mass deployment capability. Cost-effective, easy-to-install and simple-to-use, the PLANET VIP-156/VIP-157/VIP-157S VoIP Phone Adapter (“ATA” in the following term) converts standard telephones to IP-based networks. The service providers and enterprises offer users traditional and enhanced the
Краткое содержание страницы № 7
• Voice processing: Voice Active Detection, DTMF detection/ generation, G.168 echo cancellation (16mSec.), Comfort noise generation (CNG) • In band, out-of-band, and SIP-info DTMF support Package Content The contents of your product should contain the following items: VoIP Telephone Adapter Power adapter Quick Installation Guide User’s Manual CD RJ-11 cable x 1 Physical Details The following figure illustrates the front/rear panel of ATA. Respective model/descriptions are shown
Краткое содержание страницы № 8
Left / Right Panel of VIP-156 Front Panel of VIP-156PE Left / Right Panel of VIP-156PE 8
Краткое содержание страницы № 9
Front Panel of VIP-157 Left / Right Panel of VIP-157 Front Panel of VIP-157S 9
Краткое содержание страницы № 10
Left / Right Panel of VIP-157S LED Display & Button RJ-45 connector, to maintain the existing network structure, 1 PC connected directly to the PC through straight CAT-5 cable RJ-45 connector, for Internet access, connected directly to Switch/Hub through straight CAT-5 cable. 2 LAN The LAN interface also can be connected with 802.3af PoE switch or converter for power supply (VIP-156PE) 3 12V DC 12V DC Power input outlet 4 Reset Reset to the factory default setting M
Краткое содержание страницы № 11
LED display of VIP-156 / VIP-156PE LED Indicators Descriptions Power is supplied to the device. PWR STATUS The Status LED will be flashing when the machine is operational LNK/ACT OFF: the device is connected to LAN at 10Mb/s. ON: the device is connected to LAN at 100Mb/s. RING OFF: the phone is idle. ON: the phone is in use (offhook). Blinking: the phone is ringing. LED display of VIP-157 / VIP-157S LED Indicators Descriptions The Status LED will be flashing when the machine is ope
Краткое содержание страницы № 12
Chapter 2 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of ATA analog Phone Adapter ((“ATA” in the following term)) • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. • TCP/IP protocol must be installed on all PCs. For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable modem Administration Interface PLANET ATA provides GUI (Web based, Graphical User Inte
Краткое содержание страницы № 13
Please locate your PC in the same network segment (192.168.0.x) of ATA. If you’re not familiar with TCP/IP, Note please refer to related chapter on user’s manual CD or consult your network administrator for proper network configurations. LAN IP address configuration via web configuration interface Execute your web browser, and insert the IP address (default: 192.168.0.1) of VIP in the adddress bar. After logging on machine with username/password (default: root / no passwrd), browse to
Краткое содержание страницы № 14
Client Use the * (star) key DHCP will be disabled and #112xxx*xxx*xxx* Setup Static IP Address when entering a decimal system will change to the xxx# point. Static IP type. Use the * (star) key #113xxx*xxx*xxx* Set Network Mask when entering a decimal Must set Static IP first. xxx# point. Use the * (star) key #114xxx*xxx*xxx* Set Gateway IP Address when entering a decimal Must set Static IP first. xxx# point. Use the * (star) key #115xxx*xxx*xxx* Set Primary DNS Server when
Краткое содержание страницы № 15
address of the ATA. IVR will announce the current setting in the Check Primary DNS Server Setting #125# Primary DNS field. IVR will announce the current LAN port IP #126# Check LAN IP Address address of the ATA. IVR will announce the version of the Check Firmware Version #128# firmware running on the ATA. Following keypad commands can be used to set up the main function . IVR Menu Choice Machine operation Parameter(s) Notes: #138# Enable call waiting None Enable Call wai
Краткое содержание страницы № 16
Port Port enable forward to FXO Eanble forward to FXO #147+Number# Port Port Enable PPTP function None Enable PPTP function #116# #117# Disable PPTP function None Disable PPTP function Enable VLAN function None Enable VLAN function #118# #119# Disable VLAN function None Disable VLAN function Please contact your Internet service provider to obtain the Internet access type, and select the proper network settings Hint in ATA to establish the network connections. After
Краткое содержание страницы № 17
Chapter 3 3 Network Service Configurations Configuring and monitoring your ATA from web browser The ATA integrates a web-based graphical user interface that can cover most configurations and machine status monitoring. Via standard web browser, you can configure and check machine status from anywhere around the world. Overview on the web interface of ATA With web graphical user interface, you may have: More comprehensive setting feels than traditional command line interface. Provi
Краткое содержание страницы № 18
VoIP Phone Adatper main page 18
Краткое содержание страницы № 19
Chapter 4 4 VoIP Telephone Adapter Configurations Phone Book ATA can set up 140 records of Phone Book. User can dial the Name records to make calls via Phone Book feature. Field Description The default is Page 1. It can select Page1 ~ Page 14 Phone Book Page to look round Phone Book records. The record number from 0 ~ 139, it can set up 140 Phone records in total. The name of Phone Book records, it only can input Name numerals. Fill in the outgoing number (Line Number) or I
Краткое содержание страницы № 20
If you need to add a phone number into the Phone Book list, you need to input the position, the name, and the phone number (by URL type). When you finished a new phone list, just click the “Add Phone” button. If you want to delete a phone number, you can select the phone number you want to delete then click “Delete Selected” button. If you want to delete all phone numbers, you can click “Delete All” button. For Example: Ex_1: ATA had added the above phone numbers. User pick up the
