Руководство по эксплуатации Neumann.Berlin KM D AES 42

Краткое содержание страницы № 1

KM D Accessories
Solution-D

Краткое содержание страницы № 2

Elastic Suspensions Elastic Suspension EA 2124 A mt The EA 2124 A mt is able to accept mi- crophones from 21 to 24 mm in diame- ter. It has a swivel mount with a 5/8"-27 female thread, plus a thread adapter to connect to 1/2"- and 3/8" stands. EA 2124 A mt ...... blk ........ Cat. No. 008433 Table and Floor Stands Table Stand MF 2 Floor Stand MF 5 Small table stand with brass base, very Floor stand with grey soft-touch powder sturdy. It has a black matte finish. The coating. It has a non-skid so

Краткое содержание страницы № 3

Auditorium Hangers Auditorium Hanger MNV 21 mt Auditorium Hanger MNV 100 The auditorium hanger adjusts the tilt- The MNV 100 auditorium hanger is used ing angle of a microphone suspended by to suspend a detached miniature micro- its own cable. The MNV 21 consists of phone capsule freely from its intercon- the tilting clamp, suitable to hold a Neu- necting cable. The assembly can be ro- mann miniature microphone or KMR 81, tated and tilted to any desired angle. and a locking cable strain relief.

Краткое содержание страницы № 4

Stand Mounts and Miscellaneous Mechanical Adapters Stand Mount SG 109 Stereo Mount STH 100 Swivel mount for detached miniature mi- Stereo mount with a swivel mount and crophone capsules. It has a 3/8" thread. two holders, for two detached miniature microphone capsules. Two stereo re- SG 109 ................. blk ........ Cat. No. 008614 cording methods are then possible. One holder enables the microphone set- up according to the “ORTF Method”: Two detached capsules are snapped into the clamps a

Краткое содержание страницы № 5

Foam Windscreens Close range sounds, wind, and fast movements of the microphone tional pattern. Only in the upper frequency range is the output lev- boom, all may cause interfering noises. To avoid these unwanted el slightly attenuated. The wind noise attenuation was measured sounds, windscreen accessories are available. Typically, they are without electrical filtering in a turbulent air stream traveling at made out of open-cell polyurethane foam. These windscreens do 20 km/h, generated by a noi

Краткое содержание страницы № 6

Capsule Extensions for Miniature Microphone System KM D Any KVG ... capsule extension allows to use the KK 1... capsules At the capsule end, the swivel can be set through ± 110°. The separated from the output stage without the need for additional KVG ... are mounted with MZGE 8000 or 8002 on MZEF ... vertical cables. The rigid part of the capsule extension is 8 mm in diameter. bars. Special lengths on request. Capsule Extension KVG 130 nx Capsule Extension KVG 1120 nx The extended length of the

Краткое содержание страницы № 7

Capsule Heads for Miniature Microphone System KM D KK... capsule heads are part of the variable miniature microphone heads form a complete microphone. KK 131 and KM D (nx), for ex- system. Together with the KM D (nx) output stage KK... capsule ample, make up the KM 131 (nx). Capsule Head KK 131 (nx) Capsule Head KK 183 (nx) KK 131 is a free-field equalized pressure KK 183 is a diffuse-field equalized pres- transducer. The sensitivity in the free sure transducer with a free-field treble sound fie

Краткое содержание страницы № 8

Digital Microphone Interface and Power Supplies Digital Microphone Interface DMI-2 2 channels, Equipment that supports the new AES 42 standard can process the Inputs: ..................................... XLR3F, AES 42 output signals of Solution-D microphones directly. In all other cas- Outputs: ................... XLR3M, AES/EBU, 24 bit es, the DMI-2 digital microphone interface is used. The DMI-2 is a separate, two-channel device which converts the AES 42 data for- Control bus: ...............