Краткое содержание страницы № 1
M ODEL 315W W INE C OOLER
INSTALLATION&OPERATION
Краткое содержание страницы № 2
CONTENTS Model 315W Features 4 Model 315W Installation 5 Installation Checklist 13 Model 315W Operation 14 Troubleshooting Guide 17 Service Information 18 Sub-Zero Warranty 19 Features and specifications indicated herein and on the website are subject to change at any time without notice. Check our website, subzero.com, for the most up-to-date specifications. As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and eff
Краткое содержание страницы № 3
SUB-ZERO MODEL 315W INSTALLATION AND OPERATION THANK YO U Congratulations on the purchase of your The Model 315W wine cooler is protected by Sub-Zero Model 315W wine cooler. This unit is a warranty that is one of the finest in the designed and manufactured in the Sub-Zero industry. Take a moment to read the warranty tradition of superior quality and reliability. statement on page 19 and refer to it should service become necessary. The importance of the installation of the Model CONTACT 315W wine
Краткое содержание страницы № 4
SUB-ZERO MODEL 315W FEATURES MODEL 315W FEATURES Undercounter wine cooler with 26 Full-view glass door with UV resistant glass (750 ml) bottle capacity protection Overlay and stainless steel design options High altitude glass door Ideal humidity and temperature range of Discreet low voltage interior lighting WARRANTY 45˚F (7˚C) to 55˚F (13˚C). UL approved for US and Canada Sturdy, rustproof wire shelves accommo- Two, five and twelve year residential Sub-Zero products date standard 750 ml bottles
Краткое содержание страницы № 5
SUB-ZERO MODEL 315W INSTALLATION INSTALLATION SPECIFICATIONS MODEL 315W DIMENSIONS 1 Overall Width 15 /8" (384) 1 Overall Height 34 /16" (865) 5 Overall Depth – 315W/S 23 /32" (588) 3 Overall Depth – 315W/O 22 /8" (568) 1 Rough Opening Width 15 /4" (387) 1 Rough Opening Height 34 /2" (876) Minimum Height Required 1 (levelers in) 34 /16" (865) Rough Opening Depth 24" (610) 1 + _ Dimensions may vary /8" (3). OVERALL DIMENSIONS Stainless steel unit shown OVERALL DEPTH 5 1 23 /32" (588) MODEL 315W/S
Краткое содержание страницы № 6
SUB-ZERO MODEL 315W INSTALLATION INSTALLATION SPECIFICATIONS AREA REQUIREMENTS Wine bottles are heavy. A fully loaded Before moving the unit into place, be sure that unit will weigh over 200 lbs (91 kg). Be the rough opening dimensions, electrical sure the subflooring is adequate for the location, and minimum door clearances are weight of both the unit and its contents. accurate. Refer to the illustration below. Also Refer to page 5 for overall dimensions. Be sure your electrician and cabinet in
Краткое содержание страницы № 7
R E D L O C SUB-ZERO MODEL 315W INSTALLATION ELECTRICAL REQUIREMENTS KICKPLATE AIRFLOW A 115 V AC, 60 Hz, 15 amp circuit breaker and The wine cooler uses a fan to take in room air electrical supply are required. A separate through vents in the left side of the kickplate, circuit is required for each unit. and discharges warm air through vents in the right side. These vents must be kept clear of The Model 315W is equipped with a power obstructions or decorative panels. Blocking or supply cord wit
Краткое содержание страницы № 8
SUB-ZERO MODEL 315W INSTALLATION BLOCKING FOR SAFETY LEVELING THE UNIT To prevent the unit from tipping forward Shut off the power to the electrical outlet. if multiple loaded bottle racks are pulled out at one time, and to provide a stable installation, the unit must be secured in IMPORTANT NOTE: The unit must be leveled place with an anti-tip device. prior to placing it in the rough opening. There are four leveling legs on the Model A metal antip-tip bracket and screws are 315W, one at each co
Краткое содержание страницы № 9
SUB-ZERO MODEL 315W INSTALLATION KICKPLATE INSTALLATION PANEL CONSIDERATIONS Once the Model 315W is in place, you can The Model 315W offers two door panel design install the kickplate. There is some adjustment alternatives; stainless steel (/S) or overlay (/O). to the mounting assembly so that the kickplate Both of these design options are available with will fit flush with the surrounding area. Be sure glass (G) doors. that nothing obstructs the vents of the kick- Model 315W/S (classic stainles
Краткое содержание страницы № 10
SUB-ZERO MODEL 315W INSTALLATION OVERLAY PANELS 5 OVERLAY PANEL SPECIFICATIONS Inspect the door panel for the minimum /8" (16) thickness, the finished inside edge and the 1 Door Panel Width – /8" (3) reveal* 15" (381) 10 lbs (5 kg) weight limit. See the Wine 7 Door Panel Height – /16" (11) reveal** Storage section of the Sub-Zero Design Guide 1 4" (102) toe space 30 /16" (764) for additional panel information. Check our PANEL website at subzero.com. 1 Width of Rails and Stiles 2 /4" (57) min DES
Краткое содержание страницы № 11
SUB-ZERO MODEL 315W INSTALLATION OVERLAY PANEL INSTALLATION A decorative panel is attached to the Model IMPORTANT NOTE: After the first three or 5 315W door using #8 x /8" (16) square drive four mounting screws are in place, but not screws passing through the door frame from completely tightened, close the door and check the rear, behind the gasket into the panel. The your panel fit. This is the time to make small door panel is marked for screw locations by adjustments. Once you are satisfied wi
Краткое содержание страницы № 12
SUB-ZERO MODEL 315W INSTALLATION OVERLAY PANEL INSTALLATION IMPORTANT NOTE: Install screws in all the mounting holes in the door frame. The nature The wine cooler door is made with of the door panel with a narrow outer rim and a sealed double wall tempered glass core. no connecting center member requires the The drill must not contact this core when support provided by the glass door. drilling. Be sure the hole is centered on PANEL the small groove in the front of the door After the door panel i
Краткое содержание страницы № 13
SUB-ZERO MODEL 315W INSTALLATION INSTALLATION CHECKLIST IMPORTANT NOTE: To ensure a safe and proper installation, the following checklist If you are storing or disposing of your old should be completed by the installer to ensure refrigerator or freezer, please do it safely. that no part of the installation has been Remove the doors or tightly secure the overlooked. doors closed. Child entrapment accidents CONTACT can be tragic. Any questions or problems about the installa- INFORMATION tion shoul
Краткое содержание страницы № 14
SUB-ZERO MODEL 315W OPERATION USING YOUR WINE COOLER Your wine cooler is extremely simple to use, When fully loaded with room temperature just turn the control knob to the ON position. wine, the Model 315W will operate continu- The Model 315W will automatically begin to ously for as long as 24 hours to reach the cool and will continue to do so until the set desired temperature. After reaching the set temperature is reached. temperature, the unit will begin to cycle on and off. The Model 315W ope
Краткое содержание страницы № 15
SUB-ZERO MODEL 315W OPERATION WINE SHELVES Model 315W has roller-assembly shelves with WINE SHELF REMOVAL a full three-quarter extension for easy access To remove a wine shelf, pull the shelf out to its to wine bottles. Each wine shelf holds four full extension, gently and evenly lift up on both (750 ml) bottles. An additional two (750 ml) sides of the front of the shelf and remove. bottles may be placed on the bottom station- Reverse the procedure to reinstall the shelf. DESIGN ary shelf for a
Краткое содержание страницы № 16
SUB-ZERO MODEL 315W OPERATION CLEANING EXTERIOR CLEANING CLEANING THE CONDENSER To clean the classic stainless steel exterior of the Model 315W/S, use a soft, nonabrasive Before cleaning the condenser and other stainless steel cleaner like Signature Polish routine maintenance, shut off power at (see side note) and apply with a soft 100% the circuit breaker suppling power to the SIGNATURE lint-free cloth. electrical outlet. POLISH If anything spills onto the door gasket, wash with soap and warm w
Краткое содержание страницы № 17
SUB-ZERO TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION Cabinet too warm Unit switched off Check temperature control Cabinet temperature Temperature control setting Check temperature setting SERVICE changed changed CENTER Excessive operating time Dirty condenser Clean condenser Contact your Cabinet full of warm wine Unit must operate for up to 24 Sub-Zero dealer or hours to cool warm wine check the Locator section of our Door gasket not sealing tightly Check
Краткое содержание страницы № 18
SERVICE INFORMATION SERVICE INFORMATION If you do need service, be sure to have the PRODUCT REGISTRATION model and serial number of your unit when Register your new Sub-Zero today so that we you call. You’ll find these numbers on the may ensure your satisfaction. You may register model and serial number plate located on the by one of the following options: underside of the top wall. For warranty CONTACT purposes, you will also need the date of 1) Mail in the completed Sub-Zero Product INFORMATIO
Краткое содержание страницы № 19
SUB- ZERO FREEZER COMPANY PRODUCTS LIMITED WARRANTY RESIDENTIAL USE ONLY FULL FIVE YEAR SEALED SYSTEM WARRANTY LIMITED SIXTH THROUGH TWELFTH YEAR WARRANTY ON THE SEALED SYSTEM FULL TWO YEAR WARRANTY ON TOTAL PRODUCT* FULL FIVE YEAR SEALED SYSTEM WARRANTY For five years from the date of original installation, your Sub-Zero warranty covers all parts and labor to repair or replace any components that prove to be defective in materials or workmanship in the sealed system. The sealed system consists
Краткое содержание страницы № 20
SUB-ZERO FREEZER COMPANY, INC. P. O. BOX 44130 MADISON, WI 53744-4130 800-222-7820 SUBZERO.COM 173 08001 8/2005
