Руководство по эксплуатации Simplicity 5100777

Краткое содержание страницы № 1

Front End Repair Kit
Installation
Part No. 5600079
For Simplicity Citation Models
Instructions
Kit Contents:
Front end No. Qty. Description
B
5402029C 1 Front End Weldment
5402041C 2 Bracket, Bolt on
5022098 4 Cap, Plastic
5025156 10 Washer, 3/8” SAE
5025013X10 4 Bolt, 3/8-16 X 1-1/4”
5025013X20 4 Bolt, 3/8-16 X 2-1/2”
5025013X28 4 Bolt, 3/8-16 X 3-1/2”
5025394 10 Nut, 3/8-16 Hex Nylock Flange
5021072 2 Seal, Grease
A A
5025203X10 2 Pin, Cotter
5047489 1 Spacer
Figure 1. Position of Wooden Block

Краткое содержание страницы № 2

Installation Instructions Kit Part No. 5600079 7. Install the plastic end caps (B, Figure 4) in the ends of the cut cross member (A) and the new front end (C). A B C Figure 4. Install Plastic End Caps A. Cut Cross Member B. Plastic End Cap C. New Front end 8. Position from the bottom the new front end against the frame as shown in Figure 5. Then slide toward the rear of the machine until the c-channel of the new front end rests over the front cross member that was cut. Figure 5. Install New Fron

Краткое содержание страницы № 3

Installation Instructions Kit Part No. 5600079 9. Loosely install the rear brackets (F, Figure 6) to the new front end with the 3/8-16 X 1-1/4” bolts (C), 3/8- B E 16 X 3-1/2” bolts (B), 3/8 SAE washers (D), and 3/8- 16” nylon flange nuts (E). Snugly clamp the front of the new front end to the cross member using (2) C- clamps (See Figure 7).NOTE: Do not over tighten the D clamps. A E F D C Figure 6. Loosely Install the Rear Brackets A. 3/8-16 X 2-1/2 Bolt B. 3/8-16 X 3-1/2 Bolt C. 3/8-16 X 1-1/4

Краткое содержание страницы № 4

Installation Instructions Kit Part No. 5600079 11. Remove the caster wheels yokes from the old front A B end assembly. Refer to Figure 9, install the removed yokes (G) and spacer (I) in to the new front end C D assembly. If needed, clean and re-grease tapered bearings before installation. Install the new caster 23 E H pivot frame (H) to the frame with the new 3/4” hardware (J, K, L) provided. 23 22 E 21 F L G I K J Figure 9. Caster Pivot Frame Assembly A. Cap B. Slotted Nut C. Cotter Pin D. 3/4”