Краткое содержание страницы № 1
OPERATOR’S MANUAL
MODEL SCR
PART NUMBER 03103
Краткое содержание страницы № 2
WARNING:
Краткое содержание страницы № 3
Section 1 GENERAL INFORMATION For pictorial clarity, some illustrations and figures in this 1.1 INTRODUCTION manual may show shields, guards or plates open or removed. Under no circumstances should your mower Your mower was built to the highest standards in the be operated without these devices in place. industry. However, the prolonged life and maximum efficiency of your mower depends on you following the All information is based upon product information operating, maintenance and adjustment
Краткое содержание страницы № 4
ISO Symbols CE Mark SYMBOL DESCRIPTION SYMBOL DESCRIPTION Choke Transmission Parking Brake Spinning Blade 48071S On/Start Spring Tension on Idler Off/Stop Oil WARNING Falling Hazard FALLING HAZARD USE ONLY SCAG APPROVED RIDING ATTACHMENTS 481109 SEE OPERATOR'S MANUAL 2
Краткое содержание страницы № 5
SYMBOL DESCRIPTION SYMBOL DESCRIPTION Fast Slow Cutting element - Basic symbol Continuously variable - Linear Pinch Point Cutting element - Engage 481039S Hourmeter/elapsed operating hours Cutting element - Disengage Keep bystanders away Read operator's manual 3
Краткое содержание страницы № 6
Section 2 SAFETY INFORMATION 2.1 INTRODUCTION Your mower is only as safe as the operator. Carelessness The signal word “DANGER” denotes that an extremely or operator error may result in serious bodily injury or hazardous situation exists on or near the machine that could death. Hazard control and accident prevention are result in high probability of death or irrepairable injury if dependent upon the awareness, concern, prudence, and proper precautions are not taken. proper training of the pers
Краткое содержание страницы № 7
Section 2 5. DO NOT wear loose fitting clothing that could get 12. Equipment must comply with the latest requirements tangled in moving parts. Do not operate the machine per ANSI J137 and/or ANSI S279 when driven on wearing shorts; always wear adequate protective public roads. clothing including long pants. Wearing safety glasses, -NOTE- safety shoes and a helmet is advisable and is required If the mower is driven on public roads, it must by some local ordinances and insurance regulations. com
Краткое содержание страницы № 8
Section 2 5. Before attempting to start the engine, with the 15. DO NOT touch the engine or the muffler while the operator in the seat, disengage power to the cutter engine is running or immediately after stopping. deck, place the hopper in the stowed position, These areas may be hot enough to cause a burn. steering control levers in the neutral position and engage the parking brake. 16. DO NOT run engine inside a building or confined area without proper ventilation. Exhaust fumes are 6. If the
Краткое содержание страницы № 9
Section 2 2.6 SAFETY AND INSTRUCTIONAL DECALS WARNING INSTALL BELT COVER BEFORE OPERATING MACHINE READ OPERATOR'S MANUAL 481039 7
Краткое содержание страницы № 10
Section 3 SPECIFICATIONS 3.1 ENGINE General Type .............................................................................. Heavy Duty Industrial/Commercial Gasoline Brands ........................................................................................ Kohler & Kawasaki Model ......................................................................................... 25 HP Kohler Command CH25S & 27HP Kawasaki FD750D Horsepower ..........................................................
Краткое содержание страницы № 11
Section 3 -NOTE- 3.3 TRACTOR (CONT'D) The machine will travel at 8.5 mph for Travel Speed: transport purposes. For best cutting Forward ................................................................................. 0 - 8.5 MPH performance the forward travel speed Reverse .................................................................................. 0 - 5.0 MPH should be adjusted depending upon the 3.4 CUTTER DECK cutting conditions. No. of Blades ..........
Краткое содержание страницы № 12
Section 4 OPERATING INSTRUCTIONS 2. Mower Deck Control (Figure 4-1). Used to engage and disengage the mower drive system. Pushing the CAUTION: lever forward will engage the deck drive. Pulling the Do not attempt to operate this mower unless you lever back will disengage the deck drive. have read this manual. Learn the location and purpose of all controls and instruments before you 3. Engine Choke Control (Figure 4-1). Used to operate this mower. start a cold engine. 4. Engine Throttle Control
Краткое содержание страницы № 13
Section 4 6. Hour Meter (Figure 4-1). Indicates the number of hours the engine has been operated. It operates whenever the ignition switch key is in the ON position. It can be used to keep track of maintenance intervals and the amount of time required to perform various tasks. 7. Fuse Holders (Figure 4-1). Two 20-amp fuses protect the mower’s electrical system. To replace fuses, pull fuse out of the socket and install a new fuse. Right Left Dump Dump 8. Left Steering Control (Figure 4-1).
Краткое содержание страницы № 14
Section 4 3. If the engine is cold, adjust the engine choke as needed. WARNING: Never operate the mower with the interlock 4. Adjust engine throttle control to about half engine system disconnected or malfunctioning. Do not speed. disengage or bypass any switch; injury to yourself and others or property damage could result. 5. Turn the ignition key to the START position and release the key as soon as the engine starts. Do not hold the key in the START position for more than 15 4.3 INITIAL RUN-I
Краткое содержание страницы № 15
Section 4 In case of an emergency, such as loss of control, To steer the mower left while traveling forward, pull the stop the mower’s movement by quickly pulling the left steering lever back. The further the lever is pulled forward speed control lever to the neutral position. back, the sharper the mower will turn left. To steer the mower right while traveling forward, pull the Forward Travel right steering control lever back. The further the lever is pulled back, the sharper the mower will tur
Краткое содержание страницы № 16
Section 4 To steer left while traveling in reverse, allow the left 3. To disengage the deck drive, pull back the Cutter steering control lever to move forward. The further the Deck Control Lever to the disengage position. control is allowed to move forward, the sharper the mower will turn left. 4. Always operate the engine at full throttle to properly maintain cutting performance. If the engine starts to To steer right while traveling in reverse, allow the right lug down, reduce the forward sp
Краткое содержание страницы № 17
Section 4 4. Fill the fuel tank with fresh, clean fuel at the end of every day of operation. 5. Check the tire pressure. Inflate tires if necessary. 4.10 HOPPER, MULCH or SIDE DISCHARGE OPERATION When mowing with the cutting deck setup for rear discharge into the hopper (Figure 4-9), the blower belt must be installed. A control lever located on the left side of the tractor (Figure 4-8) will release tension on the idler pulley to allow the belt to be installed (grass catching operation)
Краткое содержание страницы № 18
Section 4 Grass Catching Operation Lock Pin and Latch Plate CAUTION: Never leave grass clippings in the hopper after mowing. Wet or damp clippings will generate heat as they decompose which may cause spontaneous combustion to occur. 1. With the hopper lowered, engage the deck drive. When the deck drive is engaged, the grass delivery spout, which is designed to distribute the grass clippings through the inside of the hopper, will begin to oscillate. -NOTE- The mower has an interlock switch that
Краткое содержание страницы № 19
Section 4 E. Release the latch holding the tailgate and then Mulching Operation lower the tailgate. Rear Discharge Shutoff Baffle Side Discharge Operation CAUTION: The side discharge deck can throw objects with great force. Do not stand in front of discharge chute when the cutter deck is engaged. Keep bystanders clear from the area while mowing. SCR 2K BMD Side Discharge Shutoff Baffle When mowing, never discharge toward bystanders or Figure 4-13 Baffles for Mulching buildings. Do not allow a
Краткое содержание страницы № 20
Section 4 4.12 MOVING MOWER WITH ENGINE 4.14 ADJUSTING CUTTING HEIGHT STOPPED The mower deck can be adjusted from a height of 1 1/2- inches to 5-inches at 1/2-inch intervals. To adjust the cutting To “free-wheel” or move the mower around without the height: engine running, place the dump valve handle in the FREE-WHEEL position (Figure 4-2, Page 11). Disengage the parking brake and move the mower by hand. The lever must be returned to the DRIVE position WARNING: to drive the mower. Do
