Краткое содержание страницы № 1
02494
LT18542
Owner's Manual
Краткое содержание страницы № 2
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Avoid starting or stopping on a slope. If tires lose trac- I. GENERAL OPERATION tion, disengage the blades and proceed slowly straight Read, understand, and follow all instructions in the down the slope. manual and on the machine before
Краткое содержание страницы № 3
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS Be sure the area is clear of other people before mowing. Stop WARNING: In order to prevent ac- machine if anyone enters the area. ci den tal starting when setting up, Never carry passengers or children even with the blades trans port ing, ad just ing or making re- off. pairs, alwa ys dis con nect spark plug Do not mow in reverse unless absolutely necessary. Al ways wire and place wire where it can not look down an
Краткое содержание страницы № 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu factured to giv e you the best possible dependability and performance. Gasoline Capacity 1.25 Gallons and type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type (API-SF-SJ): SAE 30 (above 32°F) edy, please contact your nearest authorized service center/ SAE 5W-30 (below 32°F) department. We have com pe tent, well-trained tech ni cians O
Краткое содержание страницы № 5
CONTENTS OF HARDWARE PACK Steering Wheel Seat Steering Boot (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Wheel Steering (1) Lock Insert Extension Washer 1/2 Shaft (1) Bolt Steering Wheel Adapter (1) Oil Drain Tube (1) Locknut 1/2-20 Keys Slope Sheet (2) Keys (1) Locknut 1/4-28 (1) Large Flat Washer (1) Hex Bolt 1/4-28 x 1-1/4 5
Краткое содержание страницы № 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard INSERT wrench sizes are listed. (2) 7/16" wrenches Utility knife 1/2 HEX NUT (2) 3/4" wrench Tire
Краткое содержание страницы № 7
ASSEMBLY HOW TO SET UP YOUR TRACTOR SEAT PAN INSTALL SEAT (See Fig. 2) Adjust seat before tightening adjustment bolt. LABEL Remove adjustment bolt, lock washer and fl at washer se curing seat to cardboard pac king and set aside for as sem bly of seat to tractor. Pivot seat upward and remove from the cardboard pack- TERMINAL ing. Remove the cardboard packing and discard. TERMINAL Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan. 02602
Краткое содержание страницы № 8
ASSEMBLY CHECK TIRE PRESSURE ✓CHECKLIST The tires on your tractor were overinfl ated at the factory BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- for shipping purposes. Correct tire pressure is important TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE for best cutting performance. BEST PER FOR MANCE AND SATISFACTION FROM THIS Reduce tire pressure to PSI shown in “PRODUCT QUALITY PROD UCT. SPEC I FI CATIONS” section of this manual. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly in
Краткое содержание страницы № 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. IGNITION REVERSE HIGH LOW FAST SLOW NEUTRAL CHOKE P LIGHTSON ENGINEON ENGINESTART PARKINGBRAKE PARKINGBRAKE PARKINGBRAKE ENGINEOFF LOCKED UNLOCKED FUEL OILPRESSURE BATTERY REVERSE FORWARD OVERTEMP MOWERHEIGHT MOWERLIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPEHAZARDS CLUTCHENGAGED CLUTCHDISENGAGED DANGER,KEEPHANDS KEEPAREACLEAR ANDFEETAWAY (SEESAFETYRULESSECTION) DA
Краткое содержание страницы № 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. IGNITION LIGHT SWITCH SWITCH ATTACHMENT POSITION CLUTCH LEVER AMMETER LIFT LEVER THROTTLE/ PLUNGER CHOKE CONTROL ATTACHMENT LIFT LEVER HEIGHT CLUTCH/ ADJUSTMENT BRAKE LEVER PEDAL PARKING BRAKE GEAR SHIFT LEVER FIG. 4 Our tract
Краткое содержание страницы № 11
OPERATION The operation of an y tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. 00155 NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “brown
Краткое содержание страницы № 12
01423 01994 OPERATION NOTE:Adjust gauge wheels with tractor on a fl at level CAUTION: Do not operate the mower surface. without either the en tire grass catcher, Adjust mower to desired cutting height (See “TO AD- on mowers so equipped, or the defl ec- JUST MO WER CUT TING HEIGHT” in the Operation tor shield in place. sec tion of this manual). With mower in desired height of cut po si tion, gauge TO OPERATE ON HILLS wheels should be assembled so they are slightly off the ground.
Краткое содержание страницы № 13
OPERATION COLD WEATHER STARTING ( 50° F and below) ADD GASOLINE When engine starts, allow engine to run with the throttle Fill fuel tank to bottom of fi ller neck. Do not overfi ll. control in the choke ( ) position until the engine r uns Use fresh, clean, regular un lead ed gasoline with a roughly, then move throttle control to fast position. This minimum of 87 octane. (Use of leaded gasoline will may require an engine warm-up period from several increase carbon and lead oxid
Краткое содержание страницы № 14
maint_sch-tractore.new1 MAINTENANCE MAINTENANCESCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air
Краткое содержание страницы № 15
MAINTENANCE TRACTOR TRAILING MANDREL BLADE EDGE UP ASSEMBLY Always observe safety rules when performing any main- CENTER te nance. HOLE FLAT WASHER BRAKE OPERATION STAR If tractor requires more than six (6) feet stopping distance LOCK WASHER at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Ad just ments BLADE BOLT section of this manual). FIG. 9 TIRES Maintain proper air pressure in all tires (See “PROD UCT TO SHARPEN BLADE (See Fig
Краткое содержание страницы № 16
MAINTENANCE TO CLEAN BATTERY AND TERMINALS OIL DRAIN VALVE Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. CLOSED Disconnect BLACK battery cable fi rst then RED bat- AND ter y cable and remove battery from tractor. LOCKED POSITION Rinse the battery with plain water and dry. Clean terminals and battery cable ends with wire brush until bright. Coat terminals with grease or petroleum jelly. DRAIN YEL LOW CAP TUBE Reinstall batte
Краткое содержание страницы № 17
02698 00667 MAINTENANCE MUFFLER HAN DLE Inspect and replace corroded muffl er and spark arrester (if equipped) as it could create a fi re hazard and/or dam- age. SPARK PLUGS Replace spark plugs at the beginning of each mowing sea- son or after every 100 hours of use, whichever comes fi rst. Spark plug type and gap setting is shown in "PROD UCT SPECIFICATIONS" section of this manual. IN-LINE FUEL FILTER (See Fig. 15) The fuel fi lter should be replaced once each season. If fuel fi lter bec
Краткое содержание страницы № 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
Краткое содержание страницы № 19
01156 SERVICE AND ADJUSTMENTS FRONT-TO-BACK ADJUSTMENT (See Figs. 19 and 20) TO LEVEL MOWER HOUSING IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE Adjust the mower while tractor is parked on level ground FOLLOWING FRONT -TO-BACK ADJUSTMENT IS NECESSARY , or driveway. Make sure tires are properly infl ated (See BE SURE TO AD JUST BOTH FRONT LINKS EQUAL LY SO “PROD UCT SPECIFICATIONS” section of this manual). If MOWER WILL STAY LEVEL SIDE-TO-SIDE. tires are over or underinfl
Краткое содержание страницы № 20
02314 SERVICE AND ADJUSTMENTS TO ADJUST BRAKE TO REPLACE MOWER BLADE DRIVE BELT Depress clutch/brake pedal all the way down and en- (See Fig. 21) gage parking brake. The mower blade drive belt may be replaced without tools. Measure distance between brake operating arm and Park the tractor on level surface. Engage parking brake. nut “A” on brake rod. BELT REMOVAL - If distance is other than 1-1/2", loos en jam nut and turn Remove mower from tractor (See “TO REMOVE nu
