Краткое содержание страницы № 1
02494
LT16542
Owner's Manual
Краткое содержание страницы № 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. � Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and WARNING: In order to prevent ac- working. ci den tal starting when setting up, � Slow down before turning. trans porting, ad just
Краткое содержание страницы № 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to � Never operate machine in a closed area. � Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. � Never tamper with safety devices. Check their proper children will remain where you last saw th
Краткое содержание страницы № 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES � Read and observe the safety rules. Gasoline Capacity 1.25 Gallons and Type: Unleaded Regular � Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) � Follow the instructions under “Maintenace” and “Stor- age” sec tions of this own er’s manual.
Краткое содержание страницы № 5
CONTENTS OF HARDWARE PACK Steering Wheel Seat (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Boot Steering Wheel (1) Knob Insert Steering Wheel Adapter Key Steering Extension (1) Large Flat Shaft Washer (2) Keys (1) Oil Drain Tube Slope Sheet (1) 5/16 Lock Washer (1) Hex Bolt 5/16-18 x 4 5
Краткое содержание страницы № 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY INSERT A socket wrench set will make assembly easier. Stan dard 5/16 HEX BOLT wrench sizes are listed. 5/16 LOCK (1) 1/2" wrench Utility knife WASHER Plier
Краткое содержание страницы № 7
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. Follow the ap pro pri ate instruction below to remove the SEAT SHOULDER tractor from the skid. BOLT W ARNING: Before start ing, read, un der stand and fol low all in struc tions in the Op er a tion section of this manu al. Be sure tractor is in a well-ventilated area. Be sure the area in SEAT PAN front of tractor is clear of other peo ple and objects. TO ROLL TRACTOR OFF SKID (See Op- er a tion section for location a
Краткое содержание страницы № 8
ASSEMBLY ✓CHECKLIST CHECK TIRE PRESSURE BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE The tires on your tractor were overinfl ated at the factory WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- for shipping purposes. Correct tire pressure is important FOR MANCE AND SAT IS FAC TION FROM THIS QUALITY for best cutting performance. PROD UCT. � Reduce tire pressure to PSI shown on tires. PLEASE REVIEW THE FOLLOWING CHECKLIST: CHECK DECK LEVELNESS ✓ All assembly instructions have been completed.
Краткое содержание страницы № 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. HIGH LOW FAST SLOW REVERSE NEUTRAL CHOKE IGNITION SWITCH REVERSE ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON FUEL BATTERY REVERSE FORWARD CRUISE CONTROL PEDAL 15 15 DANGER, KEEP HANDS ATTACHMENT ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFE
Краткое содержание страницы № 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ATTACHMENT ROS "ON" IGNITION CLUTCH LEVER POSITION SWITCH LIFT LEVER PLUNGER LIGHT SWITCH ATTACHMENT THROTTLE/CHOKE LIFT LEVER CONTROL HEIGHT CLUTCH/BRAKE ADJUSTMENT PEDAL INDICATOR PARKING BRAKE GEAR SHIFT LEVER 02829 FIG. 4
Краткое содержание страницы № 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “brown ing”
Краткое содержание страницы № 12
01423 OPERATION TO ADJUST GAUGE WHEELS (See Fig. 6) ROS "ON" POSITION ENGINE "ON" POSITION (NORMAL OPERATING) Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. NOTE:Adjust gauge wheels with tractor on a fl at level surface. � Adjust mower to desired cutting height (See “TO AD- JUST MO WER CUT TIN
Краткое содержание страницы № 13
OPERATION TO OPERATE ON HILLS ADD GASOLINE � Fill fuel tank to bottom of fi ller neck. Do not overfi ll. WARNING: Do not drive up or down Use fresh, clean, regular un lead ed gasoline with a hills with slopes great er than 15° and minimum of 87 octane. (Use of leaded gasoline will do not drive across any slope. increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel � Choose the slowest speed before starting up or down in q
Краткое содержание страницы № 14
OPERATION COLD WEATHER STARTING ( 50° F and below) � When engine starts, allow engine to run with the throttle control in the choke ( ) position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tem- per a ture. � The attachments can also be used during the engine warm-up period. NOTE: If at a high altitude (above 3000 feet) or in cold tem pera tures (below
Краткое содержание страницы № 15
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
Краткое содержание страницы № 16
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per forming an y main- bent or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade If tractor requires more than fi ve (5) feet to stop at highest approved by the manufacturer of your tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is surface, then brake must
Краткое содержание страницы № 17
MAINTENANCE � Slide blade on to an unthreaded portion of the steel bolt SAE VISCOSITY GRADES or pin and hold the bolt or pin parallel with the ground. SAE 30 If blade is balanced, it should remain in a horizontal 5W-30 position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced. F -20 0 30 32 40 60 80 100 C -30 -20 -10 0 10 20 30 40 CENTER HOLE TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE oil_visc_chart1_e FIG. 11 BLADE NOTE: Although m
Краткое содержание страницы № 18
MAINTENANCE CLEAN AIR SCREEN IN-LINE FUEL FILTER (See Fig. 13) Air screen must be kept free of dirt and chaff to prevent The fuel fi lter should be replaced once each season. If fuel engine dam age from overheating. Clean with a wire brush fi lter becomes clogged, ob struct ing fuel fl ow to car bure tor, or com pressed air to re move dirt and stubborn dried gum re place ment is re quired. fi bers. � With engine cool, remove fi lter and plug fuel line sec- tions. AIR FILTER � Place new
Краткое содержание страницы № 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: � Depress clutch/brake pedal fully and set parking brake. � Place gearshift lever in neutral (N) position. � Place attachment clutch in “DISENGAGED” position. � Turn ignition key to “STOP” and remove key. � Make sure the blades and all moving parts have completely stopped. � Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
Краткое содержание страницы № 20
SERVICE AND ADJUSTMENTS � When distance “D” is 1/8" to 1/2" lower at front than TO LEVEL MOWER HOUSING rear, tighten nuts “F” against trunnion on both front Adjust the mower while tractor is parked on level ground links. or driveway. Make sure tires are properly infl ated (See � To raise front of mower, loosen nut “F” from trunnion on “PROD UCT SPECIFICATIONS” section of this manual). If both front links. Tighten nut “E” on both front links an tires are over or underinfl ated, you
