Краткое содержание страницы № 1
Operator's Manual
7000 SERIES
ZTR® MOWERS
2001
Page 1
Краткое содержание страницы № 2
IMPORTANT - READ CAREFULLY ® ® The Dixon ZTR Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator's manual carefully and become completely familiar with the controls. ® ® The information in this operator's manual applies to all Dixon ZTR 7000 Series Commercial Mowers. Your Dixon dealer will gladly answer any questions. See your dealer for warranty se
Краткое содержание страницы № 3
INDEX SAFETY ..................................................................Pages 4-9 WARRANTY POLICY ............................................ Page 10 SPECIFICATIONS .................................................Page 11 SEAT ADJUSTMENT ............................................ Page 12 CONTROLS ...........................................................Pages 13-16 OPERATION INSTRUCTIONS ........................... Pages 17-22 CARE AND MAINTENANCE ............................... Pages
Краткое содержание страницы № 4
SAFETY RIDING LAWNMOWERS, IF IMPROPERLY OPERATED, CAN CAUSE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... BLADE CONTACT TIP-OVER RUN-OVER BACK-OVER ...read and understand this manual to prevent injuries. Page 4
Краткое содержание страницы № 5
SAFETY Safety Alert Symbol When you see this symbol, BE ALERT to the potential for injury. Follow recommended safety precautions and safe operating practices. Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Caution indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate inju
Краткое содержание страницы № 6
SAFETY This cutting mower is capable of amputating hands & feet, and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: Read, understand, and follow all instructions in the manual and on the mower before starting. Only allow responsible adults, who are familiar with the instructions, to operate the mower. Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blade
Краткое содержание страницы № 7
SAFETY SLOPE OPERATION: Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it! DO Mow across the slope with your Dixon ZTR - never up or down. Remove obstacles such as rocks, tree limbs, etc. Watch for holes, ruts or bumps. Uneven terrain could overturn the mower. Tall grass can hide obstacles. Use slow speed. Tires ma
Краткое содержание страницы № 8
SAFETY CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. Keep children out of the mowing area and under the watchful care of another responsible adult. Be alert and turn mower off if a child enters the area. Before and during backing, look behind and DOWN for small children. Never carry children
Краткое содержание страницы № 9
SAFETY SERVICE: Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. Use only an approved container. Never remove gas cap or add fuel with the engine running. Allow engine to cool before refueling. Do not smoke. Never refuel the mower indoors. Never store the mower or fuel container inside a building where there is an open flame, If fuel is spilled on clothing, change clothing immediately. To prevent fire and explosion caused by static electrici
Краткое содержание страницы № 10
DIXON INDUSTRIES, INC. a BLOUNT company AIRPORT INDUSTRIAL PARK PO BOX 1569 COFFEYVILLE KS 67337 0945 316 251 2000 FAX 316 251 4117 DIXON LIMITED WARRANTY POLICY - COMMERCIAL MODELS Models 6000 & 7000 WARRANTY: Home Owner Application: This Dixon Warranty term is for a period of two (2) years from date of purchase. Commercial Application: Dixon mowers used for commercial application are warranted for 1 year from the date of purchase. Commercial use is specified as use other than, or in ad
Краткое содержание страницы № 11
SPECIFICATIONS 7000 Series CHASSIS: 11 GA - rectangular tube BODY: Folded sheet metal. SEAT: Designed for operator comfort with padded back and arm rests. Seat is adjustable fore and aft. MOWER DECK: 2 Decks are available. Both decks are made of 10 GA fabricated welded construction with 7 GA reinforcement plate. 3 blades combine for either a 52" or 60" cut width. Cut height approximately 1.5" to 5" via 7 position lift handle. BLADE DRIVE: Electric clutch DRIVE SYSTEM: Each rear wheel is inde
Краткое содержание страницы № 12
SEAT ADJUSTMENT INSTRUCTIONS Model 7025 1. Grasp seat slide adjuster and move it into adjustment position. 2. Slide seat forward or backward. 3. Release seat slide adjuster. Seat Slide Adjuster Page 12
Краткое содержание страницы № 13
CONTROLS Steering Control Levers Blade Clutch Switch Choke Parking Brake Lever Ignition Key Throttle Cut Height Adjustment Lever Cut Height Stop Pin Page 13
Краткое содержание страницы № 14
CONTROLS PARKING BRAKE: The parking brake is designed to hold the mower from moving and is not intended for use in stopping the mower while it is in motion. . CAUTION Engage parking brake before starting engine TO SET PARKING BRAKE: The hand operated parking brake is located at left hand side of mower. To engage brake, pull upward. To release brake, move lever downward. NOTE: Always set parking brake before dismounting. Release parking brake before moving mower. HYDRO-GEAR DRIVE SYSTEM: Allows
Краткое содержание страницы № 15
CONTROLS TO GO FORWARD: From neutral position, gently push both drive levers forward. To increase speed, move levers farther forward. TO GO BACKWARD: From neutral position, gently pull both drive levers toward you. TURNING: Turning is controlled by moving one drive lever slightly forward or rearward of the other. To turn left, move left lever rearward of the right lever. To turn "square corners" move lever of desired direction to neutral. To turn on mower's own axis (zero turning radius) stop an
Краткое содержание страницы № 16
CONTROLS BLADE DRIVE: Located on control panel, on operator's right. To engage blades: Pull up on the switch. To disengage blades: Push down. MOWER DECK CUT HEIGHT LIFT LEVER: Located to the right and front of operator. Controls the cutting height. Seven positions of adjustment. Lift lever and place stop pin in hole corresponding to the desired height. Let lever rest on the pin stop. NOTE: Always use high position for transport. Page 16
Краткое содержание страницы № 17
OPERATION INSTRUCTIONS The safe and successful operation of the Model ZTR 7000 Series will depend upon the operator having the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete knowledge of all controls and their functions. During initial operation, "learning to drive", set throttle at slow speed. Sound judgement by the owner will prevent accidents. BEFORE OPERATING MOWER: 1. Re
Краткое содержание страницы № 18
OPERATION INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS: Do not operate mower if safety switches are not operating properly. Your Zero Turning Radius Mower is equipped with switches interlocked for your safety. 1. The mower blades must be disengaged before the engine will start. 2. The steering control levers must be in neutral "OUT" position before the engine will start. 3. The engine will stop if the mower blade clutch is engaged when the operator leaves the driver's seat. 4. The engine wil
Краткое содержание страницы № 19
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: Cold Engine 1. Pull choke control lever up. 2. Push throttle control lever to 1/2 setting. 3. Insert ignition key and turn to "Start" position. When engine starts, release ignition key. Key will return to "Run" position. 4. Once engine starts to warm up, slowly push choke control lever down to the fully closed position. 5. Move throttle control lever to the wide open or maximum setting for actual operation of the mower deck. 6. Engine must be opera
Краткое содержание страницы № 20
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: Engine has been operated. 1. Move throttle control lever to 1/4 to 1/2 setting. 2. Insert ignition key and turn to "Start" position. When engine starts, release ignition key. Key will return to "Run" position. 3. Move throttle control lever to wide open or maximum setting for actual operation of the mower deck. NOTE: Model ZTR 7000 Series may require partial choke setting to start even if the engine has been operated for a period of time. 4. Engine
