Краткое содержание страницы № 1
OWNER’S MANUAL
20/15/10/2 AMP
FULLY AUTOMATIC
BATTERY CHARGER
Model No.
200.713201
CAUTION:
Before first use of charger, read this manual, and
follow all its Safety and Operating Instructions with
every charger use.
Save these instructions.
Made in U.S.A. of U.S. and imported parts.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
600-198
1
THIS ART FOR PLACEMENT PURPOSES
ONLY
MAINTENANCE
PARTS TROUBLESHOOTING OPERATION SAFETY
Краткое содержание страницы № 2
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS TABLE OF CONTENTS WARRANTY ............................................................................................................... 2 SAFETY ..................................................................................................................... 3 Important Safety Instructions .................................................................................... 3 OPERATION ...................................................
Краткое содержание страницы № 3
IMPORTANT SAFETY INSTRUCTIONS HELP US HELP YOU WARNING: To reduce the risk of explosion, explosive gases, or injury Remember: while using your battery charger, follow Place charger as far away from the precautions listed below: battery being charged as the charger • Read all instructions and cautions cables will permit. printed on the battery charger, Do not expose charger to rain or battery, and vehicle or equipment snow. using battery. Never charge a frozen battery. If Use charger only
Краткое содержание страницы № 4
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS PERSONAL SAFETY PRECAUTIONS For your own personal safety, please follow the following precautions: Remove all personal metal items Wear complete eye and clothing from your body, such as rings, protection when working with lead- bracelets, necklaces, and watches acid batteries. while working with a lead-acid battery. Be sure that someone is within range A battery can produce a short circuit of your voice to come to your aid if current high
Краткое содержание страницы № 5
BEFORE USING YOUR BATTERY CHARGER It is important to understand your charger's requirements. This section will tell you about your charger's electrical requirements and how to prepare a battery for charging. ASSEMBLING YOUR CHARGER Included with your battery charger are two cord wrap posts for storage of the clamp cables. To install, align the three tabs to correspond with the three receptacles and push until you hear a snap. Wrap clamp cord after unplugging the power cord and store your charger
Краткое содержание страницы № 6
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS PREPARING YOUR BATTERY TO BE CHARGED It is important that you read and follow these guidelines while you are preparing to charge your battery. Make sure that you have a 12 volt or such as removing or not removing cell caps while charging, and 24 volt lead-acid battery. Set the recommended rates of charge. selector switch to match the voltage rating of the battery to be charged. Wear safety glasses. See additional Clean the battery terminal
Краткое содержание страницы № 7
Battery Type: seasonal farm equipment and the like. Use after fully charging the The charger is designed to provide a battery in one of the charging specific charge best suited for charging positions. each type of battery. Charging a GEL MANUAL CELL battery as a REGULAR or DEEP CYCLE battery can permanently damage it. Charging a battery on AUTOMATIC MAINTAINER anything but the proper selection can result in a partial charge or damaged battery. DO NOT charge a Gel Cell on Charge Rate: any other
Краткое содержание страницы № 8
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS freshly charged battery’s voltage will CHARGING YOUR BATTERY drop shortly after charging stops, and the charger, if left connected, may Charging your battery inside the resume charging. This off-and-on vehicle: cycling will continue until the battery’s 1. Arrange the power cord and charging voltage no longer drops enough to leads carefully in order to avoid restart the charger. damage that could be caused by the hood, door, or moving engine part
Краткое содержание страницы № 9
POSITIVE (POS, P, +) and NEGATIVE (NEG, N, -). NOTE: On top-post batteries, the positive battery terminal usually has a larger diameter than the negative one. 3. Connect the red (POSITIVE) charger clamp to the POSITIVE post of the battery. Be sure to rock the clip back and forth to make a solid connection. 4. Attach a 6-gauge (AWG) or a 4-gauge (SAE) insulated battery cable of at NEGATIVE GROUNDED SYSTEM least 24-inches long to the NEGATIVE Figure A battery post. This cable will provide a safe
Краткое содержание страницы № 10
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS 10. Standing away from the battery, POSITIVE NEGATIVE remove the negative lead from the insulated cable connected to the BATTERY CHARGER NEGATIVE post first. Then remove BATTERY +- the lead from the POSITIVE post. 11. Clean and store the battery charger POWER in a dry location. 24", 6 GAUGE CORD CABLE TO GROUNDED POWER OUTLET Figure B 10
Краткое содержание страницы № 11
CALCULATING CHARGE TIME Battery Rating Method Use the following table to more accurately determine the time it will take to fully charge a battery that is initially at 50% State-of-Charge. Identify your battery type and its associated Charge Time in the table. Common battery types are: Small batteries, motorcycles, garden tractors, etc., are usually rated in Amp-Hours (AH). Car and truck batteries, usually rated in Reserve Capacity (RC), Cold Cranking Amps (CCA), or both. Marine, or deep c
Краткое содержание страницы № 12
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS Charge Time Needed if Amp-Hours is Known Find the Charge Factor for your battery in the table on page 11. Multiply by the Amp-Hour rating of the battery. Divide by the Charger Setting (either 2 Amp, 10 Amp or 20 Amp). Multiply by 1.25 to get the approximate Hours Needed to bring the battery to full charge. Example: 15 Amp-Hour (AH) Battery, 50% State-of-Charge, 2 Amp Charger Setting [(AH x Charge Factor) ÷ Charger Setting] x 1.25 = Hour
Краткое содержание страницы № 13
TROUBLESHOOTING Performance problems often result from little things that you can fix yourself. Please read through this chart for a possible solution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION/REASON Clamps not making good Check for poor connection at battery. Make No ammeter reading. connection. sure clamps and posts are clean. Battery may not accept an AUTOMATIC charge if severely discharged. Use MANUAL setting, see "Using Your Battery Charger" on page 6. 2-amp charge rate. Amme
Краткое содержание страницы № 14
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS PARTS This section shows an illustration of your battery charger. Use it to become familiar with where all the parts are located, and what they look like. Replacement Parts List Model 713201 Part Number Description Item Description Item Part Number 93026487 Handle 1 Transformer 7 3599000270 SCR control Module 2299000992 Switch - left DPDT 0499000060 2 8 2299000991 Meter 3 PC Board Asm (SWITCHES) 9 5399100095 Circuit Breaker 3999000089 Faceplate
Краткое содержание страницы № 15
WIRING DIAGRAM 15 MAINTENANCE PARTS TROUBLESHOOTING OPERATION SAFETY
Краткое содержание страницы № 16
SAFETY OPERATION MAINTENANCE TROUBLESHOOTING PARTS For information about troubleshooting Call toll-free from anywhere in the U.S.A. 7 am to 4:30 pm CST Monday through Friday 1-800-732-7764 For the repair or replacement parts you need Call 7 am - 7 pm, 7 days a week 1-800-366-PART (1-800-366-7278) For the location of an authorized Sears Service Center in your area Call 24 hours a day, 7 days a week 1-800-488-1222 When requesting service or ordering parts, always provide the following information:
