Краткое содержание страницы № 1
®
QuickScan QS6500
Handheld Bar Code Scanner
Quick Reference Guide
Краткое содержание страницы № 2
Datalogic Scanning, Inc. 959 Terry Street Eugene, Oregon 97402 Telephone: (541) 683-5700 Fax: (541) 345-7140 An Unpublished Work - All rights reserved. No part of the contents of this documentation or the procedures described therein may be repro- duced or transmitted in any form or by any means without prior written permission of Datalogic Scanning, Inc. or its subsidiaries or affiliates ("Datalogic" or “Datalogic Scanning”). Owners of Datalogic products are hereby granted a non-exclusi
Краткое содержание страницы № 3
Datalogic Scanning, Inc. ® QUICKSCAN END USER LICENSE AGREEMENT Notice to End User: The Datalogic Product you have acquired contains embedded Soft- ware, which is integral to the product’s operation. This Software is being provided to you under license, subject to the terms and conditions of this Agreement. If you use the Dat- alogic Product, you will be deemed to have accepted the terms and conditions of this Agreement. If you do not intend to be bound to the terms of this Agreement, Datalog
Краткое содержание страницы № 4
3. Transfers, Support. 3.1 Any copying, installing, reproduction, remanufacture, reverse engineering, electronic transfer, or other use of the Software on other than the designated Datalogic Product will be a material breach of this Agreement. However, Datalogic may elect not to terminate this Agreement or the granted licenses, but instead may elect to notify End User that End User is deemed to have ordered and accepted a license for each breaching use. End User shall pay Datalogic the appl
Краткое содержание страницы № 5
7. Infringement. 7.1 Datalogic will defend End User against any claim in a lawsuit that the Datalogic Product furnished hereunder infringe a United States patent or copyright of a third party and Dat- alogic will pay any damages finally awarded against End User by a court of competent jurisdiction that are attributable to such claim or will pay End User’s part of any settle- ment that is attributable to such claim, provided, that 1) End User notifies Datalogic promptly in writing of the claim
Краткое содержание страницы № 6
embedded software, End User agrees to sign a waiver prepared by Datalogic concerning further use of the embedded Software. End User’s resumed or continued use of the embedded Software after termination shall constitute End User’s agreement to be bound by the terms and conditions of this Agreement for such use. 11. General Provisions. 11.1 Entire Agreement; Amendment. This document contains the entire agreement between the parties relating to the licensing of the Software and supersedes all
Краткое содержание страницы № 7
Installation ® The QuickScan QS6500 linear imager is easy to install and use. The following figure shows the steps to perform an installation. Turn off the host computer before connection. Consult the host terminal’s manual if necessary. 1 2 $4.50 $2.79 5 $3.99 3 4 1. Connect the interface (I/F) cable to the linear imager. 2. Connect the I/F cable to the terminal’s communication port. 3. Connect the power cord to the I/F cable connector if required. Linear imagers that use power off the ter
Краткое содержание страницы № 8
How to Scan The figure below shows the right and wrong ways to scan a bar code. 1 1 2 2 1. The linear imager must be pointed at a slight angle to the bar code so that the light reflected off the bar code can be “seen” by the linear imager. Do not hold the linear imager perpen- dicular to the bar code. 2. The targeting beam must cross the entire label. The linear imager cannot read the bar code data without seeing the entire label. Scanning PDF417 Bar Codes (PDF models ONLY) To read a PDF417
Краткое содержание страницы № 9
ON OFF Troubleshooting If the linear imager is not operating properly, the following checks should be performed: 1. Since the linear imager can receive its power from the host computer (Power Off the Terminal—P.O.T.), it will not operate without the system power on. If the linear imager uses an external power supply and the external power supply has failed, the linear imager will not operate. 2. If an external power supply is used, exchange the power sup- ply with a known good power supply
Краткое содержание страницы № 10
7. Ensure that the linear imager's interface type is compatible with the host terminal by consulting your POS system man- ual and/or the linear imager’s Product Reference Guide found on the CD included with your linear imager. 6 5 7 If the linear imager still does not function properly, contact your local supplier or Datalogic Customer Support Services. Compliance Statement This device complies with Part 15 rules. Operation is subject to the following conditions: 1. This device may not caus
Краткое содержание страницы № 11
Installation Le lecteur de code à barres Linear Imager QS6500 est un linear imager de poche facile à utiliser. Le schéma suivant illustre la procédure d’installa- tion du imager. Eteignez l’ordinateur avant de connecter le imager. Con- sultez le manuel de l’ordinateur si nécessaire. 1 2 $4.50 $2.79 5 $3.99 3 4 1. Connectez le câble d’interface (I/F) au imager. 2. Connectez le câble I/F au port de communication de l’ordinateur. 3. Connectez le cordon d’alimentation au câble I/F si requis. Les
Краткое содержание страницы № 12
Procédure de lecture Le dessin ci-dessous montre la bonne et la mauvaise façon de scanner un code à barres. 1 1 2 2 1. Le linear imager doit être légèrement incliné par rapport au code à barres afin que la lumière réfléchie sur le code peut être vue par le linear imager. Ne pointez pas le linear imager perpendiculairement au code. 2. Le faisceau lumineux doit balayer l'étiquette entièrement. Le linear imager ne peut pas déchiffrer le code à barres sans avoir entièrement parcouru l’étiquett
Краткое содержание страницы № 13
ON OFF Dépannage Si le linear imager ne fonctionne pas correctement, effectuez les vérifica- tions suivantes : 1. Si le lecteur est alimenté par l’ordinateur, ce dernier doit être sous tension. Si le linear imager utilise une source d’alimentation externe, et que cette source d’alimentation est défaillante, le linear imager ne peut pas fonctionner. 2. Si le linear imager utilise une source d’alimentation externe, rem- placez celle-ci par une autre source dont vous êtes certain du bon fonctio
Краткое содержание страницы № 14
7. Assurez-vous que le type d’interface du linear imager est compatible avec l’ordinateur, en consultant le manuel de ce dernier et/ou le Guide de référence du linear imager inclus dans le CD fourni avec le lecteur. 6 5 7 Si le linear imager ne fonctionne toujours pas correctement, contactez votre revendeur ou le Service après-vente Datalogic. Interference de la Radio Frequence Cet appareil est conforme au paragraphe 15 du règlement FCC. Les opération sont soumises aux deux conditions suiva
Краткое содержание страницы № 15
Installation Der QS6500 Linear Imager ist ein Handheld Scanner mit benutzerfre- undlichem Design. Anhand folgender Abbildung wird in Schritten gezeigt, wie der Scanner installiert werden soll. Schalten Sie den Hos- trechner aus, bevor Sie den linear imager anschließen. Falls notwendig, schlagen Sie im Host-Terminal Handbuch nach. 1 2 $4.50 $2.79 5 $3.99 3 4 1. Verbinden Sie die Schnittstelle (I/F) mit dem linear imager. 2. Verbinden Sie das I/F Kabel mit dem Datenübertragungsport im Terminal
Краткое содержание страницы № 16
Für eine gültige Sicherheitszertifizierung müssen Klasse III Stromquellen am Eingang nach den Bestimmungen IEC/ EN60950-1 (EN 60335-Serien, EN 60065 oder entsprechenden) zugelassen sein. Eingang: 100 - 240 VAC Ausgang: 9 - 10 VDC Max. Strom: 2.0 A Max. Leistung: 20 W Der Vorgang des Scannens selbst Die untenstehende Zeichnung zeigt, wie man Barcodes richtig und falsch scannt. 1 1 2 2 1. Der linear imager muß dem Barcode in einem leichten Winkel zuwandt sein, damit das reflektierte L
Краткое содержание страницы № 17
ON OFF Problembehandlung Die folgenden Tests sollten durchgeführt werden, wenn der linear imager nicht einwandfrei funktioniert. 1. Nachdem der linear imager durch den Hostrechner mit Strom ver- sorgt wird (P.O.T), kann das Gerät nicht ohne eine eingeschaltete Spannungsversorgung durch das System funktionieren. Der linear imager kann nicht in Betrieb gesetzt werden, wenn das Gerät auf Fremdstrom läuft und dieser ausgefallen ist. 2. Wenn das Gerät mit Fremdstrom läuft, wechseln Sie die Strom
Краткое содержание страницы № 18
7. Stellen Sie sicher, dass der Schnittstellentyp des linear imagers mit Ihrem Host-Terminal kompatibel ist, indem Sie in Ihrem POS-Sys- temhandbuch und/oder in der linear imager Product Reference Guide nachschlagen, die sich auf der CD befinden, die mit dem lin- ear imager geliefert wurde. 6 5 7 Bitte kontaktieren Sie entweder Ihren örtlichen Anbieter oder den Data- logic Kunden-Support-Dienst, wenn der linear imager noch immer nicht einwandfrei funktioniert. Hochfrequente Störungen Dieses
Краткое содержание страницы № 19
Installazione Il QS6500 linear imager è un lettore portatile di facile utilizzo. La seguente figura illustra le fasi di installazione del linear imager. Spegnere il computer prima di collegare il linear imager. Se neces- sario, consultare il manuale fornito unitamente al computer. 1 2 $4.50 $2.79 5 $3.99 3 4 1. Collegare il cavo di interfaccia (I/F) al linear imager. 2. Collegare il cavo di interfaccia (I/F) alla porta di comunicazi- one del terminale. 3. Se necessario, collegare il cavo di a
Краткое содержание страницы № 20
Affinché il certificato di sicurezza sia valido, le sorgenti di alimen- tazione di classe III devono essere conformi a IEC/EN60950-1 (serie EN 60335, EN60065 o relativi). Tensione ingresso: 100 - 240 VAC Tensione uscita: 9 - 10 VDC Consumo massimo: 2.0 A Potenza massima: 20 W Come eseguire una lettura La figura sottostante illustra il modo corretto e quello non cor- retto di come effettuare la scansione di un codice a barre 1 1 2 2 1. Il linear imager deve essere puntato con un leggero an
