Краткое содержание страницы № 1
HOME CINEMA CONTROL CENTER
DVD VIDEO PLAYER
RX-ES1SL
XV-N55SL
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT1002-001B
[B]
cover.RX-ES1&XV-N55[B]f 1 03.2.18, 1:42 PM
Краткое содержание страницы № 2
Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to
Краткое содержание страницы № 3
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE 2 WARNING LABEL, PLACED INSIDE THE UNIT 1. CLASS 1 LASER PRODUCT 2. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 3. CAUTION: Do not open the top cover. There are no user service- able parts inside the unit; leave all servicing to qualified service personnel. CAUTION • Do not block the ventilation openings or holes. (If
Краткое содержание страницы № 4
Caution: Proper Ventilation for RX-ES1SL To avoid risk of electric shock and fire and to protect from damage. Locate the apparatus as follows: Front: No obstructions open spacing. Sides: No obstructions in 10 cm from the sides. Top: No obstructions in 10 cm from the top. Back: No obstructions in 15 cm from the back Bottom: No obstructions, place on the level surface. In addition, maintain the best possible air circulation as illustrated. Spacing 15 cm or more RX-ES1SL Wall or obstructions Stand
Краткое содержание страницы № 5
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are pro
Краткое содержание страницы № 6
Table of Contents Parts identification ................................................ 2 XV-N55SL Before operation ................................................. 35 Getting star ted ...................................................... 5 About this manual ..................................................................... 35 Precautions ................................................................................. 5 About discs ..........................................................
Краткое содержание страницы № 7
RM-SQPES1R REMOTE CONTROL 1 2 3 4 5 6 7 8 9 +10 DVD-AUD Parts identification See pages in parentheses for details. Remote control 1 TV DIRECT button (13) 2 Standby/on buttons (11, 36, 62 – 64) When operating the receiver (RX-ES1SL), set the mode AUDIO, DVD , VCR , STB , TV selector (h) to “AUDIO/TV/VCR/STB.” 3 Source selecting buttons (11) When operating the player (XV-N55SL), set the mode DVD, VCR, STB, TV, DVD MULTI, FM/AM selector (h) to “DVD.” 4 CHANNEL +/– buttons (62 – 64) 5 TV VOL (volu
Краткое содержание страницы № 8
Parts identification RX-ES1SL See pages in parentheses for details. Front panel 1 2 3 4 5 6 7 8 9 p q w SOURCE SELECTOR MASTER VOLUME / MULTI JOG SET / TUNER PRESET TV DIRECT SETTING ADJUST SURROUND PHONES DVD MULTI DVD STB VCR TV FM / AM STANDBY / ON STANDBY 1 STANDBY/ON button and STANDBY lamp (11) 8 • SET button (16, 17, 19, 21, 31, 33, 34) 2 TV DIRECT button (13) • TUNER PRESET button (24) 3 SETTING button (16, 17, 19) 9 Remote sensor (5) 4 ADJUST button (21, 31, 33, 34) p SOURCE SELE
Краткое содержание страницы № 9
Parts identification XV-N55SL See pages in parentheses for details. Front panel 1 2 3 4 5 6 7 8 9 0 - STANDBY / ON 1 button (36) 7 4 button (39, 40) 2 STANDBY/ON indicator (36) 8 ¢ button (39, 40) 3 Display window 9 7 button (37, 38) 4 Remote sensor (5) 0 3 button (37, 39) 5 Disc tray (37) - 8 button (38, 39) 6 0 button (37) Display window 1 3 4 6 2 5 8 0 7 9 1 Audio format indicators 6 Total time/remaining time indicators 2 Disc indicator 7 3D indicator 3 Group/title/track/chapter indicators 8
Краткое содержание страницы № 10
Getting started Precautions Putting batteries in the remote control Before using the remote control, put two supplied batteries first. General precautions • DO NOT disassemble the unit or remove screws, covers, or 1 Press and slide the cabinet. buttery cover on the bac k • DO NOT expose the unit to rain or moisture. of the remote control. • DO NOT expose the unit to direct sunlight or place it near a heating device. Locations • Install the receiver in a location that is level and protected from
Краткое содержание страницы № 11
Getting started Connecting the FM and AM (MW) antennas If FM reception is poor, connect If AM (MW) reception is poor, connect an outdoor single outdoor FM antenna (not supplied). vinyl-covered wire (not supplied). 13 2 AM (MW) loop antenna (supplied) Snap the tabs on the loop into the slots of the base to assemble the AM (MW) loop antenna. FM 75 AM LOOP FM antenna (supplied) ANTENNA COAXIAL AM EXT FM 75 AM LOOP CENTER SURROUND FRONT VCR AV IN / OUT TV DIGITAL 1 SPEAKER SPEAKERS SPEAKERS A
Краткое содержание страницы № 12
Getting Started Connecting the speakers and DVD player Turn off all components before connections. Speaker Layout Diagram After connecting the front, center and surround speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best possible surround effect. For details, see pages 15 to 18. Subwoofer Center speaker Right front Left front XV-N55SL speaker speaker RX-ES1SL RX-ES1 HOME CINEMA CONTROL CENTER SOURCE SELECTOR MASTER VOLUME TV DIRECT SETTING ADJUS
Краткое содержание страницы № 13
Getting started FM 75 AM LOOP VCR AV IN / OUT TV CENTER SURROUND FRONT Connecting the DVD player (XV-N55SL) DIGITAL 1 ANTENNA (DVD) SPEAKER SPEAKERS SPEAKERS RIGHT LEFT RIGHT LEFT COAXIAL AM EXT AUDIO CENTER DIGITAL 3 DIGITAL 2 DIGITAL IN (TV) (STB) L L DVD AV IN STB Connect the DVD player by using a SCART cable CAUTION: SPEAKER SUBWOOFER IMPEDANCE R R 8 ~ 16 OUT DVD SUB and/or a digital cord. FRONT SURR IN WOOFER (REAR) • To enjoy the digital sound, digital connection is RX-ES1SL requ
Краткое содержание страницы № 14
Getting started SCART connection SCART cable (supplied: 1 cable) VCR AM LOOP VCR AV IN / OUT TV DIGITAL 1 CENTER SURROUND FRONT ANTENNA SPEAKER SPEAKERS SPEAKERS (DVD) RIGHT LEFT RIGHT LEFT AM EXT AUDIO CENTER DIGITAL 3 DIGITAL 2 (TV) (STB) DIGITAL IN L L DVD AV IN STB CAUTION: SPEAKER SUBWOOFER IMPEDANCE R R OUT 8 ~ 16 VD SUB FRONT SURR N WOOFER (REAR) RX-ES1SL TV VCR AV IN/OUT TV DVD AV IN STB STB * See below. For TV and video format • When the TV is equipped with the multiple SCART
Краткое содержание страницы № 15
Getting started Analogue connection for DVD MULTI playback (see page 34) • DVD MULTI playback is not available for XV-N55SL. RX-ES1SL FM 75 AM LOOP CENTER SURROUND FRONT DVD Player (ex. XV-NA7SL) VCR AV IN / OUT TV DIGITAL 1 SPEAKER SPEAKERS SPEAKERS ANTENNA (DVD) RIGHT LEFT RIGHT LEFT COAXIAL AM EXT AUDIO CENTER DIGITAL 3 DIGITAL 2 (TV) (STB) DIGITAL IN L L DVD AV IN STB Monaural CAUTION: SPEAKER SUBWOOFER IMPEDANCE R R OUT 8 ~ 16 DVD SUB SURR audio cord IN FRONT WOOFER (REAR) (not supp
Краткое содержание страницы № 16
RX-ES1SL Basic operations 2 Select the source to play SOURCE SELECTOR MASTER VOLUME / MULTI JOG TV DIRECT SETTING ADJUST SURROUND SET / TUNER PRESET PHONES On the front panel: STANDBY / ON STANDBY DVD MULTI DVD STB VCB TV FM / AM Turn SOURCE SELECTOR until the source name you want appears on the display. The source indicator corresponding to the selected source lights in red. • As you turn SOURCE SELECTOR, the source changes as follow: HOME CINEMA CONTROL CENTER AUDIO TV DIRECT ANALOG LC R
Краткое содержание страницы № 17
Basic operations HEADPHONE mode When using the headphones, the following signal is output SOURCE SELECTOR MASTER VOLUME / MULTI JOG TV DIRECT SETTING ADJUST SURROUND SET / TUNER PRESET PHONES regardless of your speaker setting: STANDBY / ON STANDBY DVD MULTI DVD STB VCB TV FM / AM — For 2 channel sources, the front left and right channel signal is output directly from the left and right headphones. — For multi-channel sources, the front left and right, center and surround channel signal is
Краткое содержание страницы № 18
Basic operations To cancel TV Direct and turn off the receiver, press STANDBY/ON on the front panel. The following are the analogue/digital signal format indicators on The receiver is turned off and the STANDBY lamp lights up. the display to indicate what type of signal comes into the receiver. ANALOG: Lights when analogue input is selected. To cancel TV Direct and turn on the receiver, press TV DIRECT. The receiver is turned on and the source indicator currently selected LPCM: Lights when Line
Краткое содержание страницы № 19
Basic operations Turning off the power with the Sleep Basic adjustment of auto memory This receiver memorizes sound settings for each source: Timer • when you turn off the power, You can fall asleep while listening to music—Sleep Timer. • when you change the source, and • when you change the analogue/digital input mode (see page 11). From the remote control ONLY: AUDIO SUBTITLE TITLE/GROUP RETURN When you change the source, the memorized settings for the ZOOM BASS TREBLE Press SLEEP repeat
Краткое содержание страницы № 20
RX-ES1SL Speaker settings To obtain the best possible surround effect from Surround/DSP modes (see pages 28 to 33), you need to set up the speaker and subwoofer information after all the connections are completed. You can set the speaker information using one of the following three methods. Smart Surround Setup: Set the speakers information automatically by one simple action—clapping hands. The delay time and output level for the center and surround speakers are set automatically. Quick Setup: S
