Краткое содержание страницы № 1
2.4 GHz Wireless Remote
Unit with Hookswitch
HS300A
HS301A
Краткое содержание страницы № 2
FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, w
Краткое содержание страницы № 3
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined
Краткое содержание страницы № 4
CDC STATEMENT Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring properly. 6. In the event of an equipment malfunction, all repairs should be performed by your supplier or an authorized agent. It is the responsibility of users requi
Краткое содержание страницы № 5
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading. The termination on a loop may consist of any combination of devices, subject only to the requirement t
Краткое содержание страницы № 6
NOM STATEMENT 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación. Todo otro servicio deberá ser referido a personal de servicio calificado. 9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso. La colocación del aparato eléctrico sobre una cama, sofá, alfombra o superficie
Краткое содержание страницы № 7
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato; o C: El aparato ha sido expuesto a la lluvia; o D: El aparato parece no operar normalmente o muestra un cambio en su desempeño; o E: El ap
Краткое содержание страницы № 8
TRADEMARKS USED IN THIS MANUAL TRADEMARKS USED IN THIS MANUAL ® ® AT&T and Merlin are registered trademarks of American Telephone and Telegraph Company. ® Siemens is a registered trademark of Siemens Aktiengesellschaft. ® Toshiba is a registered trademark of Toshiba Corporation. ® UL is a registered trademark of Underwriters Laboratories Incorporated. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. 7
Краткое содержание страницы № 9
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH Contents 1. Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 2. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 2.1 Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Краткое содержание страницы № 10
CHAPTER 1: Specifications ® Compliance—UL 1459, CSA, Power—Base: 7.5 VDC, 1. Specifications FCC Parts 15 and 68, IC 500 mA maximum; Remote: Baseband Modulation— RSS-210 3.6-V rechargeable NiMH, ADPCM 550-mAH battery Coverage—125,000 square Battery Life—12 hours of feet Size—Base: 6"H x 4"W x continuous use, on-line; 0.8"D (15.2 x 10.2 x 2 cm); 80 hours of continuous use, Frequency—2400 to Remote: 4"H x 2.5"W x 1"D off-line 2483 MHz (base and (10.2 x 6.4 x 2.5 cm) remote) Battery Recharge Time— W
Краткое содержание страницы № 11
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH 2.2 Components 2. Introduction A. Base 2.1 Description 30Headset/Handset The 2.4 GHz Wireless Amplifier Selector and the Remote Unit use Spread Spectrum technology to give you I. Transmit Adjustment wireless access to your phone. With the wireless system, you’re II. Telephone Compatibility free to find a file, confer with a Adjustment colleauge, check with shipping, or 4 On-line Indicator roam the building—without putting your caller on hold. 5 Batter
Краткое содержание страницы № 12
CHAPTER 2: Introduction A. B. C. 1 2 3 III. 4 I. 5 6 7 8 A B C D II. E F G IV. VI. V. E. F. D. VII. G. D. Base Stand 11
Краткое содержание страницы № 13
2.4 GHZ 2.4 GHZ WIRELESS WIRELESS REMOTE REMOTE UNIT UNIT WITH WITH HOOKSWITCH HOOKSWITCH 3. Installation 3.1 Assembling the Base and Connecting to the Telephone 1. Disconnect the handset cord from the telephone and connect it to the port Figure 3-1. Connecting the Cords. marked with the 0 icon at 2. Mount the base by aligning the bottom of the base. the tabs extending from the Connect one end of the bottom of the base with the telephone interface cord to corresponding slots on the the telephone
Краткое содержание страницы № 14
CHAPTER 3: Installation now working. If the on-line indicator does not flash, recheck assembly (Figure 3-5). Figure 3-3. Aligning the Tab. 4. Connect the headset to the Figure 3-4. Connecting the Headset. bottom of the remote. Insert the remote into the base 3.2 Checking the System (see Figure 3-4). Either side may be used. The battery Put the system in headset mode by Figure 3-5. Checking the Assembly. charge indicator marked pressing once on the headset/ with the 5 icon on the handset select
Краткое содержание страницы № 15
2.4 GHZ 2.4 GHZ WIRELESS WIRELESS REMOTE REMOTE UNIT UNIT WITH WITH HOOKSWITCH HOOKSWITCH 3.4 Before Setting Up to the Telephone 3.5 Setting Telephone Compatibility and Transmit Adjustments 1. Make sure the headset/handset selector 3.5.1 STEP 1: SETTING TELEPHONE marked with the 30 icon COMPATIBILITY on top of the base is in the 1. Put your headset on, lift the headset position. The handset from the telephone, selector is in the headset and listen for a dial tone in position when the on-line you
Краткое содержание страницы № 16
CHAPTER 3: Installation as when you used the handset. Adjust the switch marked 1-8 on the rear of the base as follows: 1 1 2 Adjust position from 1 to 8 2 3 3 4 4 5 5 6 6 7 7 8 (1 is softest, 8 is loudest) by 8 A A first talking in the handset B B C C D D E E F F G G and then in the headset for each position. When the person hears no difference when you talk into the Figure 3-8. Adjusting the Transmit Sound handset or headset, you Figure 3-7. Adjusting the Telephone Level. have the correct setti
Краткое содержание страницы № 17
2.4 GHZ 2.4 GHZ WIRELESS WIRELESS REMOTE REMOTE UNIT UNIT WITH WITH HOOKSWITCH HOOKSWITCH Table 3-1. Telephone Compatibility Guide Manufacturer System Phone Set Setting AT&T (Lucent) Definity 7100, 7300, 7400 Series A ® Merlin BTN, BIS, & 7000 Series A ISDN 6500, 7500 Series A 1A2 2500 Series G Merlin Legend MLX Series A Consumer Products Traditional & Feature A Comdial Executech, Impact All Sets A Mitel SX Series All Supersets A NEC Electra D-Term Series 2, 3, E A Executone Encore All Sets G IT
Краткое содержание страницы № 18
CHAPTER 4: Operation 4.2 Using with a Handset 4. Operation 1. Make sure the headset/ 4.1 Using with a Headset handset selector on top of the base is in the handset 1. Make sure the position. headset/handset selector on top of the base is in the 2. Pick up the handset to headset position. Put on the Figure 4-1. On-Line Indicator Flashing. answer the phone or make a headset, pick up the call as usual. handset, and answer the 4. To move away from your phone or make a call. desk during the call, rem
Краткое содержание страницы № 19
2.4 GHZ 2.4 GHZ WIRELESS WIRELESS REMOTE REMOTE UNIT UNIT WITH WITH HOOKSWITCH HOOKSWITCH Figure 4-2. Removing the Pocket Clip. Figure 4-3. Sliding the Belt Clip into Place. 3. Slide the belt clip onto the 4.4 Adjusting the Volume back of the remote until it Figure 4-4. Adjusting the Volume. clicks into place To turn the sound level up or (Figure 4-3). down in your headset, press 4.5 Muting the Microphone successively on the volume control button marked with the 7 icon To talk without the other
Краткое содержание страницы № 20
CHAPTER 4: Operation the mute function is on, you can lights up while the battery is in the still hear the other party. base. It takes 3 hours to fully recharge the battery. A fully charged battery provides 12 hours of continuous talktime. If the battery power gets too low, you’ll hear a beep in your headset every 20 seconds. When charging the battery overnight, put the system in handset mode (Figure 4-6). An optional second battery can charge in the base while the remote is in use, thus allowin
