Руководство по эксплуатации Snapper GC9520KWV

Краткое содержание страницы № 1

DEALER SETUP AND CHECKLIST FOR
SNAPPER GROUNDS CRUISER UTILITY VEHICLE

INTRODUCTION: These instructions cover the setup of the Snapper Grounds Cruiser utility vehicle. Complete
each step carefully. A checklist has been provided. It is very important to verify and record each item on the
list prior to retail. The dry weight of the machine you are about to setup is 1,230 lb. It is strongly recommended
that you use an overhead hoist when lifting the machine. The capacity of the device use

Краткое содержание страницы № 2

4. Insert bolt into hole in seat support. Place large STEP 3 2 1/2” diameter flat washer over bolt against inside INSTALL FRONT TIRES surface of seat support. The front bumper can be used to lift the front of the 5. Place (1) 1/2” x 1 1/4” flat washer on bolt. Install (1) machine. Block the machine to prevent it from falling. 7/16-20 top lock nut. NOTE: The front tires are directional. Install with valve stems out and with the points of the chevron treads pointing forward.

Краткое содержание страницы № 3

STEP 6 STEP 7 INSTALL OPERATOR PROTECTIVE ENGINE OIL AND TRANSMISSION FLUID The engine oil and transmission fluid must be checked STRUCTURE (OPS) before operation. The installation of the Operator Protective Structure 1. Fill engine crankcase to proper level. Refer to requires two people. The mounting hardware for the Engine Owner’s Manual for capacity and oil OPS and seat belts must be properly torqued. Do Not specifications. Check with dipstick unthreaded. modify the OPS in any way.

Краткое содержание страницы № 4

STEP 8 (Continued) WARNING ACTIVATE BATTERY Shield the positive terminal with Terminal Cover located on Positive Battery Cable. This prevents 8. Thoroughly clean any spilled acid from battery. metal from touching the positive terminal, which Neutralize with Baking Soda and flush with large could cause sparks. quantity of water. Dry off battery. 9. Install battery into power unit. Place battery into battery tray and secure in place with retaining rod. See Figure 1.5. STEP 9

Краткое содержание страницы № 5

STEP 10 (Continued) INSTALL OPERATOR’S AND PASSENGER’S SEAT (3) SEAT BOLTS 1/2-13 X 3” BOLT & 1/2-13 NYLOC NUT HINGE ROD 1/2-13 X 3 3/4” BOLT & 1/2-13 NYLOC NUT PROP ROD FIGURE 1.8 STEP 12 HAIRPIN ALIGN LATCH IF NECCESARY Lower the Cargo bed slowly until the latch contacts the FIGURE 1.7 striker pin. The head of the striker pin should be inside of the latch as shown in figure 1.9. If it is not aligned STEP 11 correctly, loosen the bolts that atta

Краткое содержание страницы № 6

DEALER CHECKLIST FOR SNAPPER GROUNDS CRUISER The following must be completed prior to sale. Refer to the previous pages in this setup instruction and in the Operator’s manual for detailed instructions. Review this checklist with purchaser. Check () all items actually performed. Purchaser and dealer must sign this form and the dealer retain the form for future reference. SET-UP _____ GENERAL INSPECTION for loose, missing or damaged components. Repaired as necessary. _____ WHEEL LUG N