Краткое содержание страницы № 1
Pilot 3380
Tracker 5505/5605
A U T O P I L O T
C H A R T P L O T T E R
Installation and
Operation Manual
NAVMAN
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
w w w . n a v m a n . c o m
w w w . n a v m a n . c o m
Краткое содержание страницы № 2
! CAUTION IMPORTANT SAFETY INFORMATION Please read carefully before installation and use. ! W ARNING This is the safety alert symbol. It is used to alert you to potential personal injury hazards, Obey all safety messages DANGER ! CAUTION ! CAUTION that follow this symbol to avoidpossible injury or death. WARNING indicates a potentially hazardous situation which, CAUTION ! W ARNING ! W ARNING if not avoided, could result in death or serious injury CAUTION indicates a potentially hazardous sit
Краткое содержание страницы № 3
Important It is your sole responsibility to install and use Navman’s instrument and GPS antenna in a manner that will not cause accidents, personal injury or property damage. Always observe safe boating practices. The choice, location, angle and installation of the instrument & GPS antenna are critical to performance of the system as intended. Follow instructions in this manual carefully. If in doubt, consult your Navman dealer. Ensure that any holes cut are in a safe position and will no
Краткое содержание страницы № 4
Contents 1 Introduction .......................................................................................................................................... 7 1-1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1-2 Cleaning and maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1-3 Plug-in cards . . . . . . . .
Краткое содержание страницы № 5
10 Fuel functions and display .................................................................................................................. 31 10-1 What the fuel computer does . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 10-2 Fuel display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 10-3 When you add or remove fuel . . . . . . . . . . . . .
Краткое содержание страницы № 6
Appendix A - Specifications ..................................................................................................................... 60 Appendix B - Troubleshooting ................................................................................................................. 62 Appendix C - Glossary and navigation data .............................................................................................. 65 Quick reference Feature Type See Requires General How to use the
Краткое содержание страницы № 7
1 Introduction 1-1 Overview The NAVMAN TRACKER is a compact, rugged, SmartCraft engine functions require a highly integrated marine chartplotter. It is easy SmartCraft system to be installed. For to use and has an easy to read colour display. information on using SmartCraft, see Complex functions can be performed with a few the SmartCraft Gateway Installation and key presses, taking the hard work out of boating. Operation Manual. This manual covers: The TRACKER can send data to other instr
Краткое содержание страницы № 8
! CAUTION ! W ARNING DANGER Changing the plug-in card CAUTION Handle plug-in cards carefully. Keep them in their protective cases when not plugged into the TRACKER. Keep the holder in place in the TRACKER at all times to prevent moisture from entering the card compartment. Gold contacts under here 1 2 3 4 Card Holder Turn the TRACKER off (see section 2-2). Push new card into holder. Ensure the gold contacts are on the outer edge and underneath Pull the card holder out of the TRACKER and (se
Краткое содержание страницы № 9
2 Basic Operation Overview of the keys 1) Go back to an earlier menu or display. Any changes made are 1) ignored. In chart mode, centres chart at boat’s position. 2) 2) Show a menu of the main displays. To go to a display, select it from 3) the menu (see section 2-8). 3) Cursor keys, to move the cursor or the selection highlight. 4) 5) 4) Show a menu of the options for the current display. Press again to display the Setup menu (see section 14). 6) 5) Start an action or accept a change. 6) Z
Краткое содержание страницы № 10
2-2 Using the menus Operate the TRACKER by selecting items from menus. Items can be submenus, commands or data. Selecting a submenu A after a menu item indicates a submenu, for example Chart . Press or to move c) To change a name or number: the highlight to the submenu, then press . 1 Press to display the name or number: Starting a command Press or to move the highlight to the command, for example Goto cursor, then press 2 Press or to select a letter or digit to . change. Press
Краткое содержание страницы № 11
2-4 Backlight and night mode To go to the Backlight display, press briefly. Night mode When you have finished, press . Night mode sets the palette for all displays. Backlight Normal palette, for daytime The display and keys are backlit. To change the A palette optimised for night time. backlight level, select Backlight, then press To change mode, select Night mode, then to dim or to brighten. press . To change only the chart palette, see Tip: Press twice to give the brightest secti
Краткое содержание страницы № 12
2-7 Simulate mode Demo: Simulates a boat moving along a In Simulate mode, the TRACKER ignores data from the GPS antenna and other transducers route and automatically displays different and sensors and the TRACKER generates this TRACKER functions. data itself. Otherwise, the TRACKER functions To start and stop Simulate mode, and for more normally. information, see section 14-11. In simulate There are two simulate modes: mode, Simulate or Demo flashes at the ! CAUTION bottom of the di
Краткое содержание страницы № 13
Other menu and displays Note: Press to go from an Other display back to your last chart display. TRACKER 5505/5505i/5605 Installation and Operation Manual NAVMAN 13 www.Busse-Yachtshop.de email: info@busse-yachtshop.de
Краткое содержание страницы № 14
2-8-1 Dual displays If Chart is the active display: press The TRACKER can show two displays at once, to display the options for Chart; press for example Chart + Gauges. One of the twice to make Gauges the active displays, called the active display, has a yellow display. border and is controlled by the user. To change If Gauges is the active display: press the active display, press twice (Highway wto display the options for Gauges; press cannot be the active display). For example:
Краткое содержание страницы № 15
Tip: If less than the maximum number of lines of data are used, the data will take up less of the display area. 5 Press to return to the display. 2-8-3 Compass The chart and highway displays can show a To turn the compass off or on: compass at the top of the display. 1 Press and select Data header. The compass always shows the boat’s course 2 Set Compass to or . over ground (COG), a red symbol in the middle. When the boat is navigating to a point, the compass also shows bearing to the d
Краткое содержание страницы № 16
3 Navigation: Chart The chart display shows the chart, the boat’s position course and navigation data. 3-1 Overview of navigating The TRACKER has two ways of navigating, going straight to a point or following a route. 3-1-1 Navigating to a point B D When the TRACKER is navigating to a point, the chart and highway displays show navigation C data: A The boat position . A B The destination point marked with a circle. D C The boat’s plotted course to the destination. D Two CDI lines, parallel t
Краткое содержание страницы № 17
Going to a point on the chart Navigating 1 Switch to a chart display. The TRACKER navigates to the point as described in section 3-1-1. 2 Move the cursor to the destination point: either use the cursor keys or use Find (see Cancelling navigating section 3-2-5). Go to a Chart display, press and select ! CAUTION 3 Press and select Goto cursor. Cancel goto. ! W ARNING Make sure the course does not pass over land or dangerous waters. DANGER Tip: Before starting, create waypoints at points of
Краткое содержание страницы № 18
3-2 Chart display To go to the Chart display, press , select Chart, then select Chart. A typical chart display shows: A B C D K E J F I H G A Data header. To turn the data off or on or to change what data is displayed, see section 2-8-2 B Compass (see section 2-8-3) C Chart scale (see section 3-2-3) D Boat position (see section 3-2-1) E Boat track (see section 3-5) F Boat course and CDI lines (see Appendix C, CDI). The boat is going to the waypoint called FISH06 G Distance and bearing of curso
Краткое содержание страницы № 19
3-2-1 Chart modes The Chart has two modes: Press midway between two of the cursor keys to make the cursor move diagonally. Centre on boat mode Hold a cursor key down to make the cursor To switch to centre on boat mode in the chart move continuously across the display. display, press . The boat is at the centre of the chart. As the boat moves through the In Cursor mode: water, the chart automatically scrolls to keep The distance ( DST) and bearing ( BRG) the boat in the centre of th
Краткое содержание страницы № 20
3-2-5 Finding a chart symbol To find and display a chart symbol: For Ports by name: to search for a different port name, press . change the name, 1 Press and select Find. then press . 2 Select the type of symbol: Waypoints, 5 Select the item and press . The chart Routes, Ports by name, Ports & services, or display changes to show the item in the Tide stations. middle of the display. 3 For Ports & services: select the type of To see stored information about the item, service to find.
