Руководство по эксплуатации SECO-LARM USA ENFORCER Push-to-Exit Bars SD-961A-36

Краткое содержание страницы № 1

b. The height of the push bar from the floor may be subject to local regulations.
c. The best looking installation will have the push bar centered on the door, as measured
Installation Manual
from the left and right. However, before drilling the holes, make sure the door opens and
closes properly. If not, it may be necessary to adjust the push bar to the right or left a bit.
®
(This must be checked with the aluminum top and its end-caps on.)
4. With a pencil, mark the four bolt or screw holes an

Краткое содержание страницы № 2

Figure 1: Installation of the SD-961A-36 Included: 1 x Push bar 4 x Locking washers 4 x Small plastic caps 1 x Key 4 x Sex bolts 1 x Large plastic cap 1 x SD-969-A18 4 x Machine screws 4 x Wood screws Armored door cord Machine screws Square- head bolt to lock the push bar Wire Rubber cover for square Connector head bolt Cut to size if needed Wires For hollow doors: 9.8mm hole for sex bolts (outside the door) 6mm hole 1.57”x 2.35” for screws End cap (45-60mm) (inside door the door) Connect to unl