Руководство по эксплуатации Edelbrock Torker 2930

Краткое содержание страницы № 1

TORKER AMC INTAKE MANIFOLD
For 1970 and Later AMC 343-401 C.I.D. Engines
Catalog #2930
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this
installation, it is recommended to have the installation completed by a qualified mechanic. If you have any

Краткое содержание страницы № 2

• BRACKETS: 1. Some vehicles will require a throttle bracket extention plate to move the stock throttle bracket forward. This extention is available as Edelbrock #8034 (See Fig. 1). 2. Vehicles with automatic transmissions will require using a kickdown stud on the throttle lever to operate the transmission kickdown rod. The supplied kickdown stud fits directly to the lower hole on the throttle lever of Performer and Thunder series carburetors (See Fig. 2). 3. Remove the lifter valley heat shiel

Краткое содержание страницы № 3

INSTALLATION 1) Use only recommended intake gaskets set when installing this intake manifold. 2) Fully clean the cylinder head intake flanges and the engine block end seal surfaces. 3) Apply Edelbrock Gasgacinch sealant P/N 9300 to both cylinder head flanges and to the cylinder head side of the gaskets, allow to air dry, and attach the intake gaskets. 4) Do not use cork or rubber end seals. Use RTV silicone sealer instead. Apply a ¼" high bead across each block end seal surface, overlapping t