Руководство по эксплуатации Edelbrock 2838

Краткое содержание страницы № 1

Carbureted Victor Jr. 4.6L Intake Manifold
®
For 4.6L SOHC Ford V8
Catalog #2839 (with Timing Control Module)
& #2838 (without Timing Control Module)
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the ins

Краткое содержание страницы № 2

MAP SENSOR INSTALLATION: 1. Apply a bit of liquid Teflon thread sealant to the threads of the supplied 1/8” NPT to 1/4” hose fitting and install the fitting into the 1/8” NPT hole in the intake manifold plenum (See Figure 2). 2. Attach the MAP sensor to the supplied bracket (See Figure 3). 3. Install the sensor/bracket assembly on the intake manifold using the throttle cable bracket bolt hole bosses (See Figure 4). If using a Ford throttle cable bracket, install the sensor assembly on top of the

Краткое содержание страницы № 3

CARBURETOR RECOMMENDATIONS: Manifold will accept any standard square bore flange carburetor, including all Edelbrock Thunder AVS and Performer models. Due to engine efficiency and runner design, we recommend the use of a 600 cfm or larger carburetor. Dyno testing was conducted with our 750 cfm high performance carburetor (part #1407). The best results were achieved with the stock primary jet, .075” x .047” metering rods (part #1459), and .100” secondary jets (part #1428). We recommend using the

Краткое содержание страницы № 4

® Edelbrock Corporation • 2700 California St. � Torrance, CA 90503 Tech-Line: 1-800-416-8628 � E-Mail: Edelbrock@Edelbrock.com Catalog #2838, 2839 ©2007 Edelbrock Corporation Rev. 9/07 - AJ/mc Brochure #63-2838