Краткое содержание страницы № 1
User’s Manual
E552
E462
E422
E322
Краткое содержание страницы № 2
Index Precautions And Reminders ���������������������������������������������������������������� English-1 Important Safety Instructions ��������������������������������������������������������������� English-2 Safety Instructions ������������������������������������������������������������������������������� English-4 Important Information �������������������������������������������������������������������������� English-5 Declaration Of Conformity ����������������������������������������������
Краткое содержание страницы № 3
Precautions And Reminders Do not place the display Do not open the display Call a NEC certified in confined spaces or in a cabinet� service personnel for any box when in use� Maintain internal service needed ample ventilation for the for your display� display when in use� Keep the display away Unplug immediately if any Unplug immediately if from direct sunlight, dust, foreign object is put in the there is a display malfunc- humidity, and smoke� display or if the display tion such as a loss o
Краткое содержание страницы № 4
Important Safety Instructions Read before operating equipment The lamps in this product contain mercury. Please dispose according to state, local or federal law. Follow all warnings and instructions marked on this display� 1� Read these instructions� 2� Keep these instructions� 3� Heed all warnings� 4� Follow all instructions� 5� Do not use this apparatus near water� 6� Clean only with dry cloth� 7� Do not block any ventilation openings� Install in accordance with the manufacturer's instructio
Краткое содержание страницы № 5
the cabinet� This could cause the product to tip over and cause damage and/or personal injury� 16� If monitor or glass is broken, do not come in contact with the liquid crystal and handle with care� 17� Follow instructions for wall, shelf or ceiling mounting as recommended by the manufacturer� 18� An outdoor antenna should not be located near overhead power lines or any electrical circuits� 19� If an outside antenna is connected to the receiver, confirm that the antenna system is grounded t
Краткое содержание страницы № 6
Safety Instructions FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rule � These limits are designed to provide reasonable protection against harmful interference in a residential installation� This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio communications � However, t
Краткое содержание страницы № 7
Important Information WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE� ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED� REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE� REFER SERVICING TO QUALIFIED SERVICE PERSONNEL� CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE POWER CORD IS UNPLUGGED FROM WALL SOCKET� TO FULLY DISENGA
Краткое содержание страницы № 8
Batteries installed warning Caution - Danger of explosion if batteries are incorrectly replaced� Replace only with the same or equivalent type� The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Ventilation The
Краткое содержание страницы № 9
Installed with stand 11 7/8 inches 30 cm 4 inches 4 inches 10 cm 10 cm Leave at least this space around the set. 4 inches 10 cm Never install the TV set where Air circulation is blocked� Objects and ventilation holes Never push objects of any kind into the TV through the cabinet slots as they may touch dangerous voltage points or short out parts that could result in a fire or an electric shock. Do not place any objects on the TV. English-6 English-7 English
Краткое содержание страницы № 10
Declaration Of Conformity This device complies with Part 15 of FCC Rules� Operation is subject to the following two conditions (1) � This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation� U.S. Responsible Party: NEC Display Solutions of America, Inc. Address: 500 Park Boulevard, Suite 1100 Itasca, Illinois 60143 Tel. No.: (630) 467-3000 Type of Product: Digital Signage Display Equi
Краткое содержание страницы № 11
3� following procedures: • Reorient or relocate the receiving display� • Increase the separation between the equipment and display� • Connect the equipment into a different outlet than the receiver� • Consult your dealer or an experienced radio/display technician for assistance� If necessary, the user should contact the dealer or an experienced radio/ television technician for additional suggestions. The user may find the following booklet, prepared by the Federal Communications Commission, he
Краткое содержание страницы № 12
Preparation IMPORTANT: Do not apply pressure to the screen display area which may compromise the integrity of the display� The manufacturer’s warranty does not cover user abuse or improper installations� Preparing Your LCD Display For Wall Mounting We suggest that you keep your display at least 2�36 inches (60 mm) from the wall to prevent cable interference� Before mounting your display on the wall, you need to remove the base For your safety � , only mount with a UL listed wall mount brack
Краткое содержание страницы № 13
Attaching the Base E322 / E422 / E462 E552 1� Place the display face down on a soft and flat surface to prevent scratching and damage� 2� Carefully align the base to the stand and fasten the screws with a cross- head screwdriver� CAUTION: The base of the stand is very heavy� Install with care to avoid injury such as dropping the base onto one's foot� Place The Display On A Solid Surface Ensure that the LCD display is placed in a position to allow free flow of air� Do not cover the ventilatio
Краткое содержание страницы № 14
Battery Installation and Replacement The remote control is powered by two 1�5V AAA batteries� To install or replace batteries: 1� Open the battery cover of the remote control by pushing and pulling it in the direction of the arrow� 2� Insert two new “AAA” size batteries for the remote control� When replacing old batteries, push them towards the springs and lift them out� 3� Match the batteries to the (+) and (-) marks in the battery compartment� 4� Insert the bottom of the battery, the (
Краткое содержание страницы № 15
Connect To The Power Source The display should be installed close to an easily accessible power outlet� Fully insert the prongs into the power outlet socket� A loose connection may cause image degradation� If there is power to the display, the front LED at the bottom of the display will be either blue or red� A blue LED means the display is powered on� A red LED means the display is in standby mode� Power On/Off Your New LCD Display Press the power key on the remote control or press the powe
Краткое содержание страницы № 16
7 3 8 1 9 2 5 6 1 4 Source Connection Guide E322/E422/E462 E322/E462 E422 AC POWER ® English-14 English-15
Краткое содержание страницы № 17
6 7 5 4 8 9 1 2 E552 AC POWER 1� HDMI – Connect the primary source for digital video such as a DVD multimedia player or set top box through this all digital connector� 2� RGB/AUDIO – Connect the video and audio cables from a computer here� 3� AV – Connect the primary source for composite video devices, such as a VCR or video game� Use the white and red connectors to connect the external audio from the same source� 4� COMPONENT (Y-PbPr with Audio L/R) – Connect the primary source for componen
Краткое содержание страницы № 18
8� USB/SERVICE – Insert USB storage device to view photos and listen to the music /This USB slot is for future software upgrades � � 9� RS-232C – Input from external equipment such as a PC or AV control system in order to control RS-232C functions� Once your AV device is connected, press the Source button on the remote control to select the relevant source to view� (ex: Press COMP button to select “Component” if you have connected a source to the Component input�) RS-232C Port Specifications
Краткое содержание страницы № 19
5 1 6 2 1 3 2 4 3 5 6 4 7 7 Operating Instructions E322/E422/E462 E552 Using The Side Panel Controls Press to increase the volume� 1� VOL + Press this key to shift Right in the OSD menu� Press to decrease the volume� 2� VOL - Press this key to shift Left in the OSD menu� Press to increase the channel number� 3� CH ▲/ Press this key to shift up in the OSD menu� Press to decrease the channel number� 4� CH ▼/ Press this key to shift down in the OSD menu� 5� MENU Press to open or exit the OSD (On-
Краткое содержание страницы № 20
Using The Remote Control Power Press to turn On/Off (standby) the power� (Note: To completely turn off the power, unplug the AC cord from CO M P the power outlet�) TV Press to choose ATSC/NTSC tuner source mode� AV Press to choose Composite source mode� PRE CH COMP Press to choose Component source mode� HDMI/PC Press repeatedly to choose PC IN or HDMI source mode� 0 ─ 9 / - number Press to enter the tuner channel number to select channel (Press ‘-’ to choose the sub-channel)� PRE CH Pre