Краткое содержание страницы № 1
EZVR4
User’s Manual
Speco Technologies
200 New Highway
Amityville, NY 11701
800-645-5516
www.specotech.com
Краткое содержание страницы № 2
Safety Precautions CAUTION RISK OF ELECTRICAL SHOCK. DO NOT OPEN ! CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of insulated dangerous Voltage within the product’s enclosure that may be of
Краткое содержание страницы № 3
About this document Before installing the unit, be sure to thoroughly review and follow the instructions in this User’s Manual. Pay particular attention to the parts that are marked NOTICE. When connecting with external application, first turn the power OFF and follow manual instructions for appropriate installation. Before reading this document 1. This manual contains information for configuring, managing and using the EZVR4. 2. To prevent fire or electrical shock, do not exp
Краткое содержание страницы № 4
FCC Statement: WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received including interference that may cause undesired operation." * Federal Communications Commission (FCC) Statement WARNING This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of th
Краткое содержание страницы № 5
MADE IN A WA T I N ODEL NO.: M R . SE NO: M D A EINTAIWAN D L O MO E N .: SER NO.: INSTALLATION 1. The package 2. Un-packed 3. Take the unit out from the package 4. Put on a flat desk 5. Connect your camera cables to the BNC 6. Connect your monitor cable to the BNC connectors on the rear. connector labeled “Monitor” on the rear. 7. Connect the power adaptor. 8. Turn on the “Power” switch after the cameras are installed. The EZVR4 will then “boot” up and begin recording.
Краткое содержание страницы № 6
FRONT PANEL 1. : Quad screen mode button 2. CHANNEL 1 : Channel 1 full screen button 3. CHANNEL 2 : Channel 2 full screen button 4. CHANNEL 3 : Channel 3 full screen button 5. CHANNEL 4 : Channel 4 full screen button 6. 24H : 24 hour recording mode 7. 72H : 72 hour recording mode 8. 240H : 240 hour recording mode 9. 480H : 480 hour recording mode 10. 960H : 960 hour recording mode 11.
Краткое содержание страницы № 7
REAR PANEL Power cord in 12VDC / 5A, Power Switch (ON / OFF) Camera 1 ~ 4 input BNC type Main monitor output Audio channel input x 1 and output x 1 – RCA Type Alarm / Relay connector 7
Краткое содержание страницы № 8
Booting Up Detecting the hard disk Live screen Indicator: Live: HDD installed Recording Overwrite Live mode Video loss Key lock Alarm Input Alarm Output Playback: Forward Reverse Pause 8
Краткое содержание страницы № 9
Remote controller The keys on the remote control have the same functions as the front keyboard of the unit. 9
Краткое содержание страницы № 10
Main MENU – Time Setup 1. Press ENTER to select Time Set. Press ENTER again to display the cursor. 2. Use the left or right buttons to select the item you wish to adjust, then press ENTER to change the value. 3. Press MENU to return to the previous screen and move the cursor to Apply. 4. Press ENTER to confirm. 5. Select On or Off for Daylight Savings Time. Once the time is initially set, changing the DST mode will adjust the time appropriately.
Краткое содержание страницы № 11
Main MENU – Audio Record Use direction buttons to select Audio Record. Press ENTER to select On or Off. Diagram Speaker RCA RCA Cable Audio Out (Line Level) Microphone RCA Audio In (Line Level) 11
Краткое содержание страницы № 12
Main MENU – Alarm Input Use direction buttons to select Alarm Input. Press the Enter button to choose the type of sensor input (Normally Open - NO or Normally Closed - NC). To disable the alarm mode switch to the Off position.. Main MENU – Alarm Output Use direction buttons to select Alarm Output. When switched to Off the alarm output is disabled. Press the Enter button to turn the output relay on or off. 12
Краткое содержание страницы № 13
Alarm Input Door closed Door open Alarm 1 + GND / Alarm 2 + GND / Alarm 3 + GND / Alarm 4 + GND The Alarm Signal type depends upon the Alarm Sensor polarity defined as NO (Normal Open) or NC (Normal Close). Alarm Output: Relay: NO + COM or NC + COM Relay: NO (Normal open) Alarm trigger Relay: NC (Normal Close) NO COM NC COM 13
Краткое содержание страницы № 14
Main MENU – Auto Record Use direction buttons to select Auto Record. When Auto Record is set to On, the EZVR4 Press the Enter button to choose On or Off. will start recording again after 2 minutes of If switched to OFF then Auto Record is inactivity after being manually stopped. disabled. Main MENU – Overwrite HDD Use direction buttons to select Overwrite NO - Recording stops when the Hard Enable. Press the Enter button to choose Drive is full Yes or No. YES – Recording continu
Краткое содержание страницы № 15
Main MENU – Language Use direction buttons to select Language. Press Enter button to choose a language. Supported Languages: English / French / Spanish Main MENU – Exit Use direction buttons to select Exit. Press Enter button to leave the menu. 15
Краткое содержание страницы № 16
Playback mode – Note: Instructions appear on the screen after selecting “Search” Press SEARCH to enter the playback mode. Press ENTER to select a date and time. Use the left or right arrows to select the item Press MENU to return to the previous screen you wish to change, then press ENTER to and move cursor to Search. change the value Press ENTER to start the searching. Wait until the unit starts to playback. 16
Краткое содержание страницы № 17
Backup mode Note: Plug in a USB device before starting the backup You must first playback an event using When the event you wish to backup appears instructions from the previous page. on the screen, press the BACKUP button to select the start time. Press the BACKUP button a second time to select the end of the copy. The unit will detect the USB drive and copy the data to the USB device. After the backup procedure is completed you will be returned to the live screen. The viewer and
Краткое содержание страницы № 18
Player Software Main Screen Click icon to select the file to play. It will be in .vvf format 18
Краткое содержание страницы № 19
Starts to play; Open File Play Fast Reverse Fast Forward Play Reverse Still Capture (Save to C:\ Capture & Clipboard) Previous Frame Full Screen (manual switch) Pause Quad Screen Next Frame AVI Button: .vvf file export to .avi format Select export channel(s) and click audio if included. Browse for the source file Browse a path for file output Select a compression codec Percentage of the export AVI progres
Краткое содержание страницы № 20
Specifications Model EZVR4 Input 4 CH Inputs 1.0Vp-p, 75ohm (BNC Type) Output Main monitor composite video (BNC type) x 1 Horizontal Resolution 640x448 (NTSC) / 640x544 (PAL) S/N Ratio More than 40dB Color 6.7 Million Monitoring Method Channel Display Single / Quad channel 640(H)x 448(V) Active Pixels(NTSC); Screen Quality 640(H) x 544(V) Active Pixels (PAL) Display Rate 120 fps (NTSC) / 100 fps (PAL) Recording/ Play Function Compressed Picture M - JPEG Recording Control A
