Краткое содержание страницы № 1
Personal Video Recorder
Personlig digital videospelare
CONAX embedded
Inbyggd CONAX
CXC-2000PVR
User's Manual
Användarhandbok
Краткое содержание страницы № 2
** ** ** ** ** Notice ** Copyright (Copyright © 2001 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. ** Warranty The information in this document is subject to change without notice. HUMAX does not have any responsibility for direct, indirect, accidental, necessary and other damage due to your offer or use of the information contained in this manual. ** Trademarks VIACCE
Краткое содержание страницы № 3
** ** ** ** ** Notice ** Read this manual carefully and make sure you understand the provided instructions. For your safety, check what the result each action will be. Warnings, Cautions and Notes Throughout the whole manual, pay special attention to the following marks that indicate hazardous situations. ** Warning Indicates a hazardous situation which, if not avoided, could result in (serious) injury. Caution Indicates a situation which, if not avoided, could damage the equipment or other
Краткое содержание страницы № 4
** ** ** ** ** Safety and Warning ** This Personal Video Recorder has been manufactured to comply with international safety standards. Please read the following safety precautions carefully. Safety Instructions and Precautions 1. MAINS SUPPLY ** 90 - 250V AC 50/60Hz Operate your product only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your local power company. Disconnect the product from the mains before you
Краткое содержание страницы № 5
** ** ** ** ** Safety and Warning ** 9. LIGHTNING, STORM, or NOT IN USE ** Unplug the product from the wall outlet and disconnect the cable during a thunderstorm or when left unattended and unused for long periods of time. This will prevent damage to the unit due to lightning and power-surges. ** 10. EXTRANEOUS OBJECTS ** Do not insert anything through the openings in the unit, where they can touch dangerous voltage points or damage parts ** 11. REPLACEMENT of PARTS ** When replacement parts are
Краткое содержание страницы № 6
** ** ** ** ** Contents ** 1. Before Using the Recorder GB8 ** 1.1 Package Contents GB8 1.2 Front Panel GB9 1.3 Rear Panel GB10 1.4 Conditional Access GB11 1.5 Remote Control Unit GB12 2. Setup GB14 ** 2.1 Connecting the Cable GB14 2.2 Powering On GB17 3. Installation Wizard GB18 ** 3.1 Language GB18 3.2 Area Setting GB18 3.3 Channel Search GB19 3.4 Time Setting GB20 3.5 Result GB20 4. Basic Operation GB21 ** ** ** 4.1 Switching Channel GB21 4.2 Volume Control GB21 4.3 Teletext GB21 4.4 Changing
Краткое содержание страницы № 7
** ** ** ** ** Contents ** 6. Recording and Playback GB31 ** 6.1 Instant Recording GB31 6.2 Recording Reservation GB31 6.3 Programme Playback GB33 6.4 Editing Recorded Programmes GB33 6.5 Checking Hard Disk Drive GB35 7. Channel List GB36 ** 7.1 Displaying and Switching Channel List GB36 7.2 Changing Channel List Group GB37 7.3 Edit Channels GB38 7.4 Edit Favourite Channels GB40 7.5 Channel Change Mode GB43 8. Programme Guide GB44 ** 8.1 Viewing Programme Guide Information GB44 8.2 Finding a Pro
Краткое содержание страницы № 8
** ** ** ** ** ** ** 10. Installation GB59 ** 10.1 Channel Search GB59 10.2 Linear Search GB62 10.3 Default Setting GB64 11. Software Update GB65 ** 11.1 OTA (Over the Air) GB65 12. System Information GB68 ** 12.1 Status GB68 12.2 Signal Detection GB68 12.3 Conditional Access (for Conax embedded) GB69 13. Games GB70 14. Menu Map GB71 15. Troubleshooting GB72 ** 15.1 Troubleshooting GB72 15.2 Error Message GB73 ** ** 16. Specification GB74 17. Glossary GB76 18. Service and Support GB77 ** ** GB 7
Краткое содержание страницы № 9
** ** ** ** ** 1. Before Using the Recorder ** This chapter provides detailed instructions on the product and its accessories. 1.1 Package Contents Please check all package contents before using your product. ** ** Remote Control Unit Batteries User's Manual ** ** ** ** ** SCART Cable RF Cable ** ** ** Note: Since faults may occur if the remote controller is being left without a battery for a long time, always keep the battery inserted in the remote controller. ** Warning: To install a hard di
Краткое содержание страницы № 10
** ** ** ** ** ** ** 1.2 Front Panel ** ** 1. STANDBY LED ** Red light is displayed when the product is in the standby mode. ** ** ** 2. RECORD LED ** Green light is displayed when the product is in recording. ** 3. RADIO LED ** Yellow light is displayed when the recorder is in radio mode. ** 4. STANDBY Button ** Switches between operation and standby modes. ** 5. TV/RADIO Button ** Switches between TV and Radio. ** 6. CH-/CH+ ** Moves the TV/Radio channel up/down. ** 7. SMART CARD SLOT ** Slot
Краткое содержание страницы № 11
** ** ** ** ** 1. Before Using the Recorder ** 1.3 Rear Panel ** ** 1. CABLE IN ** Connects a cable to a CABLE input jack on the Recorder. ** 2. TV/VCR ** Connects a RF signal from your recorder to RF(ANT) input jack on your TV or VCR. ** 3. TV SCART ** Connects a TV SCART cable. ** 4. VCR SCART ** ** ** Connects a VCR SCART cable. ** 5. S/PDIF ** Outputs the digital audio signals. ** 6. VIDEO ** Connects to your TV or VCR and output Video signals. ** 7. AUDIO L/R ** Connects to your TV or VCR a
Краткое содержание страницы № 12
** ** ** ** ** ** ** 1.4 Conditional Access Although some TV and Radio channels are free to air, most TV and Radio/Music channels are available on a subscription basis and can only be enjoyed via Conditional Access component. The Conditional Access component is removable Smartcard. ** Inserting Smartcard ** A Smartcard looks similar to a credit card and entitles you to view and listen to all the channels you choose to subscribe to. The Smartcard slot on the product can be used for Conax Smartcar
Краткое содержание страницы № 13
** ** ** ** ** 1. Before Using the Recorder ** 1.5 Remote Control Unit ** ** ** ** GB 12 ** ** ** ** ** **
Краткое содержание страницы № 14
** ** ** ** ** ** ** 1. SOURCE 11. PLAYBACK CONTROL BUTTONS ** ** Selects the input source between TV Includes fast rewind, play, fast forward, and recorder. record, stop, pause buttons. ** ** 2. TV/RADIO 12. STANDBY ** ** Switches between TV and Radio modes. Switches between Operation and ** Standby modes. ** 3. NUMERICAL (0~9) BUTTONS ** 13. GUIDE Enters a TV/Radio channel number or ** menu option number. Displays the Programme Guide. ** ** 4. LIST 14. EXIT ** ** Displays the channel list. Exi
Краткое содержание страницы № 15
** ** ** ** ** 2. Setup ** This chapter describes how to set up the Recorder. Select the most appropriate procedure depending on your requirements. Note: If you encounter any problem when setting up the Recorder, please contact your local product distributor. 2.1 Connecting the Cable 1. Connecting TV This is the most simple setup mode. ** ** ** ** Connect your CATV line to the CABLE IN socket on the Recorder for receiving cable services. TV Scart are connected as in the figure above. ** ** G
Краткое содержание страницы № 16
** ** ** ** ** ** ** 2. Connecting TV/VCR with 2 SCARTs This is the optimal way to connect the Recorder. ** ** ** ** ** GB 15 ** ** ** ** ** **
Краткое содержание страницы № 17
** ** ** ** ** 2. Setup ** 3. Connecting Hi-Fi system If you wish to connect S/PDIF to the optical S/PDIF terminal and Dolby digital decoder to listen digital audio, connect as following. ** ** ** ** ** GB 16 ** ** ** ** ** **
Краткое содержание страницы № 18
** ** ** ** ** ** ** 2.2 Powering On 1. Connect the power cord of the recorder to a wall outlet. 2. Turn on the power switch, located at the left on the back of the recorder. Make sure that the Standby LED indicator is turned on Red. ** ** 3. Power on by pressing the STANDBY button at Remote Controller. ** ** ** ** ** GB 17 ** ** ** ** ** **
Краткое содержание страницы № 19
** ** ** ** ** 3. Installation Wizard ** When powering on your product for the first time after purchasing, the Installation Wizard is automatically started. You can easily set-up using simple organisation and options, and watch the broadcasting after completing the set-up procedure. You can select items using the NUMERICAL (0-9) button. Note: If you press the BACK button or select Back and press the OK button while running the Installation Wizard, you can return to the previous screen. 3.1 Lang
Краткое содержание страницы № 20
** ** ** ** ** ** ** 3.3 Channel Search You can set parameters to search channels. Select the following item using the button, and press the OK or button. Frequency: The default value is set to 362000. If you wish to set your desired frequency value, select User Define, and enter the value using the NUMERICAL (0~9) button. Symbol Rate: The default value is set to 6875. Select your desired symbol rate using the button, and press the OK or button. If the desired value is not listed, then selec
