Руководство по эксплуатации Audiovox APS-25KB

Краткое содержание страницы № 1

Model APS-25KB
Installation Manual
PRE-INSTALLATION NOTES:
AUTO LOCK / UNLOCK : DIP SWITCH #1
The system is shipped with this feature activated.
Any time the ignition key is turned to the off position, the doors will automatically unlock. Any time the ignition
key is turned to the on position, the doors will automatically lock.
To disable the auto lock/unlock feature, move dip switch number 1 to the "off" position.
PASSIVE / ACTIVE DOOR LOCK SELECTION: DIP SWITCH #2
This feature will only affe

Краткое содержание страницы № 2

CHANNEL 2 OUTPUT: This system provides an additional hardwire remote output to control an assortment of optional upgrades. This output is an independent channel from the transmitter, and is controlled by button #2 on the transmitter. It is a delayed ground pulse (300 mA maximum), and can be used to control: • Optional trunk release relay AS-9256 • Optional remote starter AS-9075 • Optional window roll up AS-9153 CHANNEL 3 OUTPUT (Transmitter Only): The transmitters included in this alarm incorpo

Краткое содержание страницы № 3

DASH MOUNTED LED: A small red LED is included that will serve as a visual indicator of the alarm status. It should be installed in the dash, located where it can be easily seen from outside the vehicle, yet not be distracting to the driver. Once a location has been selected, check behind the panel for wire routing access and to confirm the drill will not damage any existing components as it passes through the panel. Drill a 1/4" diameter hole, and pass the red and blue wires from the LED through

Краткое содержание страницы № 4

WHITE w/ BLACK TRACE WIRE: POSITIVE OUTPUT TO SIREN Route this wire through a rubber grommet in the firewall to the siren location. Connect the white/black wire to the positive wire of the siren. Secure the black ground wire of the siren to chassis ground. BLACK WIRE: CHASSIS GROUND Connect this wire to a solid, metal part of the vehicle’s chassis. Do not confuse this wire with the thin black antenna wire that exits the control module independently. YELLOW WIRE: + 12 VDC IGNITION SOURCE Conne

Краткое содержание страницы № 5

3 Wire Ground Switched Door Locks In this application, the red wire provides a ground pulse during arming (pulsed ground lock) output. Connect the red wire to the wire that provides a low current ground signal from the factory door lock switch to the factory door lock control relay. The green wire provides a ground pulse during disarming (pulsed ground unlock) output. Connect the green wire to the wire that provides a low current ground signal from the factory door unlock switch to the factory d

Краткое содержание страницы № 6

© 2000 Audiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-5732A