Руководство по эксплуатации Wayne-Dalton DOUBLE LOCKBAR ECR LOCK 260597

Краткое содержание страницы № 1

Keyed-in-Handle Secure ECR Lock
Installation Instructions
and Owner’s Manual
Wayne-Dalton Corp.
Models: 260597, 260600
P.O. Box 67 Mt. Hope, OH 44660
www.wayne-dalton.com
All Residential Door Models: 8000/9000 Series & Wood Doors
PHILLIPS HEAD MACHINE SCREWS
(2) FOAM TAPE
(2) 1” (9200) #306564
(9200/9600/9900)
(2) 1-1/4” (9600/8300 & WOOD)#306565
3/4” X 2-1/2”
(6) 1/4-20 X 9/16”
(2) 1-1/2” (9900) #306566
#306653
TRACK BOLTS
(2) 1-3/4” (8000/PR9000/8500) #306567
#200527
UNIVERSAL
LOCK STILE
OUT

Краткое содержание страницы № 2

CENTER STILE Step 1: Installing the ECR Lock CAUTION DO NOT DRILL LOCK SEC- (3)PRE-PUNCHED TION OR INSTALL LOCK ON DOORS WITH HOLES OPENERS. THE DOOR AND/ OR OPENER MAY BE DAMAGED IF THE OPENER IS USED WHILE THE DOOR IS LOCKED. NOTE: Common practice for doors with the odd number of raised panels is to mount the lock towards (3) 3/4” DIA. the right side of the section when looking out. HOLES FACE UP FACE DOWN IMPORTANT: Remove all burrs from the drilled holes before installing the lock to

Краткое содержание страницы № 3

Step 2: Outside Lock Handle Assembly 3/4” DIA. 8000/PR9000 & PR9050 Series doors (see Fig. 4), HOLES align the outside handle assembly with the handle point- ing towards the fl oor and insert the assembly through OUTSIDE the previously drilled 3/4” diameter holes in the section. HANDLE HANDLE Secure the outside lock handle to the section with (2) SHANK #10 phillips head screws. 9000 Series & Wood doors (see Fig. 5), align the out- #10 PHILLIPS side handle assembly with the handle pointing tow

Краткое содержание страницы № 4

Step 4: Installing the Secure Lock 1 8000/9000 Series & Wood doors (Fig.1-3), locate the inside handle and uncoil the lock cable, then thread the cable through the inside handle as illustrated (see Fig.1). 3 Locate the secure lock striker plates over the pre-punched 2 holes in the vertical track nearest the center of the lock section (see Fig.2). Fasten the striker plates to the vertical track using (2) 1/4-20 x 9/16” track bolts and fl anged hex nuts. Lock bars are embossed “R” for right s