Руководство по эксплуатации Sony SCHLAGE LINK BE369

Краткое содержание страницы № 1

Schlage Wireless Locks
User Guide
Contents
Programming and User Codes .......................................... 2
Programming Code ........................................................... 2
User Codes ....................................................................... 2
Turn Lock Feature ............................................................... 2
Replacing the Batteries ...................................................... 3
BE369 Deadbolt ........................................

Краткое содержание страницы № 2

Programming and User Codes All locks are pre-programmed with a programming code and two user codes. The programming code and user codes can be changed at any time. All pre-programmed codes can be found on the yellow sticker on the front of the Installation Instructions that come with the lock. An identical label is also located on the inside (part that faces the door) of the keypad. Programming Code • Used to manually program the lock using the keypad. • Used to put the lock into enrollment

Краткое содержание страницы № 3

Replacing the Batteries BE369 Deadbolt FE599 Lever Lock a. Remove cover screws. a. Remove cover screws. b. Remove screw on upper left to release upper battery tray. b. Remove cover. Hold battery tray in place while loosening screw. c. Remove battery cover. c. Upper battery tray will be released. Fully remove tray and d. Remove four old AA batteries. remove three old AA batteries. e. Replace batteries with 4 new, high-quality AA batteries. d. Remove 9V battery. Reverse steps to replace the bat

Краткое содержание страницы № 4

Restoring Factory Settings Restoring the factory settings will: • Restore the original programming code • Restore the pre-programmed user codes If you have an active account at www.schlagelink.com, the user codes listed in the web interface for the lock will be restored in the physical lock when lock reconnects with the bridge. The original pre-programmed user codes will also be added to the web interface. Restoring factory settings WILL NOT exclude the lock from the bridge. DO NOT reset your

Краткое содержание страницы № 5

Manual Programming Functions Press the keys on the keypad as shown in the following steps. Wait for the confirmation indicator before proceeding to the next step. If you make a mistake, wait for all lights and beeps to stop and then start over from the beginning. Press New Press Press Press Same New (Six (Four (Four Add Numbers) Numbers) Numbers) Wait For Wait For Wait For Success! 3 Lights + 3 Beeps 3 Lights + 3 Beeps 3 Lights + 3 Beeps 1 Long Light + 1 Long Beep Press Press Press Unw

Краткое содержание страницы № 6

Emergency Key Override If the battery fails completely, or if there is an electronic error, the lock can be unlocked manually using the key. BE369 FE599 Troubleshooting Problem Lights/Beeps Cause Solution at Lock Solution on Web Entering a valid user code Green then Lock is in vacation mode. Enter six-digit programming Uncheck Vacation using the keypad does not Red/Hi then code. checkbox. unlock lock. Low Schlage button does not light none Lock keypad is locked out Wait 30 seconds and try none

Краткое содержание страницы № 7

Problem Lights/Beeps Cause Solution at Lock Solution on Web Cannot change the Red User code already in lock Select a different none programming code. matches the first four digits programming code, or delete of the programming code you the user code that matches are trying to add. the first four digits you want to use. The first programming code Try again. Make sure you none entry did not match the enter the same code twice. second. Cannot delete all user codes Red The first programming cod