Краткое содержание страницы № 1
UF55/UF55w Projector User’s Guide
TM
Part of the SMART Board 600i3
Interactive Whiteboard System
Краткое содержание страницы № 2
Registration Benefits If you register your SMART product, we’ll notify you of new features and software upgrades. Register online at www.smarttech.com/registration. Keep the following information available, in case you need to contact Technical Support: Serial Number Date of Purchase FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against ha
Краткое содержание страницы № 3
Table of Contents Table of Contents ................................................................................... Usage Notice ..........................................................................................2 Precautions....................................................................................................2 Introduction.............................................................................................4 Product Features .....................................
Краткое содержание страницы № 4
Usage Notice Precautions Follow all warnings, precautions and maintenance as recommended in this user’s guide. Warning: Don’t look into the projector’s lens when the lamp is on. The bright light may damage your eyes. W arning: T o reduce the risk of fire or electric shock, don’t expose this projector to rain or moisture. Warning: Don’t open or disassemble the projector as this may cause electric shock. Warning: Take the projector down off the Boom before replacing the lamp. W arning
Краткое содержание страницы № 5
Usage Notice Do • Turn off the product before cleaning it. • Use a soft cloth moistened with a mild detergent to clean the display housing. • Disconnect the power plug from the AC outlet if the product isn’t being used for a long period of time. • Allow 5 minutes before restarting the lamp. This will prolong lamp life. Don’t • Block the ventilation slots and openings on the unit. • Use abrasive cleaners, waxes or solvents to clean the unit. • Use under the following
Краткое содержание страницы № 6
Introduction Product Features ® This product is a single chip DLP projector. Outstanding features include: DLP Technology UF55: • True XGA 0.55" 024 × 768 resolution • Aspect ratio: 4:3 • Short throw ratio: 0.6 UF55w: • True WXGA 0.65" 280 × 800 resolution • Aspect ratio: 6:0 • Short throw ratio: 0.5 2000 ANSI Lumens (typical) Computer compatibility: ® ® ® ® Apple Macintosh , iMac , and VESA Standards: UXGA, SXGA+, SXGA, WXGA, XGA, SVGA, VGA V ideo com
Краткое содержание страницы № 7
Introduction Projector Package Overview This projector comes with all the items shown below. Check to make sure your package is complete. Contact your dealer immediately if anything is missing. Vol. Projector Remote Control User’s Guide Introduction 5 English
Краткое содержание страницы № 8
Introduction Product Overview Main Unit 4 5 2 3 5 6 2 7 4 . Lamp cover 5. Input/Output (IO) cover 2. Focus 6. Diagnostic Indicator LED 3. Projection Lens 7. Power Indicator LED 4. IR Receiver English 6 Introduction
Краткое содержание страницы № 9
Introduction Connection Ports 2 3 4 5 6 7 8 100V - 240V 50 Hz - 60 Hz 9 Audio In Audio In Audio 2 Audio 1 Audio Out Service Control 0 S-video Video Computer (VGA) 2 Computer (VGA) 1 VGA Out 6 5 4 3 2 1. Audio-L Connector (for S-V ideo Connector) 2. Audio-R Connector (for S-V ideo Connector) 3. Audio-L Connector (for Composite V ideo Connector) 4. Audio-R Connector (for Composite V ideo Connector) 5. Audio-2 Input Connector (for VGA2-In Connector) 6. Audio-1 Input Connector (
Краткое содержание страницы № 10
Introduction Remote Control Remote control transmitter 6 2 7 9 8 3 0 Vol. 4 5 Model No.:03-00131-20 Remote Control SBP-10X/SBP-20W Projector, UF55 Use the remote control to control these functions: . Input Select input source. 2. Menu Display menus. 3. Hide Press to hide or display the image. Select a display mode: Bright Classroom, Dark 4. Mode Classroom, sRGB or User. 5. Mute Turn off the sound temporarily. 6. Turn on the power or enter Idle Mode. Power 7. Enter Accept the selected mode.
Краткое содержание страницы № 11
M Introduction To change the remote control’s battery 1 When you use the 2 2 remote control for the first time, there is a plastic sheet between the battery and its contact. Remove the sheet before use. 3 Procedure . Remove the battery holder by holding down the side release firmly and pulling out the battery holder . 2. Insert a CR2025 coin cell battery. Be sure to align the plus and minus ends of the battery properly. 3. Replace the battery holder. Introduction 9 English
Краткое содержание страницы № 12
501H 00 zV - 6 - 0 24 H 0z V Audio In Audio In Audio 2 Audio 1 Audio Out Service Control 100V - 240V 50 Hz - 60 Hz Audio In Audio In Audio 2 Audio 1 Audio Out Service Control Installation Connecting the Projector Opening and Closing the Input and Output Cover 1 3 2 6 5 4 Cable management slot Procedure . Pull the cable cover forward and leftward to remove the cable cover from the slot. 2. Connect the power cord and the cable that you want to connect to the projector. 3. Collect all cab
Краткое содержание страницы № 13
Installation Turning On the Projector and Putting It into Idle Mode Turning On the Projector . Ensure that the power cord and video signal cable are The first time you securely connected. The Power LED is solid Amber. use the projector , you can select your 2. Turn on the lamp by pressing “ ” on the remote control. preferred language The Power LED turns green. from the main menu The startup screen displays in approximately 0 seconds. after the startup 3. Turn on your source. Select
Краткое содержание страницы № 14
Installation Adjusting the Projected Image Adjusting the Projector’s Focus T o focus the image, rotate the Focus Ring until the image is clear. Focus Ring English 2 Installation
Краткое содержание страницы № 15
User Controls On-Screen Display Menus The projector has multilingual On-Screen Display (OSD) menus that allow you to make image adjustments and change a variety of settings. Using the OSD Menus . T o open the OSD menu, press Menu on the remote control. 2 When the OSD displays, use the buttons to select an item in the main menu. Select an item and press the button to enter a submenu. 3. Use the buttons to select the desired item in the submenu and adjust the settings using t
Краткое содержание страницы № 16
User Controls Image Adjustment Display Mode There are four factory presets optimized for various types of images: Bright Classroom: This mode is recommended for projecting in a bright classroom. Dark Classroom: This mode is recommended for projecting in a dark classroom. sRGB: This mode provides standardized accurate color. User: This mode allows you to apply your own settings. Brightness To adjust the brightness of the image: Press on the remote control to darken image.
Краткое содержание страницы № 17
User Controls Image Adjustment Frequency Frequency , Change the display data frequency to match the frequency of your Tracking , computer ’ s graphic card. If a flickering vertical bar appears on your H-Position and screen, use this function to make an adjustment. V-Position functions Tracking are only supported under Analog VGA Synchronize the signal timing of the display with your computer’s (RGB) signal. graphics card. If the image appears to be unstable or flickers, use this f
Краткое содержание страницы № 18
User Controls Image Adjustment Saturation To adjust a video image from black and white to fully saturated color: Press on the remote control to decrease the amount of saturation in the image. Press on the remote control to increase the amount of saturation in the image. Saturation , Sharpness and Sharpness Tint functions are To adjust the sharpness of the image: available only when Press on the remote control to decrease the sharpness. the video source is connected. Pre
Краткое содержание страницы № 19
User Controls Image Adjustment White Peaking This adjustable item utilizes a new color-processing algorithm and system level enhancements to enable higher brightness while providing true, more vibrant colors in picture. The range is from “0” to “10”. If you prefer a more enhanced brightness, select a higher setting. For a smoother , more natural image, adjust toward the lower setting. Degamma Allows you to adjust the color performance of the display. Color A djust the Red, Green, Blue,
Краткое содержание страницы № 20
User Controls Audio Control V olume Press on the remote control to decrease the volume. Press on the remote control to increase the volume. Mute Select On to mute the sound. Select Off to turn off mute. Disable V olume Control Select On to disable the volume adjustment. Select Off to enable the volume adjustment. Closed Captioning Select On to turn on closed captions. Select Off to turn off the captioning feature. Closed Captioning Language Choose the clo
