Resumo do conteúdo contido na página número 1
Operating and Installation
Instructions
Gas Combiset
CS 1011
®
®
en-US
To prevent accidents and
appliance damage,
read these instructions
before
installation or use. M.-Nr. 07 366 200
Resumo do conteúdo contido na página número 2
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS Do not try to light any appliance. Do not touch any electrical switch. Do not use any phone in your building. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
Resumo do conteúdo contido na página número 3
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Guide to the combiset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Burner ..........................................................10 Before using the combiset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 4
IMPORTANT SAFETY INSTRUCTIONS Children WARNING- When using your gas Children should not be left appliance follow basic unattended in an area where the precautions, including the appliance is in use. Never allow following: children to sit or stand on any part of the appliance. This gas combiset conforms to all Caution: Do not store items of interest uniform safety codes and to children in cabinets above the regulations. appliance. Children climbing on the appliance to reach these items could Re
Resumo do conteúdo contido na página número 5
IMPORTANT SAFETY INSTRUCTIONS Technical safety Install the appliance so that the power cord and gas piping do not Installation, repair and maintenance come into contact with any portion of work should be performed by a Miele the combiset which may become hot authorized service technician. Work by during use. unqualified persons could be dangerous and may void the warranty. Do not use an extension cord to connect this appliance to electricity. Before installing the combiset, Extension cor
Resumo do conteúdo contido na página número 6
IMPORTANT SAFETY INSTRUCTIONS Before servicing, turn off the gas Safety valve and disconnect the power supply The appliance is hot during use and by either removing the fuse, unplugging remains so for some time after being the unit or manually “tripping” the switched off. Be careful not to touch the circuit breaker. appliance if it may still be hot. This equipment has not been Protect your hands with oven mitts designed for maritime use or for use in or potholders when using the mobile i
Resumo do conteúdo contido na página número 7
IMPORTANT SAFETY INSTRUCTIONS Do not use pans that extend past Always position pan handles and the burner grate. Using larger pans utensils inward so they do not extend may cause the flames to spread out over adjacent work areas, burner or the and damage the surrounding edge of the combiset. countertop or other countertop Do not store items on the appliance appliances. when not in use. Items could melt or For safety and stability, do not use catch fire from residual heat or if the pans w
Resumo do conteúdo contido na página número 8
IMPORTANT SAFETY INSTRUCTIONS Make certain that the power cords of small appliances do not come in contact with the appliance. The insulation of the cable could become damaged. Danger of electric shock! In the event of damage or defect, turn off the appliance immediately. Turn off the gas shut off valve and disconnect completely from the electrical supply. Contact the Miele Technical Service Department. Do not use the appliance until it has been repaired. Ensure power is not supplied to the
Resumo do conteúdo contido na página número 9
Guide to the combiset Wok burner Burner grate Control knob Display Indicators On/Off indicator "Residual Heat" indicator 9
Resumo do conteúdo contido na página número 10
Guide to the combiset Burner Small burner cap Large burner cap Burner ring Burner Ignition safety control (Thermocouple)
Ignitor Burner base 10
Resumo do conteúdo contido na página número 11
Before using the combiset Cleaning the combiset Metal components have a protective coating which may give off a slight odor Before using for the first time clean the the first time your new appliance is appliance as follows: heated. Remove any protective foil. The harmless odor will dissipate after a Wash the removable parts of the gas short time and does not indicate a burner in a mild solution of warm faulty connection or appliance defect. water and liquid dish soap. Dry and reassemble t
Resumo do conteúdo contido na página número 12
Use Fast-Ignition System The knob must only be turned left to The gas combisets are equipped with a turn the appliance on and right to Fast-Ignition-System which turn it off. incorporates the following features: – The control knob does not need to If the knob is : be pressed until the flame lights. - turned on without pressing it down first, – If the flame goes out because of a - turned clockwise to turn on, draft, for example, the burner is - used to turn the outside ring on automatically re-ig
Resumo do conteúdo contido na página número 13
Use Turning on Regulating the burners The inner and outer burners are both controlled by one control knob. There is a stop at the 6 o’clock position that requires you to press the knob down while turning it, in order to get from the high flame zone to the low flame zone. To turn on the burner, press the To reduce the flames from a high to control knob down to pass the low setting, turn the control knob resistance, then release the pressure counterclockwise until resistance is and turn it cou
Resumo do conteúdo contido na página número 14
Use On/Off indicator and Residual heat indicator When the combiset is turned on, the On/Off indicator lights up. Once a pre-set temperature has been reached, the residual heat indicator will also light up. The On/Off indicator goes out when the combiset is turned off. The residual heat indicator will remain on until the combiset is cool enough to touch. Do not touch or place any heat sensitive objects on the combiset while the residual heat indicator is on. Danger of damage or injury. If the dis
Resumo do conteúdo contido na página número 15
Cookware Pan size Suitable pans – Set the combiset to a high flame Unlike pans used on an electric when using a large diameter pan and combiset, the bases do not need to be low flame when using a small even for good results. diameter pan. Thick pan bases will give more even results, as hot spots are reduced due to better heat distribution. Thin pan bases will conduct the heat faster but not as evenly as thick pan bases. Stir the food frequently to – Generally, wide / shallow pans will prevent bu
Resumo do conteúdo contido na página número 16
Safety features Ignition safety control Safety cut-off This appliance is equipped with an If a zone has been on for an unusually Ignition Safety Control. This control cuts long period of time (approx. 4 hours), it the gas supply if the flame goes out will automatically shut off. and reignition is unsuccessful. To reignite the burner, turn the To reignite the burner, turn the control knob to “”, then switch the control knob to “”, then switch the burner on as usual. burner on as usual. 16
Resumo do conteúdo contido na página número 17
Cleaning and care Combiset Never use a steam cleaner to clean Let the appliance cool to a safe this combiset. Pressurized steam temperature before removing the could cause permanent damage to grates. the surface and to components. Clean the grates, combiset and Do not use any sharp or pointed knobs with a sponge and a mild objects which could damage the solution of warm water and liquid seal between the frame and the dish soap. countertop. Soak baked or hardened spills. Dry the combiset and
Resumo do conteúdo contido na página número 18
Cleaning and care Burner Reassembling the burner The burner can be dismantled and cleaned when cool. Remove the burner parts and wash them in a solution of hot water and liquid dish soap. Dry them thoroughly. Make sure that the flame holes are clean and completely dry. Wipe the burner base clean with a damp cloth and then dry. Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry. Make sure that no liquid gets into the appliance. Place the burn
Resumo do conteúdo contido na página número 19
Frequently asked questions Repairs should only be carries out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The burner does not ignite when the combiset is being used for the first time or after an extended period of not being used. Possible fault Solution There could be air in the gas pipe. You may need to make several attempts before the burner ignites successfully. The On/Off and residual hea
Resumo do conteúdo contido na página número 20
Frequently asked questions The burner does not ignite after several attempts. Possible fault Solution Disconnect the appliance from the electrical supply for a few seconds. If the problem persists, check if: – The burner is assembled incorrectly. – Reassemble the burner as shown in "Cleaning and Care - Burners". – The gas valve is closed. – Open the gas valve. – The burner is wet and soiled. – Clean the burners. See "Cleaning and Care". – The flame slits are dry and – Dry the igniters. unblocked
