Resumo do conteúdo contido na página número 1
ge.com
Safety Instructions . . . . . . . . . .2–5
Owner’s Manual &
Installation Instructions
Operating Instructions
Bridge Burner . . . . . . . . . . . . . . . .8
JP989
Cooktop Vent System . . . . . . . . . .8
Cookware Tips . . . . . . . . . . . . . . . .9
Dual Surface Unit . . . . . . . . . . . . .8
Features of Your Cooktop . . . . . . .6
Surface Units . . . . . . . . . . . . . . .7, 8
Temperature Limiter . . . . . . . . . . .8
Care and Cleaning
Control Knobs . . . . . . . . . . . . . . .10
Gla
Resumo do conteúdo contido na página número 2
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS WARNING – TO REDUCE THE RISK OF WARNING – TO REDUCE THE RISK OF A FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, COOKTOP GREASE FIRE: OBSERVE THE FOLLOWING: A. Never leave surface units unattended at high A. Use this unit only in the manner intended settings. Boilovers cause smoking and greasy by the manufacturer. If you have questions, spillovers that may ignite. Heat oils slowly on contact the manufacturer. low or
Resumo do conteúdo contido na página número 3
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support ge.com WARNING! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. SAFETY PRECAUTIONS When using electrical appliances, basic safety precautions should be followed, including the following: Be sure your appliance is properly installed Always keep wooden and
Resumo do conteúdo contido na página número 4
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! SAFETY PRECAUTIONS Do not let cooking grease or other Use little fat for effective shallow or deep- flammable materials accumulate on fat frying. Filling the pan too full of fat can the cooktop. cause spillovers when food is added. Do not touch surface units. These surfaces If a combination of oils or fats will be used may be hot enough to burn even though in frying, stir together before heating, or as they are d
Resumo do conteúdo contido na página número 5
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support ge.com RADIANT SURFACE UNITS Use care when touching the cooktop. The glass surface of the cooktop will retain heat after the controls have been turned off. Avoid scratching the glass cooktop. Clean the cooktop with caution. If a wet The cooktop can be scratched with items sponge or cloth is used to wipe spills on such as sharp instruments, rings or other a hot surface unit, be careful to avoi
Resumo do conteúdo contido na página número 6
Features of Your Cooktop. Throughout this manual, features and appearance may vary from your model. Feature Index (Features and appearance may vary) Left Rear Surface Unit Bridge Surface Unit Left Front Surface Unit Vent Grille Vent Filter (below the vent grille) Right Rear Surface Unit Dual Surface Unit Model and Serial Number Label (under the cooktop, on the right side of the vent chamber) Left Rear Surface Unit Control Left Front Surface Unit Control Left Side Hot Surface Indicator Lights (on
Resumo do conteúdo contido na página número 7
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Using the surface units. ge.com Radiant Surface Units The control for the radiant surface unit The surface unit ON indicator light will can be set anywhere between LO and HI glow when any surface unit is on. for an unlimited number of heat settings. NOTE: The surface unit ON indicator light With the infinite switch the coil cycles may glow between the surface control on and off to main
Resumo do conteúdo contido na página número 8
Using the surface units. Dual Surface Unit To use the small (6-inch) surface unit, The right front surface unit has 2 cooking sizes to select from so you can match the size of the unit turn the knob counterclockwise to to the size of the cookware you are using. and select the desired setting. The unit will only heat the area inside the smaller To use the large (9-inch) surface unit, circle. turn the knob clockwise to and select the desired setting. The unit will heat the entire area contained
Resumo do conteúdo contido na página número 9
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Selecting types of cookware. ge.com The following information will help you choose cookware which will give good performance on glass cooktops. Stainless Steel: Glass-Ceramic: recommended usable, but not recommended Poor performance. May scratch the surface. Aluminum: heavy weight recommended Stoneware: Good conductivity. Aluminum residues sometimes appear as scratches on the usable, but not re
Resumo do conteúdo contido na página número 10
Care and cleaning of the cooktop. Be sure electrical power is off and all surfaces are cool before cleaning any part of the cooktop. Vent System Do not use abrasive cleaners. They will Before cleaning the vent grille, be sure the exhaust blower is turned off. damage the vent grille’s finish. Do not clean the vent grille in the To clean the vent grille, remove it from the cooktop by lifting it up and off. dishwasher. Wipe with a damp cloth. If necessary, the vent grille can be washed in the sink
Resumo do conteúdo contido na página número 11
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Cleaning the glass cooktop. ge.com Normal Daily Use Cleaning ® ONLY use CERAMA BRYTE Ceramic Shake the cleaning cream well. Cooktop Cleaner on the glass cooktop. Apply a few drops of CERAMA ® Other creams may not be as effective. BRYTE Ceramic Cooktop Cleaner directly to the cooktop. To maintain and protect the surface of your glass cooktop, follow these steps: Use a paper towel or CERAMA ® BRYTE C
Resumo do conteúdo contido na página número 12
Cleaning the glass cooktop. Metal Marks and Scratches Be careful not to slide pots and This should be removed immediately pans across your cooktop. It will before heating again or the leave metal markings on the discoloration may be permanent. cooktop surface. WARNING: Carefully check the bottom These marks are removable using of pans for roughness that would scratch ® the cooktop. the CERAMA BRYTE Ceramic Cooktop Cleaner with the ® CERAMA BRYTE Cleaning Pad for Ceramic Cooktops. If pots with
Resumo do conteúdo contido na página número 13
Installation Radiant Instructions Downdraft Cooktop If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at: ge.com IMPORTANT SAFETY BEFORE YOU BEGIN INSTRUCTIONS Read these instructions completely and carefully. WARNING TO REDUCE THE RISK – OF FIRE, ELECTRIC SHOCK OR INJURY TO • IMPORTANT Save these – PERSONS, OBSERVE THE FOLLOWING: instructions for local inspector’s use. A Installation work and electrical wiring • IMPORTANT Observe all must be done by qualified person(s
Resumo do conteúdo contido na página número 14
Installation Instructions UNPACKING YOUR COOKTOP PARTS INCLUDED (PACKED BELOW THE COOKTOP) • Blower assembly • (9) Sheet metal screws • Cleaning cream (8-18 x 3/8″) • Blower plenum • Scrub sponge or scraper • Foam gasket tape (9 ft. roll) (on some models) • (4) Nuts (10-32 keps – nuts with lock washers attached) • Vent grille • (2) Hold-down retainers and • Vent filter thumb screws Sheet Metal Screws (9) Hold-Down Retainers Vent Grille (8-18 x 3/8″) and Thumb Screws CAUTION: DO NOT LIFT FROM
Resumo do conteúdo contido na página número 15
Installation Instructions PREPARATION TOOLS AND MATERIALS ELECTRICAL REQUIREMENTS YOU WILL NEED This appliance must be supplied with the proper voltage and frequency, as listed in these Installation • Saw Instructions, and connected to an individual, • Flat blade screwdriver properly grounded branch circuit, protected • Electrician’s pliers by a 40-amp circuit breaker or time delay fuses. • Duct tape All wire connections must be made in accordance with local codes and properly insulated. Check
Resumo do conteúdo contido na página número 16
Installation Instructions CABINET PREPARATION 2 1 PREPARING FOR INSTALLATION PREPARING THE BASE CABINET This cooktop is designed to fit easily into a variety Positioning the cooktop of cabinets. However, some cabinets may require The cooktop is designed to look best when centered modifications. in a cabinet at least 30″ wide. Preparing a cabinet that is against a wall The exhaust vent beneath the cooktop must be In some cabinets, the sides may need to be scooped located between wall studs or fl
Resumo do conteúdo contido na página número 17
Installation Instructions CABINET PREPARATION CUTOUTS 4 5 PREPARING THE COUNTERTOP PREPARING FOR DUCTWORK The countertop must have a deep flat surface NOTE: Ductwork MUST be vented to outside. DO to accommodate the cooktop and the vent. NOT vent into a wall, ceiling, crawlspace, attic or any Countertops with a rolled front edge and concealed space. backsplash may not provide the flat surface Cut hole in cabinet wall or floor as appropriate for area required. your installation. Make sure exhaust
Resumo do conteúdo contido na página número 18
Installation Instructions DUCTWORK CALCULATIONS Equivalent Number Equivalent Duct Pieces Length* x Used = Length Calculate Total Equivalent Ductwork Length 5″ round Equivalent Number Equivalent 1 to 3 ⁄4″ x 10″ Duct Pieces Length* x Used = Length transition 90° elbow 37 ft. x ( ) = ft. 5″ round † 6″ round straight 2.7 ft. x ( ft.) = ft. 1 to 3 ⁄4″ x 10″ 6″ round transition † straight 1 ft. x ( ft.) = ft. 90° elbow 4 ft. x ( ) = ft. 1 1 3 ⁄4″ x 10″ 3 ⁄4″ x 10″ † to 6″ round straight 1 ft.
Resumo do conteúdo contido na página número 19
Installation Instructions EXHAUST BLOWER RATINGS EXHAUST BLOWER SAFETY WARNING Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of other fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and local code authoriti
Resumo do conteúdo contido na página número 20
Installation Instructions DUCTWORK INSTALLATION (Note: For planning purposes only.) 7 INSTALLING THE DUCTWORK OPTIONAL INSTALLATION: REAR WALL VENTING Use galvanized or aluminum duct in 6″ round 1 or 3 ⁄4″ x 10″ size, or a combination of both. 5″ round duct may be used on SHORT DUCT runs but best results will be obtained using PVC duct should be used if installing under a 1 3 ⁄4″ x 10″ or 6″ round ducting. poured concrete slab. NOTE: Local building code must be followed in specifying approved t
