Resumo do conteúdo contido na página número 1
2460 D/2490 D
Dunstabzugshaube
Afzuigkap
Hotte aspirante
Cooker Hood
Montage- und Gebrauchsanweisung
Installatie- en gebruiksaanwijzing
Manuel de montage et d’utilisation
Operating and Installation Instructions
Resumo do conteúdo contido na página número 2
Contents Safety warnings 49 for user 49 for kitchen unit installer 49 Introduction 51 Extractor version 51 Filter Version 51 Bedienung der Dunsthaube 52 Maintenance and care 53 Metal grease filter 53 Open the metal grease filter 53 Carbon filter 54 Changing the light bulb 55 Cleaning 56 Special accessories 56 Technical assistance service 56 Guarantee conditions 57 Technic Details 59 Mounting accessories included 59 Electrical connection 60 Safety warnings for the electrician 60 Wall unit mountin
Resumo do conteúdo contido na página número 3
Safety warnings for user Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control. The hot oil in the frying pan might ignite due to overheating. The risk of self-ignition increases when the oil being used is dirty. It is extremely important to note that overheating can cause a fire.
Resumo do conteúdo contido na página número 4
It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities. When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole. National and regional building regulations impose a number of
Resumo do conteúdo contido na página número 5
Introduction Extractor version The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one activated carbon filter (special accessory). You will need original AEG carbon filter for this function (see Special Accessories). The air is discharged to the outside through a pipe, which must be fitted to connection flange A. Fig. 1. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Should there already b
Resumo do conteúdo contido na página número 6
Fig. 2 Bedienung der Dunsthaube The hood is fitted with one motor having several speed. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. The control switches are located on the unit’s front panel: a- Indicator lamp b- Light ON/OFF switch c- Motor OFF - Speed 1 push-button d- Speed 2 push-button e- Speed 3 push-button 52
Resumo do conteúdo contido na página número 7
Maintenance and care The hood must always be disconnected from the mains power supply before beginning any maintenance work. Metal grease filter The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Open the metal grease filter First, push the
Resumo do conteúdo contido na página número 8
Carbon filter The carbon filter should only be used if you want to use the hood in its filtering function. To do this you will need an original AEG activated carbon filter (see special accessories). Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest tempera-
Resumo do conteúdo contido na página número 9
Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a
Resumo do conteúdo contido na página número 10
Cleaning Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will
Resumo do conteúdo contido na página número 11
Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not cover commercial use. 2. The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials. The guarantee does not cover appliances where
Resumo do conteúdo contido na página número 12
Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Senlis +33 (0) 44 62 29 29 Germany Nürnberg +49 (0) 911 323 2600 Italy Pordenone +39 (0) 1678 47053 Sweden Stockholm +46 (0) 8 738 7910 UK Slough +44 (0) 1753 219899 58
Resumo do conteúdo contido na página número 13
Technic Details Models 2490 D 2460 D Dimensions - extractor ver (in cm): Height 68-113 68-113 Width 89,8 59,8 Depht 45 45 Dimensions - filter version (in cm): Height 67,5-122,5 67,5-122,5 Width 89,8 59,8 Depht 45 45 Maximum absorbed power: 195 W 195 W Motor absorption: 1 x 155 W 1 x 155 W Lighting: 2 x 20W 2 x 20W Lenght of the cable: 140 cm 140 cm Mounting accessories included 6 wall plugs Ø 8 mm 6 wood-screws 5 x 45 mm 6 metal screws 2,9 x 6,5 8 metal screws 3 x 10 1 deflector 1 chimney suppo
Resumo do conteúdo contido na página número 14
Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector
Resumo do conteúdo contido na página número 15
Wall unit mounting - Fig. 6 Only for extractor version: position the upper section of the chimney so that the oulet slots H are not visible (see also A-B-C sequence on on Fig. 6). Fix each other both parts of the hood (1), make all connections between the two parts (2) and fix with 6 screws (3). Sign the wall with a center line, this will aid mounting procedure (4), position the template so that the mid line printed on the template matches with the center line previously signed, the lower
Resumo do conteúdo contido na página número 16
A-B-C, Extractor version only!
Fig. 6 62
Resumo do conteúdo contido na página número 17
Resumo do conteúdo contido na página número 18
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1LNC Ed. 09/01
