Manual do usuário PYLE Audio View Series PLVWR7800

Resumo do conteúdo contido na página número 1

PLVWR7800
OWNER’S MANUAL
FLIP DOWN TFT MONITOR

Resumo do conteúdo contido na página número 2

INSTALLATION Desk-top Installation Mounting Bolts (M3x6) 2 1 Tapping Screw (M4x10) Bracket Levers Fig. 1 1. Determine the mounting location and drill four mounting holes. 2. Attach the bracket to the holes with the tapping screws (M4x10). 3. Let the two levers aim at the fixing holes on the bottom of the base to fix the display unit. 4. Attach the TV unit to the preferred location with the mounting bolts (M3x6). 5. For the convenience of fixing the unit, you can turn the display left or right to

Resumo do conteúdo contido na página número 3

INSTALLATION Ceiling-on Installation Bracket Levers Tapping Screws (M4x10) Fixing holes Mounting Bolts (M3x6) Fig. 2 1. Determine the mounting location and drill four mounting holes. 2. Attach the bracket to the holes with the tapping screws (M4x10). 3. Let the two levers aim at the fixing holes to fix the display unit. 4. Attach the unit to the bracket with the mounting bolts (M3x6). 5. When the installation has completed, you can also turn the display upward or downward, left or right to adju

Resumo do conteúdo contido na página número 4

REPLACING THE CAR DOME LAMP Follow the directions show below for a new lamp changing. 1. Position light switch to “ ”. 2. Push back the lamp cover and open it. (Refer to the following figure) 3. Remove and discard the old lamp. 4. Install a new bulb. 5. Close the cover. Lamp Cover Bulb Light Switch Bulb Specification Diameter: ø8mm Length: 28mm Voltage Spec.: DC12V, 5W CAR DOME LAMP WIRING Line for Car Dome Lamp Note: Color Connection Red Power Supply White Interior Lig

Resumo do conteúdo contido na página número 5

CONTROL & FUNCTION KEYS 1 2 4 5 6 7 8 9 3 11 11 12 12 13 14 18 15 16 19 17 5

Resumo do conteúdo contido na página número 6

CONTROL & FUNCTION KEYS 10 7 INCH TFT COLOR MONITOR 6

Resumo do conteúdo contido na página número 7

MONITOR 1. (=POWER) Press button (1) to turn on the unit. Press it again to turn it off. 2. POWER INDICATOR LIGHT When the system is on, the indicator light (2) will be illuminated. 3. CAR DOME LAMP The car dome lamp (3) will be on in some needed situations. 4. LIGHT SWITCH The are three seetings for the car dome lamp operation: (OFF), (AUTO), and (ON), refer to light switch (4). A. : To turn off the lamp. B. : To make the lamp turned on only when car doors are opened. C. :

Resumo do conteúdo contido na página número 8

13. PUSH (Monitor Release Button) Opening the Monitor Press the PUSH button (13) to eject the screen display from the base at a little angle. Then you can easily turn the display upward or downward for good viewing. The monitor also can be adjusted through 30 degree both left and right from the central viewing position Closing the Monitor Return the monitor to the central viewing position. Then push the monitor back into the monitor base unit until the screen engages with PUSH button (13) .