Resumo do conteúdo contido na página número 1
Resumo do conteúdo contido na página número 2
Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference. Contents Packing list ---------------------------------------------------- 1 Precautions ---------------------------------------------------- 2 Installation Instructions ------------------------------------- 3 3 Swivel Base -------------------------------------------------- Power cord -------------------------------------------------- 3 4 Video cable -
Resumo do conteúdo contido na página número 3
PRECAUTIONS Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor. If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit i
Resumo do conteúdo contido na página número 4
INSTALLATION INSTRUCTIONS Swivel Base To attach the swivel base to the monitor, do the following: • Carefully turn the monitor on its side or upside down. ( see figure 1 ) • Locate the cavities at the bottom front of the monitor. • Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place. • To remove the swivel base, hold the bottom of the swivel base, then push it out. Install Remove
Resumo do conteúdo contido na página número 5
Video cable Connecting the Video Cable: The monitor comes with a built-in video cable. Plug the signal cable's 15-pin connector into the computer's video port and tighten the two screws on the cable connector. Caution:Don’t bend the signal cable, otherwise it will break the inner wire. Connecting the Power Cord: Plug the power cord into the monitor's AC power socket. Then plug the power cord into a grounded AC outlet or UL- approved power strip or the power output socket on your PC.
Resumo do conteúdo contido na página número 6
OPERATING INSTRUCTIONS General Instructions The power switch is located at front panel of the monitor. Press the power switch to turn the monitor on or off. The other control knobs are located at the base of the monitor (See Figure 3). By changing these settings, the picture can be adjusted to your personal preferences. • The power cord should be connected. • Connect the video cable from the monitor to the video card. • To turn the monitor on, press the POWER switch to ON position.
Resumo do conteúdo contido na página número 7
Front Panel Control • Power Switch: Press this knob to switch ON/OFF of monitor’s power. • MENU: Active OSD menu or function adjust confirm. • Contrast / : Adiust contrast or function adjust. • Brightness / : Adjust brightness or function adjust. • EXIT: Press the EXIT key to inactive OSD menu. • Power Indicator: Green — Power On mode. Orange — Off mode. How to adjust a setting The monitor controls are accessed by pressing button MENU to enable OSD (On-S
Resumo do conteúdo contido na página número 8
Adjusting the picture The description for functional control icons 1. CONTRAST : Adjust the picture contrast. 2. BRIGHTNESS : Adjust the picture brightness. 3. H-CENTER : Adjust the horizontal position of the picture. 4. H-SIZE : Adjust the picture’s horizontal size. 5. V-CENTER : Adjust the vertical position of the picture. 6. V-SIZE : Adjust the picture’s vertical size. 7. ZOOM : Adjust the picture’s horizontal and vertical size simultane
Resumo do conteúdo contido na página número 9
14. USER COLOR ( Red / Blue ) : If the 9300°K normal white or 6500°K warmer white do not satisfy your desire, properly adjust R . B GAIN controls to obtain your optimum whiteness level. 15. DEGAUSS : If color impurity occurs when moving or swiveling the monitor, press MENU Key and degauss to fix the picture condition. 16. MOIRE REDUCE : Moire is the result of interference between the phosphor layout and the video signal. In some cases, you may find the moire very notice
Resumo do conteúdo contido na página número 10
THIS MONITOR WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN ORDER FOR THIS MONITOR TO OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL. This monitor meets the Power Management standards as set by the Video Electronics Standards Association (VESA) and/or the United States Environmental Protection Agency (EPA) and The Swedish Confederation Employees ( NUTEK ). This feature is designed to conserve electrical energy by reducing power consumption when there i
Resumo do conteúdo contido na página número 11
TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord should be connected No Plug & Play *Check if the PC system is Plug & Play compatible *Check if the Video Card is Plug & Play compatible *Check if the D-15 plug pin of Video Cable is bent *Make sure the Monitor Drivers are installed Picture is fuzzy *Adjust the Contrast and Brightness Controls. Picture bounces or a wave *Move electrica
Resumo do conteúdo contido na página número 12
APPENDIX A - SPECIFICATIONS CRT 38cm(15"), 90º deflection, 29mm neck, 0.28mm dot pitch non-glare screen. Viewable Image Size 35.6cm (14"), diagonal Display Color • Analog input Unlimited colors Input Signal All timing that meets scanning frequencies Specification • Video • Analog R, G, B 0.7Vpp positive/75 ohm • Sync. • Horizontal sync. : Positive/Negative • Vertical sync. : Positive/Negative Synchronization • Horizontal 30kHz to 54kHz automatically • Vertical 50Hz to 1
Resumo do conteúdo contido na página número 13
Functions ( OSD ) • CONTRAST • BRIGHTNESS • H-CENTER • H-SIZE • V-CENTER • V-SIZE • ZOOM • PINCUSHION • TRAPEZOID • PIN-BALANCE • PARALLELOGRAM • ROTATION • 6500°K • USER COLOR • 9300°K • DEGAUSS • MOIRE REDUCE • RECALL • EXIT • SELECT LANGUAGE Plug & Play DDC1/2B EPA ENERGY On mode ≤ 75W ® STAR Off mode ≤ 8W Power consumption 75W Max. Preset display area 270mm × 202mm Regulations UL, CSA, CB report, SEMKO, TUV-S,
Resumo do conteúdo contido na página número 14
APPENDIX B - FACTORY PRESET TIMING TABLE HORIZONTAL VERTICAL STANDARD RESOLUTION FREQUENCY FREQUENCY IBM 720×400 31.5kHz 70Hz VGA 640×480 31.5kHz 60Hz VESA/85 640×480 37.5kHz 75Hz VESA/85 800×600 46.9kHz 75Hz VESA/85 800×600 53.6kHz 85Hz VESA/60 1024×768 48.4kHz 60Hz 13
Resumo do conteúdo contido na página número 15
Your International Guarantee Dear Customer, Thank you for purchasing this Philips product which has been designed and manufactured to the highest quality standards. If, unfortunately, something should go wrong with this product Philips guarantees free of charge labor and replacement parts irrespective of the country where it is repaired during a period of 12 months from date of purchase. This international Philips guarantee complements the existing national guarantee obligations to yo
Resumo do conteúdo contido na página número 16
Avant d'utiliser le moniteur veuillez lire complètement le manuel. Gardez ce manuel pour pouvoir le consulter ultérieurement. Sommaire Liste du matériel ----------------------------------------------- 1 Précautions ------------------------------------------------------ 2 Instructions d'Installation ------------------------------------ 3 Base Tournante --------------------------------------------- 3 3 Fil d'Alimentation ----------------------------------------- Câble Vidé
Resumo do conteúdo contido na página número 17
PRÉCAUTIONS N'utilisez pas le moniteur à proximité d'une source d'eau, e.g. près d'une baignoire, d'un lavabo, d'un évier, d'un bac à linge, d'une piscine ou dans un sous-sol humide. Ne placez pas le moniteur sur un chariot, un support ou une table instables. Si le moniteur venait à tomber il pourrait blesser une personne et risquerait d'être sérieusement endommagé. Utilisez uniquement un chariot ou un support recommandé par le fabricant ou vendu avec le moniteur. Si vous montez le mon
Resumo do conteúdo contido na página número 18
INSTRUCTIONS D'INSTALLATION Base Pivotante Pour fixer la base pivotante au moniteur, procédez comme suit : • Posez avec précaution le moniteur sur un de ses côtés ou mettez-le à l'envers. ( Voir figure 1 ) • Repérer les cavités situées au bas de la face avant du moniteur. • Insérez les chevilles situées sur la base pivotante dans ces cavités. Poussez la base pivotante vers l'avant jusqu'à ce que la base pivotante arrive en buté. • Pour retirer la base pivotante, maintenez le fond
Resumo do conteúdo contido na página número 19
Câble Vidéo Branchement du câble vidéo: Le moniteur est muni d’un câble vidéo intégré. Branchez le connecteur à 15 broches du câble au port vidéo du PC et fixez la fiche en serrant ses deux vis. Attention: Ne pas plier le câble des signaux, car ceci peut endommager le câble intérieur de celui. Branchement du câble électrique: Branchez le câble électrique à la prise de courant du moniteur. Ensuite, branchez le câble électrique à une prise de courant du réseau électrique et mise
Resumo do conteúdo contido na página número 20
INSTRUCTIONS D'UTILISATION Instructions Générales Les autres boutons de contrôle sont situés sur la base de votre moniteur (Voir Figure 3). En changeant ces paramètres, vous pouvez ajuster l'image comme vous le souhaitez. • Le fil d'alimentation doit être branché. • Connectez le câble vidéo depuis le moniteur à la carte vidéo. • Pour allumer le moniteur, mettez le bouton de MISE SOUS TENSION sur la position ON. Le témoin de mise sous tension va s'allumer. • Votre moniteur possède un sys
