Manual do usuário Innovative Ideas Limited LCD Monitor Arm 9103

Resumo do conteúdo contido na página número 1

LCD Monitor Arm Step 2 Attaching the Tilter to the Adapter Bracket
NOTE: If the bracket does not line up with the hole
Model No. 9103
pattern on the back of your monitor, please
Carefully remove the base from the flat panel monitor. For removal
contact our customer service department.
instructions, see your Flat Panel User’s Guide.
INSTRUCTIONS
Slide the titler shaft into the hole in the end of the forearm, as
If the adapter bracket is already attached to the tilt mechanism, shown in Illustr

Resumo do conteúdo contido na página número 2

Step 2 Setting the Counter-balance Use the 1/4” allen wrench (provided), insert into the hole on the top of the endcap with shaft; with one hand, hold the arm in a horizontal position, while turning the allen wrench with the other hand to set the weight adjustment. See Illustration 5 below. Using the allen wrench in a horizontal position allows extra leverage while adjusting. (1) Forearm (2) Pivot Point To increase the weight for heavier monitors, turn (3) Mount Base the wrench left (counter-c