Resumo do conteúdo contido na página número 1
SY-6VBA 133
Motherboard
Quick Start Guide
C
The SOYO CD Quick BIOS Hardware Introduction
Setup Installation
RECYCLED PAPER 100%
POST CONSUMER
FOR HOME OR OFFICE USE
With FCC Standards FC
Tested To Comply
Resumo do conteúdo contido na página número 2
SOYO ™ SY-6VBA 133 Motherboard ® ® m m * These specifications are subject to change without notice 2 6VBA 133 Serial - Version 1.2 - Edition: September 1999 "http://www.soyo.com.tw". on the Internet. The address is Web Site If you need any further information, please visit our document is subject to change without notice. however, no guarantee is given as to the correctness of the contents. The information in this installing the Motherboard. Information in this guide has been carefully checked
Resumo do conteúdo contido na página número 3
1 Introduction 1 Congratulations on your purchase of the SY-6VBA 133 Motherboard. This Quick Start Guide describes the steps for installing and setting up your new Motherboard. This guide is designed for all users to provide the basic steps of Motherboard setting and operation. For further information, please refer to SY-6VBA 133 Motherboard User's Guide and Technical Reference online manual included on the CD-ROM packed with your Motherboard. Unpacking When unpacking the Motherboard, check for
Resumo do conteúdo contido na página número 4
SY-6VBA 133 Motherboard Layout PS/2 KB PS/2 Mouse Connector Connector 0 JP8 LED1 13 11 1 USB 1 USB 2 2 N ® 3 4 PRT COM 1 FDC 11 COM 2 ® a ATX 82C693A Power JP9 11 AGP Slot 21 1 3V ITE 8671 Lithium t Battery JP5 1 5 2 JP2 IR1 13 13 r r S JP44 3 O WOL I B Header ® a h 3 s 82C596B a l4 1 F _ HDD _ LED + Speaker 5 Turbo _ LED ++ JP7 1 Winbond PWRBT W83782M Keylock _ Power CA828 Reset LED 2 e + 1 g N Key Features ® Ø Supports Intel Pentium III processor (450- Ø Supports onboard hardware monitorin
Resumo do conteúdo contido na página número 5
2 Installation 2 To avoid damage to your Motherboard, follow these simple rules while handling this equipment: l Before handling the Motherboard, ground yourself by grasping an unpainted portion of the system's metal chassis. l Remove the Motherboard from its anti-static packaging. Hold it by the edges and avoid touching its components. l Check the Motherboard for damage. If any chip appears loose, press carefully to seat it firmly in its socket. Follow the directions in this section designed to
Resumo do conteúdo contido na página número 6
Install the Motherboard Follow the steps below in order to perform the installation of your new SY-6VBA 133 Motherboard. Install the CPU Record the working frequency of your CPU that should be clearly marked on the CPU cover. FSB 66MHz FSB 100MHz FSB 133MHz To mount the processor that you have purchased separately, follow these instructions. 6 Hardware Installation and remove the CPU. for use. retention module down your CPU is ready two slides on the inward. Now press the outward. Now on
Resumo do conteúdo contido na página número 7
Note: Installing a heat sink and cooling fan on top of your CPU is necessary for proper heat dissipation. Failing to install these items may result in overheating and possible burn-out of your CPU. Make Connections to the Motherboard This section tells how to connect internal peripherals and power supply to the Motherboard. Internal peripherals include IDE devices (HDD, CD-ROM), Floppy Disk Drive, Chassis Fan, Front Panel Devices (Turbo LED, Internal Speaker, Reset Button, IDE LED, and KeyLock
Resumo do conteúdo contido na página número 8
Configure Memory Your board comes with four DIMM sockets, providing support for up to 1.5GB of main memory using unbuffered and registered DIMM modules from 8MB to 256/512MB. On this motherboard, DRAM speed can be set independent from the CPU front side bus speed. Depending on the DRAM clock speed setting in the BIOS setup (Chapter 3), appropriate memory modules must be used. For 66MHz DRAM speed, use PC66 memory; for 100MHz DRAM speed, use PC100 memory; for 133MHz DRAM speed, use PC133 memory.
Resumo do conteúdo contido na página número 9
Refer to the following table: PII, Celeron PII,PIII PIII JP9 JP8 tell CPU its 133/100# 100/66# FSB Speed 66MHz FSB 100MHz FSB 133MHz FSB *Possible higher Short Short FSB = 66MHz Normal setting multiplier setting 1 2 1 2 Short Open Normal setting FSB = 100MHz 1 2 1 2 Normal Open Open FSB = 133MHz setting 1 2 1 2 * This setting will tell CPU that it is running on 66MHz; this will release more multiplier settings on some Intel CPUs, but it will make the system operate out of its specifications if t
Resumo do conteúdo contido na página número 10
Set the CPU Frequency You do not need to set any jumper for the CPU frequency. Instead, CPU settings are changed through the BIOS [SOYO COMBO SETUP]. Please refer to Chapter 3 - Quick BIOS Setup for details on how to set the Slot 1 processor frequency. External Suspend Button (JP1) Some cases come with a suspend button, insert the plug into JP1. In addition to this button, the system can also enter the suspend mode through your OS. Note: Suspend mode only functions if your Power Management mod
Resumo do conteúdo contido na página número 11
Clear CMOS Data (JP5) Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily identified by its white colored cap. 1 2 3 1 2 3 The SY-6VBA 133 provides over-clocking capability. Due to the over-clocking setting your system may fail to boot up or hang during run time. Please perform the following steps to recover your system from the abnormal situation : 1.Turn off system power (If
Resumo do conteúdo contido na página número 12
3 Quick BIOS Setup 3 This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead, CPU settings are software configurable with the BIOS [SOYO COMBO SETUP]. The [SOYO COMBO SETUP] menu combines the main parameters that you need to configure, all in one menu, for a quick setup in BIOS. After the hardware installation is complete, turn the power switch on, then press the key during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS SETUP UTILI
Resumo do conteúdo contido na página número 13
If you set this field to [Manual], you are then required to fill in the next two consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Ratio. (1) CPU Host/PCI Clock CPU Host / PCI Clock Under this item you find the o66/33 o95/31 o115/38 o124/41 o140/35 frequencies your PCI slots run at. o75/37 o100/33 o117/39 o126/31 o142/35 o78/39 o105/35 o118/39 o133/33 o144/36 o81/40 o110/36 o120/40 o135/33 o150/37 o83/41 o112/37 o122/37 o137/34 o155/38 o90/30 o113/37 o124/31 o138/34 (2) CPU Ratio A
Resumo do conteúdo contido na página número 14
(4) AGP Clock The AGP clock is derived from the CPU FSB frequency. It is divided by 1.0, 1.5 or 2.0 depending on the setting of JP2 and JP7: Please refer to page 9 for the JP2 and JP7 settings. (5) Vcore Voltage Adjust The CPU notifies the board of what core voltage it requires by its VID outputs. The on-board voltage regulator uses the VID code to set the core voltage. If the Vcore Voltage Adjust is set to normal, the Vcore will be exactly what the VID code specifies. If an adjustment percentag
Resumo do conteúdo contido na página número 15
4 The SOYO CD 4 The SOYO-CD will NOT autorun if you use it on an Operating System other than Windows 9x or NT. Your SY-6VBA 133 Motherboard comes with a CD-ROM labeled "SOYO CD." The SOYO CD contains the user's manual file for your new Motherboard, the drivers software available for installation, and a database in HTML format with information on SOYO Motherboards and other products. Insert the SOYO CD into the CD-ROM drive The SOYO CD will auto-run, and the SOYO CD Start Up Menu will display as
Resumo do conteúdo contido na página número 16
Please note that if the Start Up program was unable to determine which SOYO Motherboard you own, the manual selection menu will pop up, as shown below. Then select the user's manual file that corresponds to your Motherboard model name and click OK. SOYO CD Manuals Please select your manual in the box below and click OK. 686 boards: 586 boards: 6VBA 13 3 O K Back (Manual Selection Menu) The user's manual files included on the SOYO CD can be read in PDF (Postscript Document) format. In order to r
Resumo do conteúdo contido na página número 17
Ø After installation of windows, you will need to install the VIA drivers. Follow the instructions below. Click the Install drivers button to display the list of drivers that can be installed on your Motherboard. The start-up program displays the drivers available for the 6VBA 133. n t . VIA 4 in 1 driver package 6VBA 133 Winbond hardware doctor for win 95/98 s Cancel D (Driver Installation Menu) However, to display the list of all drivers software available with SOYO Motherboards, click th
Resumo do conteúdo contido na página número 18
This driver will make the necessary changes to the Windows registry, in order to make sure that Windows has no problems recognizing your VIA chipset. ─ IRQ remapping utility (This driver is installed automatically) This utility will remap the IRQ lines to make sure that everything functions properly under Windows. Ø Your motherboard comes with a hardware monitoring IC. By installing this utility Temperature, Fan speed and Voltages can be monitored. It is also possible to set alarms when current
Resumo do conteúdo contido na página número 19
Note: If no HTML browser is installed on your system, the Start Up program will prompt you on whether or not you would like to install the Internet Explorer* browser. Click YES to install the HTML browser. After the installation is complete, please restart your system. Then re-run the SOYO CD and you will be able to browse the SOYO HTML database. (* Internet Explorer is a Microsoft Trademark) 19 The SOYO CD Quick Start Guide SY-6VBA 133
Resumo do conteúdo contido na página número 20
n n . , : a s u : : 20 : support@soyo.nl ail Em )181 569 4134 Fax: +44 (0 Fax: +31-79-3637575 Tel : +44 (0)181 569 4111 Tel : +31-79-3637500 Technical Support: Technical Support: sales@soyo.co.uk E-mail: : sales@soyo.nl ail Em )181 569 4134 Fax: +44 (0 Fax: +31-79-3637575 Tel : +44 (0)181 569 4111 Tel: +31-69-3637500 Sales Sales www.soyo.co.uk Web Site: europe.com and Republic of Ireland www.soyo- , www.soyo.nl Web Site: Covered: United Kingdom Region Switserland Germany, Austria and Ho
