Manual do usuário Multi-Link Acp-300 ACP-300

Resumo do conteúdo contido na página número 1

(ACP-300, ACP-500 & ACP-900)

Programming Manual

Toll Free Sales and Tech Support 866.337.0965
International Sales and Tech Support 217.337.0965

techsupport@faxswitch.com | www.faxswitch.com
______________________________________________________
The ACP can be easily tailored to fit the needs of individual organizations or
departments.

A wide variety of remote site information systems can be accessed, and with its
register programs, the system functions can be configured to m

Resumo do conteúdo contido na página número 2

In the absence of Fax tones or security codes, the ACP begins to ring the call through to its default port (Device 1). Outgoing calls can be placed from any device port as if it were attached to a dedicated line. Only one device at a time can actively use the telephone line. When the line is in use by one device, other devices attempting to access the line for an outgoing call will receive a busy signal. With special programming, this feature can be overridden in an emergency situatio

Resumo do conteúdo contido na página número 3

Flag 6 (Bit 2) Busy Signal 1 (on) Determines if a device trying to access the line when the line is already in use will hear a busy tone or dead air. Flag 7 (Bit 1) Enable Multi-Port Polling 0 (off) Allows transfer to another device when communication with the first device addressed is complete. Flag 8 (Bit 0) Night Watch Mode to Device 3 0 (off) Determines if night watch transfers are transferred to device 3. (Default night watch port is device 2) The operation modes (Flags) ca

Resumo do conteúdo contido na página número 4

When programming this register, you must enter all Flag (Bit) values. The flags are preset to the following: Flag 1 (Bit 3) Device 4 Barge-in Mask 0 (off) Flag 2 (Bit 2) Device 3 Barge-in Mask 0 (off) Flag 3 (Bit 1) Device 2 Barge-in Mask 0 (off) Flag 4 (Bit 0) Device 1 Barge-in Mask 0 (off) Register 8 must also be set to a positive number to activate barge-in. REGISTER 08 - Barge-In Time This register contains the amount of time that a telephone receiver must be held off-hook to "ba

Resumo do conteúdo contido na página número 5

REGISTER 15 Security Access Code for Device Port 5 Contains the security access code for device port 5. This register holds up to 7 digits ranging from 0 to 9, * and #. Factory preset to 55. REGISTER 16 - Multiple Polling Code This register contains the multiple polling code (MPC). The MPC should be placed at the beginning or end of a security access code. After a device has completed its communication and if the correct MPC is detected, the ACP will seize the line. This process allows

Resumo do conteúdo contido na página número 6

TO READ VALUES FROM MEMORY To read all values, press 99 on your telephone key pad. To read the value of a single register, press * and the two-digit register number. TO WRITE PROGRAMS TO MEMORY Press 80 on your telephone key pad. This should always be done when you are satisfied with the information you have programmed. TO EXIT PROGRAMMING MODE Press 90 on your telephone key pad. IMPORTANT: The ACP MUST be the first device on the phone to insure accurate routing. In a rollover seq