Manual do usuário Extron electronic DVI Output Card

Resumo do conteúdo contido na página número 1

Installation Guide
DVI Output Card
Digital Visual Interface Card for ISS 108/408 and ISM 482
68-761-01 Rev. B
01 09

Resumo do conteúdo contido na página número 2

Installation An optional digital visual interface (DVI) output card is available for the ISS 108, ISS 408, and ISM 482. With the card installed, the switcher outputs Program video simultaneously on the standard DVI connector and Program Output BNC and 15-pin HD connectors. Opening the Switcher Extron recommends returning the switcher to Extron for service and updates. N The ISM 482 Switcher installation is shown. The ISS 108 and ISS 408 installations are similar. To install the optional

Resumo do conteúdo contido na página número 3

Installation, cont’d 5 Lift cover straight up. 3 Remove (16) screws. Remove top two 4 front panel screws. Fan Connectors: DVI card socket J14 6 J8 and J13. J13 J8 Figure 1 — Removing the switcher cover DVI Output Card Installation 2 INPUTS 1 2 3 4 5 6 7 8 R R R R R R R R G G G G G G G G B B B B B B B B B 100- 240 1.2A MAX. 50/60 Hz H/HV H/HV H/HV H/HV H/HV H/HV H/HV H/HV H/HV H/HV V V 1 2 3 4 5 6 7 8

Resumo do conteúdo contido na página número 4

Installation, cont’d DVI Output Card Installation Install the DVI output card in the switcher as follows: W Changes to electronic components must be performed by authorized service personnel only. W To prevent electric shock, always unplug the switcher from the AC power source before opening the enclosure. 1. Locate the DVI output card connector opening on the rear panel and the DVI output card socket J14 on the left rear portion of the main circuit board, as viewed from the front (figure 2

Resumo do conteúdo contido na página número 5

Installation, cont’d 2. If the rear panel DVI connector opening is covered, remove the two screws that secure the cover to the back panel and remove the cover. 3. Position the DVI card above J14 with the DVI connector facing toward the rear of the switcher. Ensure the pins on the DVI card properly align with the J14 socket to prevent bending. 4. Carefully insert the DVI board 45-pin connector into socket J14 on the main circuit board (figure 3). DVI Output Card DVI Connector DVI Output Car

Resumo do conteúdo contido na página número 6

Installation, cont’d Closing the Switcher 1. Reconnect the two fan power cords to connectors J8 and J13 on the main board. It does not matter which fan is connected to which connector. 2. Replace the top cover on the switcher. 3. Fasten it with the screws that were removed in "Opening the Switcher", step 3 and step 4. 4. Reinstall the switcher and reconnect all cables. Extron USA - West Extron USA - East Extron Europe Extron Asia Extron Japan Extron China Extron Middle East Headquarters +800