Manual do usuário Seagate CHEETAH X15 ST318451LW/LC

Resumo do conteúdo contido na página número 1

Installation instructions
1. Set the SCSI ID
Determine which SCSI IDs are already being used in the system and then
Cheetah X15 Installation Guide
assign this disc drive a SCSI ID that isn’t already being used. Use the J6
ST318451LW/LC and ST39251LC
connector located on the front of the drive to set the SCSI ID (see Figure 1).
SCSI interface disc drives
 Most Cheetah X15 drives are factory set with the SCSI ID set at 0. If this
Publication Number: 83329485, Rev. B, September 2000 is the only S

Resumo do conteúdo contido na página número 2

inoperable. A low level format, with verify turned on, will typically take two J2 Drive with hours. Pin 1 HDA up, PCB down, viewed Protect against power failure or other power interruptions during the format. from front Pin 1 Reserved Positions HDA a. Turn on DC power to the host system. Delay Motor Start option (valid b. Boot the system from a system floppy, CD, or from a previously only if the Enable Motor Start J6 jumper is not connected) L R installed hard disc drive if there is one. Re