Manual do usuário Seagate CHEETAH ST173404LWV

Resumo do conteúdo contido na página número 1

 Some systems provide a cable designed to connect to the J5 jumper
block on the drive to remotely set the ID. You can connect this cable to J5
and use the host-provided remote switch to set the SCSI ID.
Cheetah 73 Installation Guide
Model ST173404LW/LC/LWV/LCV, SCSI interface disc drive
Publication Number: 83329479, Rev. A, December 1999
Handling precautions/electrostatic discharge protection
• Disc drives are fragile. Do not drop or jar the drive and handle the drive
Drive
only by the edges

Resumo do conteúdo contido na página número 2

low level format, do not abort the format as this is likely to make the drive J2 inoperable. A low level format, with verify turned on, will typically take four Drive with Pin 1 HDA up, PCB hours. down, viewed from front Pin 1 Reserved Positions HDA Protect against power failure or other power interruptions during the format. Delay Motor Start option (valid a. Turn on DC power to the host system. only if the Enable Motor Start J6 jumper is not connected) b. Boot the system from a system flop