Resumo do conteúdo contido na página número 1
PENT/ATCA −717
Reference Guide
P/N 6806800A15A
April 2006
Resumo do conteúdo contido na página número 2
Copyright Copyright 2006 Motorola GmbH All rights reserved. Motorola and the stylized M logo are trademarks of Motorola,Inc., registered in the U.S. Patent and Trademark Office. All other product or service names mentioned in this document are the property of their respective owners. Notice While reasonable efforts have been made to assure the accuracy of this document, Motorola GmbH assumes no liability resulting from any ommissions in this document, or from the use of the information obtaine
Resumo do conteúdo contido na página número 3
Contents Using This Guide Other Sources of Information Safety Notes Sicherheitshinweise 1 Introduction About this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Organization of this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Feedback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 4
Hard Disk . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49 CompactFlash Disk . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 CMC Debug Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 Rear
Resumo do conteúdo contido na página número 5
Restoring BIOS Default Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 91 Updating BIOS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 92 BIOS Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93 BIOS Post Codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 6
IPMC Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 115 Block Transfer Interfaces . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 115 Port 80 Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 116 IPMC Extensions .
Resumo do conteúdo contido na página número 7
Control and Status Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 138 Buffer Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 138 Interrupt Mask Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 138 Port 80 Register . . . . . . .
Resumo do conteúdo contido na página número 8
Tables Introduction Tablei1aaaaaaaOrganization of this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Tablei2aaaaaaaOrdering Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 Tablei3aaaaaaaAccessories Ordering Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 Installation Ta
Resumo do conteúdo contido na página número 9
Tablei33aaaaaaUpper Divider Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 147 Tablei34aaaaaaReference Clock Pulse Width Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 147 Tablei35aaaaaaVersion Register . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 148 Tablei36aaaaaaAccess Control Regi
Resumo do conteúdo contido na página número 10
Figures Installation Figurei1aaaaaaaLocation of Critical Blade Temperature Spots (Blade Top Side) . . . . . . . . . . . . . . . . . . . . . . . . 39 Figurei2aaaaaaaLocation of Critical Blade Temperature Spots (Blade Bottom Side) . . . . . . . . . . . . . . . . . . . . . 40 Figurei3aaaaaaaLocation of On −board Switches . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Figurei4aaaaaaaLocation of PMC Slots . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 11
Figurei38aaaaaaClock Synchronization Building Block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 124 Figurei39aaaaaaBlade Power Supply Structure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 126 Figurei40aaaaaaVLAN Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 130 Maps and Registers Figurei41aaaaaaPCI Structur
Resumo do conteúdo contido na página número 12
Using This Guide This Reference Guide is intended for users qualified in electronics or electrical engineering. Users must have a working understanding of Peripheral Component Interconnect (PCI), AdvancedTCA , and telecommunications. Conventions Notation Description 57 All numbers are decimal numbers except when used with the notations described below. 00000000 Typical notation for hexadecimal numbers (digits 0 through 16 F), e.g. used for addresses and offsets or 0x00000000 0000 Same for bina
Resumo do conteúdo contido na página número 13
Notation Description Danger Dangerous situation: injuries to people or sever ous situation: injuries to people or severe damage to e damage to objects possible Abbreviations Abbreviationa Descriptiona A A AC Alternating Current ANSI American National Standards Institute API Application Programming Interface APIC Advanced Programmable Interrupt Controller ATA Advanced Technology Attachment ATCA Advanced Telecommunications Computing Architecture B B BIOS Basic Input/Output System BMC Base Board Ma
Resumo do conteúdo contido na página número 14
Abbreviationa Descriptiona FCC Federal Communications Commission FIFO First In First Out FPGA Field−Programmable Gate Array FRU Field Replacable Unit G G GND Ground I I IDE Integrated Device Electronics IEC International Electric Code IPMB Intelligent Platform Management Bus IPMC Intelligent Platform Management Controller IPMI Intelligent Platform Management Interface ISA Industry Standard Architecture ISO International Organization for Standardization L L LCCB Line Card Clock Building Block LED
Resumo do conteúdo contido na página número 15
Abbreviationa Descriptiona R R RAM Random Access Memory ROM Read−Only Memory RTC Real Time Clock RTM Rear Transition Module S S S.M.A.R.T. Software Maintenance and Reference Tool SATA Serial ATA SCSI Small Computer System Interface SDR Sensor Data Record SDRAM Synchronous Dynamic Random Access Memory SELV Safety Extra Low Voltages SMI Serial Management Interface SPD Serial Presence Detect SPI Serial Peripheral Interface SRAM Static Random Access Memory SROM Serial Read−Only Memory U U UL Underwr
Resumo do conteúdo contido na página número 16
Order No.a Rev. Date Description 226132 AA May 2005 Changed logo, copyright, ... from Force Computers to Motorola;generalized safety notes regarding maximum combined power dissipation of installed PMC modules; in power requirements: added exceptions applicable to US and Canada; in standard compliances: removed IEC60068 (officially withdrawn) and UL94V−0/1 (already covered by 60950 and NEBS) standard; added section "Restoring BIOS Default Settings"; added "Restore BIOS Default Settings" procedure
Resumo do conteúdo contido na página número 17
Order No.a Rev. Date Description 6806800A15A April 2006 Created separate manual for blade used in AXP systems; Changed parallel ATA connector pinout; modified description of on−board switches SW4−1, SW4−2 and SW4−4 (default settings were changed); updated description of Ethernet switch configuration (new routing); updated PMC Pn4 pinout description; extended description of face plate LEDs; updated description of P23 backplane connector pinout; added section: BIOS−>Crisis Recovery Mode; updated o
Resumo do conteúdo contido na página número 18
Other Sources of Information For further information refer to the following documents.a Note:aCheck the Motorola literature catalog for errata sheets that may be applicable to the blade.a Company or www. Document Organisation Motorola motorola.com/co ACC/ARTM−717 Installation Guide mputing ACC/CABLE/RJ45/DSUB Installation Information aa aa ACC/ATCA−715/HDD Installation Guide ACC/ATCA−715/HDD−SATA Installation Guide aa aa ACC/ATCACMCMODULE Installation Guide. aa aa PENT/ATCA−715/717/7105/7107:
Resumo do conteúdo contido na página número 19
Company or www. Document Organisation PICMG picmg.org PICMG 3.0 Revision 1.0 Advanced TCA Base Specification PICMG 3.1 Revision 1.0 Specification Ethernet/Fiber Channel for AdvancedTCA Systems SMSC smsc.com LPC47S422 Enhanced Super I/O Controller Datasheets and Application Notes PENT/ATCA −717 19
Resumo do conteúdo contido na página número 20
Safety Notes This section provides safety precautions to follow when installing, operating, and maintaining the product. We intend to provide all necessary information to install and handle the product in this manual. However, as the product is complex and its usage manifold, we do not guarantee that the given information is complete. If you need additional information, ask your Motorola representative. The product has been designed to meet the standard industrial safety requirements. It must no
