Resumo do conteúdo contido na página número 1
USE AND CARE OF YOUR
™
My Café
Tea & Coffee Pod Brewer
P2896
Model MCPA
®
COMMERCIAL AND HOUSEHOLD TYPE
The Bunn logo is a registered trademark of Bunn-O-Matic Corporation.
My Café is a trademark of Bunn-O-Matic Corporation.
RECORD MODEL & SERIAL NUMBER
In order to receive accurate and timely warranty assistance, it is important to
record the Model and Serial Number information located on the bottom of the
brewer. A space is provided below for this information.
MODEL: Record these numbers f
Resumo do conteúdo contido na página número 2
TABLE OF CONTENTS WARNINGS ...........................................................................................................................2 USER NOTICES .....................................................................................................................3 INTRODUCTION ....................................................................................................................3 SPECIFICATIONS ......................................................................
Resumo do conteúdo contido na página número 3
USER NOTICES Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www.bunn.com. # 37280.0000 # 37281.0000 # 37267.0000 INTRODUCTION ® ™ The BUNN My Café Tea & Coffee Pod Brewer is designed to personalize your brewing experience by allowing a single cup brew of perfectly balanced coffee or tea. ® BUNN
Resumo do conteúdo contido na página número 4
IMPORTANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Do not insert or remove pod holder while • Read all instructions. brewing. Press the coffee or tea button to • Do not touch hot surfaces. Use handles or stop or cancel a brew cycle. knobs. • A canceled brew cycle is not held in • To protect against electric shock, do not memory. The next brew cycle will place cord, plug, or brewe
Resumo do conteúdo contido na página número 5
GENERAL INFORMATION Improper installation could result in permanent damage and void the limited warranty. Read & follow the instructions on page 9. ® • Use CAUTION when dispensing hot water from the brewer. The water from your BUNN Pod brewer is approximately 93°C (200°F). This is approximately 10°C (50°F) hotter than the hot water from your faucet and must be handled with care. • This brewer is designed to remain plugged in at all times (except during initial installation, cleaning, or when
Resumo do conteúdo contido na página número 6
FEATURES & CONTROLS SLIDE LID WATER POD HOLDER RESERVOIR RELEASE BUTTON SPRAYHEAD SEAL SPRAYHEAD POD HOLDER INSERT POD HOLDER DRIP TRAY GRATE POWER SWITCH DRIP TRAY BLUE (BREW) LIGHTS CONTROL PANEL VOLUME CONTROL SLIDE LEVER P2897 FIG 1. Exploded View HEATING INDICATOR REFILL WATER POD HOLDER INDICATOR INDICATOR COFFEE BREW TEA BREW BUTTON* BUTTON* VOLUME CONTROL * The Coffee or Tea button can be pressed again to stop or cancel a brew cycle in process. INDICATORS P2898 FIG 2. Control Pan
Resumo do conteúdo contido na página número 7
DEFINITIONS COMPONENTS • WATER RESERVOIR - Holds reserve water for brewing. The reservoir can be removed and filled separately at a sink or other clean water source or by pouring water through the slide lid. (Holds 1.7 L (46 oz.) to the maximum line.) • SLIDE LID - The slide lid allows access to the reservoir. Water can be poured through the opened lid and into the reservoir without removing the reservoir. • POD HOLDER RELEASE BUTTON - Push to unlock and release the pod holder. When there is
Resumo do conteúdo contido na página número 8
CONTROL PANEL (Cont.) • HEATING INDICATOR - This light indicates that the heater is bringing water up to temperature. A brew cycle cannot be started until the indicator has gone out. (During a brew cycle, this light will come on indicating the tank heater is warming the new water entering the tank.) • POD HOLDER INDICATOR - This indicator identifies a missing or unlocked pod holder. Before a brew cycle can be started, the pod holder must be inserted and locked into place. • TEA BREW BUTTON
Resumo do conteúdo contido na página número 9
INITIAL BREWER SET-UP 1. Remove the lid and 7. Plug in the brewer water reservoir. and turn on the power switch. P0214/2905 8. Place a mug or bowl that P3017 will hold at least 414 ml (14 (CAUTION: Do not place the brewer in fl. oz.) onto the drip tray a sink or other water source.) grate. P2904 2. Thoroughly rinse the water reservoir. 9. Press and release the coffee brew button to fill the 3. Fill the reservoir to the internal water maximum line with tank.* P2907 fresh cold water.
Resumo do conteúdo contido na página número 10
BREWING DELICIOUS COFFEE OR TEA WARNING: Never place hands directly under pod holder outlet. Hot water can be present. WARNING: Never remove the holder with force. If stuck, wait 10 minutes and try again. WARNING: Never brew without the pod holder insert in place. 7. Press a pod into the 1. Open the slide lid. pod holder. P2909 P2941 (NOTE: For best results, center pod in (CAUTION: Do not place brewer in holder and gently press the pod completely sink or other water source.) into holder cavi
Resumo do conteúdo contido na página número 11
HOT WATER The same basic steps used to brew coffee or tea can be used to obtain hot water by leaving the coffee pod or tea bag/pod out of the pod holder. ® CAUTION: The water from your BUNN Pod brewer is approximately 93°C (200°F). This is hotter than the hot water from your faucet and must be handled with care. COFFEE FUNDAMENTALS Brewing delicious coffee is similar to cooking any favorite food. Both require a good recipe. Proper coffee making requires quality equipment to precisely ® c
Resumo do conteúdo contido na página número 12
ROUTINE CLEANING Before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder, drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse. With the pod holder and drip tray removed, use a damp cloth with mild detergent to wipe the area below the pod holder and into the drip tray area. Occasionally, wipe the outside of the brewer with a damp cloth. (The reservoir, slide lid, pod holder, dr
Resumo do conteúdo contido na página número 13
PERIODIC CLEANING/DESCALING (Cont.) 8) When the cycle has finished, empty the cup. Repeat step 7 at least two more times to remove the solution from the tank. 9) Clean the pod holder with a mild detergent and rinse thoroughly. 10) Proceed to the “Cleaning The Sprayhead/Seal” section. CLEANING THE SPRAYHEAD/SEAL 1) Press the Power Switch into the off “O” position. 2) Unplug the brewer and allow it to cool down. (Minimum of 1 hour.) 3) After the unit has been allowed to cool, remove the pod holde
Resumo do conteúdo contido na página número 14
INSPECTING THE SPRAYHEAD SEAL When disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. CAUTION: The seal confines the hot liquid to the pod holder. Replace the seal if it becomes damaged. Parts are available at www.bunn.com. CLEANING THE POD HOLDER To prevent residue build up, it is a good idea to periodically disassemble the pod holder/screen assembly
Resumo do conteúdo contido na página número 15
TROUBLESHOOTING SITUATION EXPLANATION Nothing happens when the This is the first time you have used your COFFEE BUTTON or TEA brewer. BUTTON is pressed. The Initial Brewer Set-up procedure must be performed first. Please follow the directions on page 9 before attempting to run a brew cycle. Your brewer is not plugged in. Check to make sure the brewer is plugged in and the POWER SWITCH has been turned on. (The POD HOLDER RELEASE BUTTON - also known as the BUNN Indicator - will be illuminat
Resumo do conteúdo contido na página número 16
SITUATION EXPLANATION The REFILL WATER INDICATOR The WATER RESERVOIR has run low on water. has come on. Slide the lid open and pour additional water into the reservoir, or remove the reservoir and fill it at a sink, or other water source. CAUTION: Do not place the brewer in a sink or other water source. Do not fill past the Maximum fill line. The POD HOLDER INDICATOR The POD HOLDER is missing. has come on. Place the pod holder into the machine and press it firmly into place. The POD HOLDER is
Resumo do conteúdo contido na página número 17
TROUBLESHOOTING (Cont.) SITUATION EXPLANATION The Pod Holder will not come The pod in the POD HOLDER may have swelled out of the brewer. to a point where the holder does not slide out easily. Wait at least 10 minutes and then try carefully removing the pod holder again. CAUTION: Hot liquid may be present. Water is appearing on the The WATER RESERVOIR has been removed counter around the base of the to be filled with water and was not seated brewer. properly when it was replaced. Remove the li
Resumo do conteúdo contido na página número 18
SITUATION EXPLANATION ® ® The BUNN (POD HOLDER When the BUNN button (Also known as the RELEASE BUTTON) indicator is POD HOLDER RELEASE BUTTON) is lit, this not on all of the time. indicates that the power to the machine is on. ® No action is required. The BUNN Pod brewer is ready to brew. When the brewer enters a sleep mode the POD HOLDER BUTTON will not be glowing. Pressing any button or the POD HOLDER RELEASE BUTTON will wake up the brewer. NOTE: If the brewer does not operate, refer
Resumo do conteúdo contido na página número 19
® BUNN REPLACEMENT PARTS P2915 SLIDING LID Dishwasher Safe. P2914 WATER RESERVOIR Holds 1.7 L (46 oz.) of fresh water for quick brewing. Dishwasher safe. P2913 POD HOLDER Dishwasher safe. P2916 DRIP TRAY AND GRATE Dishwasher safe. Catches up to 177 P2943 ml (6 oz.) of liquid. POD HOLDER INSERTS Available in black or green. Color code your pod holder to identify coffee and tea holders. Helps prevent P2917 P2954 SPRAYHEAD ™ Precision Jetstream sprayhead for DESCALER/LIME INHIBITOR full flav
Resumo do conteúdo contido na página número 20
LIMITED WARRANTY Bunn-O-Matic Corporation (“Bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this Pod Brewer that the Pod Brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purchase of the Pod Brewer. If such a defect appears during the warranty period, you must notify us promptly by contacting us through our website at www.bunn.com. If we determine, in our sole discretion,
