Manual do usuário Zephyr CBE-1000

Resumo do conteúdo contido na página número 1

www.zephyronline.com
External Blower
CBE-1000
Model number: CBE-1000
Serial number:
Date of Purchase:
Sales Dealer:
MAY07.0101 © Zephyr Corporation.
Use,Care,andInstallationGuide

Resumo do conteúdo contido na página número 2

www.zephyronline.com READ AND SAVE THESE INSTRUCTIONS WARNING TO RE DUC E THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SP EED CONTRO L DEVICE. WARNING TO RE DUC E THE RISK OF FIRE, ELECTRIC SH OCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a. Use this unit only in the manner intended by the manufacturer, If you have questions, contact the manufacturer. b. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting mea

Resumo do conteúdo contido na página número 3

NOTE: The following instructions explain the mounting procedures for the CBE-1000 external blower. Please refer to your hood manual for instructions on preparing the hood for use with external blower. Fig-5 24" 3" 8" 4" 55/8" 10 1/4" 30" 7 1/2" 7 1/8" 2" 1 5/8" 8" 23/4" Fig-1 TYPICAL INSTALLATION ROOF MOUNT OUTSIDE W ALL MOUN T 10" Elbow 10" Duct 10" E lbow Roof Hood Out side Wall Hood Recommended for use only over conventional domestic gas and electric ranges. 2 Installation-ExternalBlowerSpeci

Resumo do conteúdo contido na página número 4

www.zephyronline.com 1. Remove and discard shipping brackets and wood support (attached to sides of motor and inlet collar). Fig. - 7 BEFOREINSTALLING , check to see if blower wheel turns freely and does not rub on motor brackets. Check damper door to be sure it moves freely and spring returns door to closed position. 2. Provide 14” x 18” hole through the roof or wall as shown in Fig. - 2. For reference, location of 10” duct connection and wiring connection is shown. 3. Install blower on roof or

Resumo do conteúdo contido na página número 5

4. Connect the blower to exhaust system with a 10” diameter metal duct only. Use 10” adjustable elbow to adjust to roof angle. IMPORTANT: You must run 10” round duct work from the external blower to the ceiling. Before the duct work passes through the ceiling b racket, use a 10” to 8” transition adapter and run 8” duct work to t he opening on the hood. The 8” duct work run should not exceed 60” in length. (see Fig 4a) External Blower Tape and screw all joints to prevent air