Manual do usuário System Sensor 2151

Resumo do conteúdo contido na página número 1

INSTALLATION AND MAINTENANCE INSTRUCTIONS
2151 Low Profile
Photoelectronic Plug-in
3825 Ohio Avenue, St. Charles, Illinois 60174
1-800-SENSOR2, FAX: 630-377-6495
Smoke Detector
www.systemsensor.com
Specifications
Size
Height: 1.7 inches (43 mm)
Diameter: 4.0 inches (101 mm)
Weight: 3.6 oz. (102 g)
Operating Temperature Range: 0°C to 49°C (32°F to 120°F)
Operating Humidity Range: 10% to 93% Relative Humidity noncondensing
Latching Alarm: Reset by moment

Resumo do conteúdo contido na página número 2

4. Test the detector using the magnet as described under A. Test Magnet (p/n M02-04-01 or M02-09-00) TESTING. 1. Place the magnet against the cover in the location 5. Reset the detector at the system control panel. designated by the raised mark to activate the test fea- 6. Notify the proper authorities that the system is back on ture (see Figure 1). line. 2. The LEDs should latch ON within 5 seconds indicat- ing alarm and annu

Resumo do conteúdo contido na página número 3

Figure 2: 1. Remove the detector cover by prying away the four side tabs with a small-bladed screwdriver, and then SENSOR COVER pulling the cover from the base. 2. Vacuum the screen carefully without removing it. If further cleaning is required continue with Step 3, oth- erwise skip to Step 8. 3. Remove the screen assembly by pulling it straight out (see Figure 2). 4. Remove the sensing chamber cover by pulling it straight out. SE

Resumo do conteúdo contido na página número 4

Please refer to insert for the Limitations of Fire Alarm Systems Three-Year Limited Warranty System Sensor warrants its enclosed smoke detector to be free from Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please include a note describing the malfunction and suspected cause defects in materials and workmanship under normal use and service for a of failure. The Company shall not be obligated to repair or replace units