Resumo do conteúdo contido na página número 1
02/25/2011
Tabletop Patio
Heater
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from
the appliance and immediately call
your gas supplier or fire department.
WARNING
Do not store or use gasoline or
other flammable vapors and liquids
in the vicinity of this or any other
appliance.
An LP-cylinder not connected for use
shall not be stored in the vicinity of
this or any other appliance.
WARNING
For Outdoor Use Only
Resumo do conteúdo contido na página número 2
PRECAUTIONS CARBON MONOXIDE HAZARD DANGER This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as a camper, tent or home. WARNING: Improper installation, adjustment, alteration, services or maintenance can cause injury, death or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. SPECIFIC
Resumo do conteúdo contido na página número 3
PRECAUTIONS NOTE:PLEASE READ THE FOLLOWING SAFETY RULES WARNING: The installation must conform with local codes Installation and repair should be done by or, in the absence of local codes, with the a qualified service person. The heater National Fuel Gas Code, ANSI Z223.1/NFPA 54, should be inspected before use and at NFPA58 Natural Gas and Propane Installation least annually by a qualified service Code, CSA B149.1, or Propane Storage and person. Handling Code, B149.2 More frequent clean
Resumo do conteúdo contido na página número 4
PRECAUTIONS NOTE:PLEASE READ THE FOLLOWING SAFETY RULES WARNING: Within a partial enclosure which includes an Do not store a spare LP-gas cylinder under or overhead cover and three side walls, as long as near this appliance; 30 percent or more of the horizontal periphery of the enclosure is permanently open. Never fill the cylinder beyond 80 percent full; This appliance requires 16.4oz (1lb) LP_gas Do not clean the heater with cleaners that are supply cylinder. combustible or corrosive. Th
Resumo do conteúdo contido na página número 5
WARNINGS AND CAUTIONS NOTE: PLEASE READ THE FOLLOWING SAFETY RULES: Perform a leak test with a soapy solution: 1. To check gas connections. 2. After connecting a new cylinder. 3. Upon re-assembly after disassembly. This heater is designed to operate with a standard 1 Ib propane cylinder with Approved Cylinder Connection. PREPARATION Before beginning assembly of product, make sure all parts are present. If any part is missing or damaged, do not attempt to assemble the
Resumo do conteúdo contido na página número 6
PARTS LIST Please check the contents of the packaging as to whether anything is missing! 8 1 1 Base 7 11 2 1 Housing 12 3 1 Burner Column 12 4 2 Emitter Screen Shield 5 1 Emitter Screen 6 1 Reflector Dome 9 7 1 Dome Cap 9 1 Decorative Dome Cap Nut 8 9 7 M4 x 8 Bolts 7 M4 x 6 Bolts 10 13 11 3 M6 Nuts 3 12 6 6mm Washers 13 1 Regulator The fasteners used comply with ANSI/BL.1 10 6
Resumo do conteúdo contido na página número 7
ASSEMBLY WARNING : ONLY AN AUTHORIZED GAS TECHNICIAN SHOULD INSTALL THIS PRODUCT. Step 1 Step 1 Attach housing (2) to base (1) using seven M4 x 6 bolts (10). 2 1 10 Hardware Used 10 M4 x 6 bolt X 7 Step 2 Step 2 3 Insert the three clamps of the burner column (3) into the three spring pieces of the housing (2) per the picture and screw over. Make sure the clamp and the spring piece fit together. 2 7
Resumo do conteúdo contido na página número 8
ASSEMBLY Step 3 Step 2 Attach emitter screen (5) to burner column (3) using three M4 x 8 bolts (9) Note: The ignition hole on emitter screen must line to the control knob. Ignition Hole 9 ODS Hole 3 Hardware Used 9 M4 x 8 bolt X 3 Step 4 Step 4 8 Attach reflector dome (6) to emitter screen (5) 7 using six 6mm washers (12) and three M6 nuts 11 (11). 12 Then attach dome cap (7) and decorative dome cap nut (8) to reflector dome (6). 12 5 Hardware Used M6 nut 11 X 3 3 12 6mm Wash
Resumo do conteúdo contido na página número 9
ASSEMBLY Step 5 Step 5 Attach emitter screen shield (4) to burner column (3) using four M4 x 8 bolts (9). 4 4 4 9 3 4 3 Hardware Used 9 M4 x 8 bolt X 4 Step 6 Step 6 Open the access door. Open up the gas bottle cover. Attach it to the regulator. Aim at the screw thread. Turn counter clockwise and tighten. Regulator Tighten Gas bottle 9
Resumo do conteúdo contido na página número 10
SAFETY CHECK Check for leak Your patio heater has been checked at all factory connections for leakage. To check the connections at the tube/regulator/cylinder. 1) Make leakage solution by mixing 1 part liquid dish soap and 3 parts water. 2) Spoon several drops (or use squirt bottle) of the solution onto the tube/regulator/cylinder connections. 3) Inspect the connections and look for bubbles. 4) If no bubble appears, the connection is safe. 5) If bubble appears, there is leak; lo
Resumo do conteúdo contido na página número 11
OPERATION This product is equipped with ODS (Oxygen Deprivation System) WARNING: DO NOT ATTEMPT TO OPERATE HEATER UNTIL YOU HAVE READ AND UNDERSTAND ALL PRECAUTION . FAILURE TO DO SO CAN RESULT IN SERIOUS PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE. Before turning gas supply ON WARNING Your heater was designed and approved for OUTDOOR FOR YOUR SAFETY: USE ONLY. DO NOT use it inside a building or any other If at any time you are unable to enclosed area. light burner and smell gas, wait 5 Ma
Resumo do conteúdo contido na página número 12
OPERATION 4 Push in gas control knob and turn counter clockwise to "IGNITE" then to "PILOT" position, this will light the pilot. If needed, keep depressing and turning control knob counter clockwise until the pilot lights. (You will hear 1 clicking noise) 5. Once the pilot is lit, keep the control knob depressed for approx. 30 seconds. Then release the control knob. 6. If pilot does not stay lit, repeat steps 3 and 4 after 5 minutes. 7. If pilot still does not stay
Resumo do conteúdo contido na página número 13
OPERATION CAUTION : AVOID INHALING FUMES EMITTED FROM THE HEATER'S FIRST USE. SMOKE AND ODOR FROM THE BURNING OF OILS USED IN MANUFACTURING WILL APPEAR. BOTH SMOKE AND ODOR WILL DISSIPATE AFTER APPROXIMATELY 30 MINUTES. THE HEATER SHOULD NOT PRODUCE THICK BLACK SMOKE. NOTE: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the Control Knob to the "LOW" position. Then, turn the knob to the level of heater desired. When heater is ON: Emitt
Resumo do conteúdo contido na página número 14
LOCATING HEADER FOR USE CAUTION: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT, ABOVE, BESIDE OR UNDER THIS HEATER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD BE SERIOUSLY DAMAGED. This heater is primarily used for the heating of CEILING/OVERHANG outdoor patios, decks, spas, pools and open working areas. 12" 10" Always make sure that adequate fresh air ventilation is provided. Follow the spacing tolerances shown in Figure 1 at all times. This heater must be placed on level,
Resumo do conteúdo contido na página número 15
MAINTENANCE/STORAGE CLEANING AND MAINTENANCE : To enjoy years of outstanding performance from your heater make sure you perform the following maintenance Yellow Tip activities on a regular basis: Primarily Blue Flame Keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable of corrosive cleaning agents. While washing your unit, be sure to keep the area WARNING: around the burner and pilot assembly dry at all times. If FOR YOUR SAFETY ; the gas control is exposed
Resumo do conteúdo contido na página número 16
MAINTENANCE/STORAGE STORAGE: NOTE: Between uses: wait until heater is cool before Turn the control knob to "OFF" position. covering. Turn clockwise to disconnect cylinder from regulator. Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris). If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages. During periods of extended inactivity or when transporting; Turn the c
Resumo do conteúdo contido na página número 17
TROUBLESHOOTING PROBLEM PROBABLE CAUSE SOLUTION Pilot will not light Gas valve may be OFF Turn the gas valve ON Tank fuel empty Refill LP gas tank Air in supply system Purge air from lines Loose connection Check all fittings Debris around pilot Clean dirty area Pilot will not stay on Loose connection Tighten connection Thermocouple Contact customer service Gas leak in line Check connections Lack of fuel pressure Fuel tank is near empty Pressure is
Resumo do conteúdo contido na página número 18
ONE-YEAR LIMITED WARRANTY The appliance has been manufactured under the highest standards of quality and workmanship. We warrant to the original consumer purchaser that all aspects of this product will be free of defects in material and workmanship for one (1) year from the date of purchase. A replacement for any defective part will be supplied free of charge for installation by the consumer. Defects or damage caused by the use of other than genuine parts are not covered by this warranty. Th
Resumo do conteúdo contido na página número 19
SRPT03-XXXX color material & base venthole shape reflector venthole shape material & base reflector 1. Round 1. Steel w/ bigger base 1. 1PC reflector 2. S/S w/ bigger base 2. Rhombic 2. 2PCS reflector 3. Steel w/ smaller base 3. Rectangle 3. 3PCS reflector 4. S/S w/ smaller base 8. Cast aluminium base 9. Cast iron base SRPT03-XXXX couleur matériau et base
