Resumo do conteúdo contido na página número 1
S le e p
CR9901
3 Band Single Alarm
Clock Radio
CR 9 9 0 1
3 B a n d C loc k R a d io
Please read this manual before use
CR9901 Instruction Book.pm6 1 24/10/99, 13:48
A la rm /O ff
M in u te
H o u r
T im e
ROBERTS
Sound for Generations
Resumo do conteúdo contido na página número 2
S le e p Controls 3 (Top) 4 5 2 6 1 C R 99 01 3 B a n d C lock R a d io 12 11 10 9 8 7 (Left side) (Right side) 1. Dimmer switch 5. Waveband selector 9. Alarm/Off button 2. Function switch 6. Tuning control 10. Minute button 3. Headphone socket 7. Sleep button 11. Hour button 4. Volume control 8. Snooze button 12. Time button 1 CR9901 Instruction Book.pm6 2 24/10/99, 13:48 A la rm /O ff M in u te H o u r T im e FM MW LW Volum e Tu nin g Dim m er O ff B u zz A u to O n High Low
Resumo do conteúdo contido na página número 3
Controls (Front) 15 16 LW 150 17 0 2 10 2 4 0 2 60 kH z PM MW 54 0 60 0 80 0 10 0 0 13 0 0 16 0 0 kH z FM 88 92 96 10 0 10 4 10 6 10 8 MH z 18 17 15. PM indicator 16. LED dial pointer 17. Battery compartment (underside) 18. Alarm indicator If you need any further advice, please call our Technical Helpline on :- 2 0181 758 0338 (Mon-Fri) CR9901 Instruction Book.pm6 3 24/10/99, 13:48
Resumo do conteúdo contido na página número 4
Switching on and setting the time Before using your clock radio you must first set the correct time. ON 1. Place the unit on a flat surface. Plug the power cord into the wall socket LW 15 0 17 0 21 0 24 0 26 0 kH z PM 54 0 60 0 80 0 1000 130 0 160 0 MW kH z and switch on. FM 88 92 96 10 0 10 4 10 6 10 8 MHz 2. The clock display will flash 12.00. PM 3. Press and hold down the Time Set button. 4. Whilst holding down the Time Set button press the Hour, or Minute buttons to set the time. Release t
Resumo do conteúdo contido na página número 5
Listening to the Radio O ff Buzz Auto O n 1. Turn on the radio by sliding the Function switch to the 'On' position. LW 150 170 21 0 24 0 26 0 kH z The LED dial pointer will light up indicating that the radio is 54 0 60 0 80 0 10 0 0 1300 16 0 0 kH z MW switched on. FM 88 92 96 10 0 10 4 10 6 10 8 MH z 2. Select the required waveband using the Waveband selector switch. FM MW LW 3. Tune in to the desired station by rotating the Tuning control. The station frequency is indicated by the LED dial po
Resumo do conteúdo contido na página número 6
Alarm The alarm can be set to wake you by either the buzzer or the radio. Setting alarm time 1. Press and hold down the Alarm/Off button. 2. Whilst holding down the Alarm/Off button press the Hour, or Minute buttons to set the time. Release the buttons when the correct alarm time is reached. The clock uses a 12 hour display with a PM indicator. Ensure that the correct 12 hour cycle is selected. PM Checking the alarm time 1. To check alarm time, press and hold down the Alarm/Off button the disp
Resumo do conteúdo contido na página número 7
Setting the alarm to wake to buzzer O ff Buzz Auto O n 1. Set the alarm time as previously described. Set the Function switch to the 'Buzz' position. The Alarm indicator will light. The alarm will sound every day at the preset time for 59 minutes. To turn off the alarm until the next day press the Alarm/Off button. To turn off the alarms permanently set the Function selector to the 'Off' position. PM Setting the alarms to wake to radio 1. Set the alarm time as previously described. Set the
Resumo do conteúdo contido na página número 8
Snooze control The radio or buzzer alarm can be silenced for 7 minutes by pressing the Snooze button. This sequence can be repeated whilst the alarm is sounding. Sleep timer The radio can be set to turn off after a preset time has elapsed. Press and hold down the Sleep button until the desired time is reached (maximum 59 minutes in 1 minute steps). The radio will switch off after the sleep time has elapsed. To cancel the sleep function before the preset time has expired, press the Alarm/Off butt
Resumo do conteúdo contido na página número 9
General Fuse Do not allow this unit to be exposed to water or steam. It is recommended This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug that the FM band be used wherever possible as better results in terms (BS1363). If another type of plug is used a 5A fuse should be fitted in the of quality and freedom from interference will usually be obtained than plug, adaptor or distribution board. on the MW or LW bands. IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN. Mains supply The CR
Resumo do conteúdo contido na página número 10
Specifications Circuit Features Power Requirements Loudspeaker 75mm diameter 8 ohms Mains AC 230 volts, 50Hz only Output Power 0.3W RMS Back-up Battery IEC size 6LR61 (6F22, PP3) Aerial System FM Wire Aerial Frequency Coverage FM 87.5 - 108MHz MW Built-in Ferrite aerial MW 525 - 1610kHz LW 147- 284kHz LW Built-in Ferrite aerial ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice. 9 CR9901 Instruction Book.p
Resumo do conteúdo contido na página número 11
Notes: If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) CR9901 Instruction Book.pm6 11 24/10/99, 13:48
Resumo do conteúdo contido na página número 12
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. Procedure: Any claim under thi
