Resumo do conteúdo contido na página número 1
Administrator Guide
SIP Cordless Phone
Model No. KX-TGP500
KX-TGP550
Thank you for purchasing a Panasonic product.
Please read this guide before using the unit and save it for future reference.
Document Version: 2010.03.15
Resumo do conteúdo contido na página número 2
Introduction Introduction This Administrator Guide provides detailed information on the configuration and management of this unit. This Administrator Guide is available on the Panasonic Web site at: http://panasonic.net/pcc/support/sipphone/ Audience This Administrator Guide contains explanations about the installation, maintenance, and management of the unit and is aimed at network administrators and phone system dealers. Technical descriptions are included in this guide. Prior knowledge of net
Resumo do conteúdo contido na página número 3
Table of Contents Table of Contents 1 Initial Setup .............................................................................................13 1.1 Setup ................................................................................................................................14 1.1.1 Factory Defaults .............................................................................................................14 1.1.2 Language Selection for the Unit ......................................
Resumo do conteúdo contido na página número 4
Table of Contents Model ........................................................................................................................57 Operating BANK .......................................................................................................57 IPL Version ...............................................................................................................57 Firmware Version .........................................................................................
Resumo do conteúdo contido na página número 5
Table of Contents 3.4.4.2 STUN Server ...............................................................................................................70 STUN Server Address ..............................................................................................70 STUN Server Port .....................................................................................................71 3.4.5 Static NAPT Settings ...................................................................................
Resumo do conteúdo contido na página número 6
Table of Contents Registrar Server Address ..........................................................................................83 Registrar Server Port ................................................................................................84 Proxy Server Address ...............................................................................................84 Proxy Server Port ......................................................................................................84 P
Resumo do conteúdo contido na página número 7
Table of Contents Second CODEC ........................................................................................................96 Third CODEC ............................................................................................................96 Fourth CODEC ..........................................................................................................97 Fifth CODEC .........................................................................................................
Resumo do conteúdo contido na página número 8
Table of Contents 3.7.4.3 Ringing Tone .............................................................................................................113 Tone Frequencies ...................................................................................................113 Tone Timings ..........................................................................................................114 3.7.4.4 Stutter Tone ....................................................................................
Resumo do conteúdo contido na página número 9
Table of Contents TIME_ZONE ..............................................................................................................136 DST_ENABLE ...........................................................................................................136 DST_OFFSET ...........................................................................................................136 DST_START_MONTH ...............................................................................................137
Resumo do conteúdo contido na página número 10
Table of Contents 4.4.3 Ethernet Port Settings ..................................................................................................155 VLAN_ENABLE (KX-TGP550 only) ...........................................................................155 VLAN_ID_IP_PHONE (KX-TGP550 only) .................................................................155 VLAN_PRI_IP_PHONE (KX-TGP550 only) ...............................................................155 VLAN_ID_PC (KX-TGP550 only) ..........
Resumo do conteúdo contido na página número 11
Table of Contents CODEC_G711_REQ .................................................................................................169 CODEC_G729_PARAM ............................................................................................169 4.6.2 RTP Settings ................................................................................................................170 TOS_RTP_[1–8] ........................................................................................................
Resumo do conteúdo contido na página número 12
Table of Contents SIP_2NDPRSNC_ADDR_[1–8] .................................................................................189 SIP_2NDPRSNC_PORT_[1–8] .................................................................................189 USE_DEL_REG_OPEN_[1–8] ..................................................................................189 USE_DEL_REG_CLOSE_[1–8] ................................................................................190 PORT_PUNCH_INTVL_[1–8] ........................
Resumo do conteúdo contido na página número 13
Section 1 Initial Setup This section provides an overview of the setup procedures for the unit. Document Version 2010.03.15 Administrator Guide 13
Resumo do conteúdo contido na página número 14
1.1.3 Basic Network Setup 1.1 Setup 1.1.1 Factory Defaults Many of the settings for this unit have been configured before the unit ships. Where possible, these settings are configured with the optimum or most common values for the setting. For example, the port number of the SIP (Session Initiation Protocol) server is set to "5060". However, many of the settings, such as the address of the SIP server or the phone number, have not been pre-configured, and they must be modified depending on the
Resumo do conteúdo contido na página número 15
1.1.3 Basic Network Setup Using a Static IP Address Specified by Your Network Administrator If IP addresses for network devices are specified individually by your network administrator, you will need to manually configure settings such as the IP address, subnet mask, default gateway, and DNS servers from either the base unit or one of the handsets. For details about the required network settings, consult your network administrator. DNS Server Settings You can configure the unit to use 2 DNS serv
Resumo do conteúdo contido na página número 16
1.1.3 Basic Network Setup In cases when buttons/soft key icons are shown in symbols/pictures 1. Base unit: (middle soft key) ® [#][5][0][0] Handset: (center of joystick) ® [#][5][0][0] 2. [ ]/[ ]: Select "On" for DHCP ® 3. [ ]/[ ]: Select "Automatic" for DNS ® • Select "Manual" to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2 (secondary DNS server) manually ® 4. Base unit: [ ] Handset: [ ] To configure network settings manually In cases when buttons/soft key icon
Resumo do conteúdo contido na página número 17
1.1.5 Pre-provisioning To configure network settings manually 1. Click the [Network] tab, and then click [Basic Network Settings]. 2. Select [Static] for [Connection Mode]. 3. Enter an IP address in [Static IP Address]. 4. Enter the subnet mask in [Subnet Mask]. 5. Enter a default gateway address in [Default Gateway]. 6. Enter the address for the primary DNS server in [DNS1]. 7. If necessary, enter the address for the secondary DNS server in [DNS2]. Note • If your phone system dealer does not al
Resumo do conteúdo contido na página número 18
1.1.5 Pre-provisioning For details about the settings that can be configured with the configuration files and how to specify the settings, see Section 4 Configuration File Programming. Factory Phone system dealer Preset Pre-provisioning Pre-provisioning data Factory defaults Factory defaults Pre-provisioning can aid the installation process by allowing phone system dealers to configure beforehand the minimum settings required to operate the unit. For example, phone system dealers can store on
Resumo do conteúdo contido na página número 19
1.1.5 Pre-provisioning 1.1.5.3 Server for Pre-provisioning The DHCP server and TFTP server play important roles in performing pre-provisioning. This section explains their purposes, uses, and brief descriptions. Server Purpose Description DHCP server Used to provide the address In option 66 of the DHCP server, specify the IP of a TFTP server, set in option address or FQDN (Fully Qualified Domain Name) of 66 of the DHCP server, to the TFTP server. units that have not been For details, refer to t
Resumo do conteúdo contido na página número 20
1.1.5 Pre-provisioning Prior Settings Item Description/Setting DHCP server option 66 192.168.0.130 IP address range assigned by DHCP server 192.168.0.16 to 192.168.0.63 File name of the configuration file used for KX-TGP500B01.cfg pre-provisioning URL of the configuration file used for CFG_STANDARD_FILE_PATH="http:// provisioning that is entered in the configuration provisioning.example.com/Panasonic/ file Config{MAC}.cfg" Note • "{MAC}" is replaced by the MAC address of the unit. (e.g., "0080F0
