Manual do usuário Pelco HD3515

Resumo do conteúdo contido na página número 1

C2400M-A (8/99)
HD35/HD3515 Series
Heater and Defroster Kit
®
3500 Pelco Way IMPORTANT SAFEGUARDS AND WARNINGS
Clovis, CA 93612-5699
Prior to installation and use of this product, the following WARNINGS should be observed.
USA
1. Installation and servicing should only be done by qualified service personnel and conform
In North America & Canada:
to all local codes.
Tel (800) 289-9100
FAX (800) 289-9150
2. Only use replacement parts recommended by Pelco.
International Customers:
Tel (1-559) 292-19

Resumo do conteúdo contido na página número 2

Hardware to attach the heater bracket(s) EH3508/EH3512 Series EH3515/EH3515L Series 4 3/8-inch screws 4 3/8-inch screws 4 #6 nylon washers 4 #6 nylon washers 2 1/4-inch Phillips pan head screws 2 #6 lock washers Hardware to attach the PC board (EH3508/EH3512/EH3515 only) 2 6-32 x 3/8-inch Phillips pan head screws 4 #6 nylon washers 1 #6 lock washer 1. Disconnect all sources of power from the enclosure. 2. Unlatch and open the lid. 3. Remove the camera and camera sled. a. Disconnect the power and

Resumo do conteúdo contido na página número 3

10. Do one of the following depending on the model number of the enclosure: • EH3512 Series and EH3515 Series Connect the heater and defroster wires to the PC board (refer to Figure 2). Be sure the wires are not obstructing other accessories within the enclosure. If you are installing HD3515-2 Heater Kit (24 VAC), refer to Table A, 24 VAC Wiring Distances. ® • EH3515L Legacy Series Connect the front and rear heater wires to the HTRS connector (P5) on the circuit board and the defroster wires to

Resumo do conteúdo contido na página número 4

11. Reinstall the camera and sled. Caution…If the wiring is routed underneath the camera sled, be sure you do not bind the wiring when reinstalling the camera sled and camera. 12. Close the enclosure lid, and latch. 13. Reconnect power to the enclosure. Table A. 24 VAC Wiring Distances The following are the recommended maximum distances for 24 VAC applications and are calculated with a 10-percent voltage drop. (Ten percent is generally the maximum allowable voltage drop for AC-powered devices.)