Resumo do conteúdo contido na página número 1
4’ x 6’ GREENHOUSE
WitH tWO VENtS
Model 94515
ASSEMbly iNStRUctiONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
tO pREVENt SERiOUS iNjUR y, REAd ANd UNdERSt ANd
All WARNiNGS ANd iNStRUctiONS bEfORE USE.
© ®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reprod
Resumo do conteúdo contido na página número 2
contents UNpAcKiNG ..............................................................................2 SpEcificA tiONS ......................................................................3 GENERAl SAfEty WARNiNGS ANd pREcAUtiONS ..........3 bASE ASSEMbly .....................................................................5 fRAME ASSEMbly ..................................................................6 Assembling the Outer frame ............................................................ 6 Ass
Resumo do conteúdo contido na página número 3
SpEcificA tiONS 1 1 Overall Dimensions 51 / ” L x 74 / ” W x 81” H 2 2 3 Window Dimensions 22 / ” L x 20” W 4 3 3 Door Dimensions 62 / ” H x 22 / ” W 4 4 Aluminum Frame Materials Transparent Polycarbonate Sheets Weight 48.5 lb. Note: Diagrams within this manual are for reference only and are not necessarily to scale. Save this Manual You will need this manual for the safety warnings and precautions, assembly, inspec- tion, maintenance and cleaning procedures, parts list and assembly diagram. K
Resumo do conteúdo contido na página número 4
7. cHEcK fOR dAMAGEd pARtS. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace or repair damaged or worn parts immediately. 8. REpl Ac EMENt pARt S ANd Acc ESSORiES: When servicing, use only identical replacement parts. Only use accessories intended for use with this product. Ap- proved accessories are available from Harbor Frei
Resumo do conteúdo contido na página número 5
bASE ASSEMbly iMpORt ANt–R EAd t HE f Oll OWiNG c AREf Ully bE f ORE pROc EEdi NG • The first step in assembly is to assemble a proper base. The greenhouse must be properly supported to help prevent property damage and injury in the event of strong winds or inclement weather. Wind and ground conditions may vary from site to site, and may affect the practicality and effectiveness of anchoring methods substantially. • Be certain to check with local authorities to obtain all required building
Resumo do conteúdo contido na página número 6
fRAME ASSEMbly • Unless noted otherwise, all frame parts will be attached using the bolts (43) and Nuts (52) provided. bolts should all be assembled with their heads 1 facing the outside of the greenhouse. tighten Nuts only about / turn past 4 finger-tight; be careful not to overtighten. • lay out all parts by number prior to assembly. • An assistant or an appropriate support (not included) will be useful to keep the partially assembled parts upright during assembly. An assistant should
Resumo do conteúdo contido na página número 7
Resumo do conteúdo contido na página número 8
Assembling the Roof frame 5 4 35 2 12 14 3 figure b 1. Assemble the roof frame to the side of the greenhouse first. Attach the Front-Right and Front-Left Crown Beams (2, 3) to the outside of the Crown (35) with the angled edges towards the top. See diagram below right, viewed from under the Crown, facing forward. 2. Attach the Top Doorway Beam (12) and Door Rail (14) 3355 assembly to the outside (opposite the Crown) of the Front- Right and Front-Left Crown Beams (2, 3). The rounded edge
Resumo do conteúdo contido na página número 9
Assembling the Studs and braces the 8 spots requiring a Hold-down connector (55) are marked with a plus (+). 10 23 9 8 22 19 + 7 + 23 + 25 6 + 25 22 Viewed from other angle + 10 19 + 38 + 3 + 39 23 figure c 1. Attach the Rear-Left and Rear-Right Studs (8, 9) to the outside of the Rear Floor Plate (16) and Rear Brace (21). Slide a Hold-Down Connector (55) under the base and over the Bolt at each Floor Plate (16) connection. 2. Attach the tops of the Rear Studs (8, 9) to the Rear-Right and R
Resumo do conteúdo contido na página número 10
Resumo do conteúdo contido na página número 11
Assembling the Roof Studs and braces 15b 11 15a 11 figure d 1. Attach both Roof Studs (11) to the outside of the Crown (35) and slide one Bolt (43) into each. Secure the ends to the outer top edge of the Side Ceiling Plates (36) using another Bolt (43). 2. Slide a Left Window Support Beam (15a) onto two Roof Studs (11) on the left side of the greenhouse, with the predrilled holes on the underside and the flat side fac- ing the Crown (35). Use the extra Bolts (43) to secure the Beam loosely
Resumo do conteúdo contido na página número 12
Resumo do conteúdo contido na página número 13
Resumo do conteúdo contido na página número 14
installing the t ransparent panels 1. Panel Clips (46) are used to secure the Transparent Panels in place on the Green- house. 2. Remove the protective film from both sides of all panels. 63/65 35 32 65 63 63 15a/15b 36 3. The Roof Panels (63) and the Roof Window Panels (65) will need to be placed as shown in the illustrations above. The top edges of these panels need to be placed up under the edge of the Crown (35) or the Window Support Beam (15a/15b). 4. One at a time, place each Transparen
Resumo do conteúdo contido na página número 15
panel installation diagram # = panel clip (67) location # # # # # # # # 66 # # # 67 # 64 # 65 # # # # # # # # # # # # # 66 # # # # # # # # 64 63 # # # # # # # # # 69 # # # # # # # 65 # # # # # # 63 # # # # # # # 70 # # # 64 # # # # # # # 68 # # 62 # # # # # # 64 # # # 70 # 62 # # # # # # # # SKU 94515 for technical questions, please call 1-800-444-3353. Page 15
Resumo do conteúdo contido na página número 16
iNSpEctiON, MAiNtENANcE, ANd clEANiNG 1. bEfORE EA cH USE, inspect the general condition of the Greenhouse. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, and any other condition that may affect the safe operation of the Greenhouse. If a problem occurs with the Greenhouse, have it corrected before further use. do not use damaged equipment. 2. t O clEAN : Wipe with a damp cloth, using a mild detergent. do not use cleaners that are combustible, cor
Resumo do conteúdo contido na página número 17
pARtS liSt lengths given are approximate and most are rounded to the nearest inch. pARt dEScRiptiON Q’ty pARt dEScRiptiON Q’ty Left-hand Corner Door Slide 1 4’ 2 19 1’ 3” 1 Stud Support Front-Right Crown 2 3’ 9” 1 20 Left Door Frame 5’ 3” 1 Beam Front-Left Crown 3 3’ 9” 1 21 Rear Brace 6’ 1 Beam Rear-Left Crown Side Diagonal 4 3’ 9” 1 22 4’ 3” 2 Beam Brace Rear-Right Crown 5 3’ 9” 1 23 Front Brace 1’ 11” 2 Beam Left Doorway 6 5’ 5” 1 24 Top Door Frame 2’ 1 Stud Right Doorway Front Diagonal
Resumo do conteúdo contido na página número 18
pARtS liSt (continued) part lengths are approximate and most are rounded to the nearest inch. pARt dEScRiptiON Q’ty pARt dEScRiptiON Q’ty Long Door M6 x Hold-down 38 1 55 16 Support Bolt 38 Connector Door Support 39 1 56 Hex Wrench 1 Spacer Door Bottom Front/Rear Base 40 2 57 2 Slider Plate 41 Spanner Wrench 1 58 Side Base Plate 2 Base Plate 42 Door Seal 2 59 4 Connector M6 x 43 Bolt 88 60 Base Bolt 16 10 ST4.5 44 Door Screw 16 61 Base Nut 16 x 19 ST4.5 2’ x 45 Window Screw 8 62 Wall Panel
