Resumo do conteúdo contido na página número 1
INSTALLATION AND OPERATION MANUAL
Free-Standing
EPA Certified
Wood-Burning Stoves
Save These Instructions
For Future Reference
P/N 775,215M, Rev. C, 05/2008
Performer ST210
Performer SS210
Wood Stoves
Models Performer™ S210
A French manual is available upon request. Order P/N 775,215CF.
Ce manuel d’installation est disponible en francais, simplement en faire la demande. Numéro de la pièce
775,215CF.
These appliances must be properly installed and operated in order to prevent the pos-
sibili
Resumo do conteúdo contido na página número 2
13. Inspect your chimney at least once a month during the burn- General Safety Precautions ing season to check for soot and creosote accumulations. Any accumulations over 1/4” thick should be removed by a 1. If this solid-fuel room heater is not properly installed, a house professional chimney sweep. Do not attempt to burn out heavy fire may result. For your safety, follow the installation direc- creosote accumulations with a hot fire. If
Resumo do conteúdo contido na página número 3
Table of Contents General Safety Precautions ................................................................. Testing Information ...........................................................................4 Draft Requirements ...........................................................................4 Selecting the Proper Venting System ......................................................4 Negative Pressure Warning ................................................................5 Creosote .
Resumo do conteúdo contido na página número 4
Testing Information Selecting the Proper Venting System This manual describes the installation and operation of the Per- The appliance is merely one component of a larger system. The former™ S210 non-catalytic wood heaters. These heaters meet other equally important component is the venting system. This is the U.S. Environmental Protection Agency’s emissions limits for necessary for achieving the required flow of combustion air to the woo
Resumo do conteúdo contido na página número 5
Dry, seasoned wood is that which has been cut, split and allowed Negative Pressure Warning to dry under a covered area where air is free to flow and circulate under and around the wood (not under a tarp or plastic). Make This appliance is not designed to be operated in a negative pres- sure wood is not stacked directly on the ground, it may absorb sure. Very airtight homes with large kitchen exhaust fans, or moisture from
Resumo do conteúdo contido na página número 6
Approved Chimney* - Your stove is approved for use with Class Clearances to Combustibles A, UL 103 HT (U.S.) / ULC-S629 (Canada) Listed Residential Type and Building Heating Appliance Chimney (HT chimney - 2100° WARNING: BE ABSOLUTELY SURE THE DISTANCE BE- Fahrenheit) and double wall connector pipe from Security™ TWEEN THE HEATER AND THE SURFACE OF ANY COM- Chimneys. BUSTIBLE CONSTRUCTION IS NOT LESS THAN SHOWN ON THE DIAGRAM BELOW. Clearances to connector
Resumo do conteúdo contido na página número 7
Installation Clearances - Refer to Diagrams A, B and C PIPE INSTALLATION A B (1) C D (1) E† F (1,4) Single Wall Residential USA-16” 1- /4” USA- 4” 14-1/” 8” 9” CAN-48 mm 49mm CAN-6 5mm 68mm 00mm 9mm Single w/ Pipe Residential USA-10” 7-/4” USA- 4” 14-1/” 8” 9” Shield CAN- 0mm 197mm CAN-6 5mm 68mm 00mm 9mm Double Wall Residential or USA-10” 7-/4” USA-18” 8-1/” 8” 6” Mobile Home* CAN- 0mm 197mm CAN-48 mm 16mm 00mm 15mm Double Wall Alcove USA-10” 7-/4” USA-
Resumo do conteúdo contido na página número 8
Leg and Heatshield Installation Note: The threaded rods used to bolt the legs to the stove are packaged with the heatshield, as a heatshield is required when a stove is installed on legs. Residential and Mobile Homes (Bolting down and grounding of stove are required only in mobile homes). Heatshield Open all cartons, if any and remove the contents upon receipt Mounting Holes and check for any damaged or missing parts. If there is hidden damage, notify you
Resumo do conteúdo contido na página número 9
10. If installed into a mobile home, the stove shall be grounded Stove Installation to the mobile home chassis with a #8 AGW copper wire or equivalent. 1. If not previously installed, install floor protection and move 11. For residential installations, install the first section of stove the heater intothe desired location. pipe with the crimped end going down inside the flue collar 2. Position the stove on your floor protection
Resumo do conteúdo contido na página número 10
5. If required, install the Outside Air Kit (P/N 71112) as per Pedestal Installation the following instructions. To locate the hole in the hearth for outside air mark and cut a 4” (102 mm) hole in the (For ashdrawer pedestal see instructions included with pedes - hearth. The hole’s center should be 3” (76 mm) directly tal) forward from the center of the flue outlet or locate as per thefollowing instructions. Residential and
Resumo do conteúdo contido na página número 11
Post Installation Checks Brick Installation CAUTION: Wear gloves during brick installation in case 1. Check that all chimney pipe joints are securely fastened. of sharp edges inside the stove. 2. Check that the heater is securely fastened to the floor (if Note: Installation of the baffle bricks and insulating blanket is applicable). easier when you can still access the flue outlet, (before con- necting the flue pipe). Besure the insulating blanket isplaced 3. Make s
Resumo do conteúdo contido na página número 12
3. Included with the stove are two 15-1/4”x 11-1/2”x 1/2” thick ceramic fiber blankets. Install one blanket above the baffle brick and toeach sideof thesupport bracket. Makesure thatthe blankets arefully to the rear. 4. Next, install the front baffle bricks #33-38 under the ceramic fiber blankets carefully so as not to damage the ceramic fiber blankets. Bricks #33-38 rest rest inthe front two secondarytubes. CAUTION: Ma
Resumo do conteúdo contido na página número 13
Optional Blower Installation A blower, cat. no. 71000, can be installed on the stove to improve hot air distribution throughout the room. To installthe blower: 1. Remove all the contents from the blower box. Included with theblower should bea blowerspeed control. 2. Remove the screw in the round knock out plate on the back of the stove. Bend the knock out plate back and forth until it canbe removed. 3. Mount the blower as sho
Resumo do conteúdo contido na página número 14
4. Light the paper and allow sufficient time for the kindling to become fully engulfed in flames. Close the door. Your door may or may not need to be left slightly open during this process, depending on your stove model and chimney draft. Once the kindling is burning well, larger pieces of woodmay be added,then the door shouldbe closed. Do not operate the stove with the doors open or ajar, as this will produce extreme temperatures within t
Resumo do conteúdo contido na página número 15
Cleaning Glass CAUTION SEE MAINTENANCE ON PAGE 17 FOR GLASS CLEANING TIPS Cleaning Glass: Ensure appliance is cold prior to cleaning glass. A commercial glass cleaner The operator plays an important part in keeping the glass clean and designed for stoves is recommended. Do not use free of buildups. The first and most important part the operator abrasive cleaners. Do not clean with any materials, plays is making sure to burn only well-seasoned firewood
Resumo do conteúdo contido na página número 16
1. Thoroughly preheat your stove before slowing the burn Maximizing Your Stove’s Overall Efficiency rateby closing the draft control. It is important to know that for high, combustion efficient, clean 2. Measure the stove temperature at the hottest point on burns, you will need to have sufficient temperatures inside the the stove top or face. Use this information to repeat burn firebox for thorough combustion. The best method for determining rates. if
Resumo do conteúdo contido na página número 17
Experiment with different loading configurations to achieve Maintenance longer burns. Try loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh DOOR HINGES: If door hinges need lubricating, use an anti-seize wood should be loaded to the back of the firebox or to the sides. compound (never use oil) available from your Lennox Hearth Hot coals or half burned wood should be
Resumo do conteúdo contido na página número 18
Troubleshooting Problem Solution POOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys nor- mally have poor drafts. Remember, the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4). If your stove is not drafting properly, your chimney is the problem. All stoves are thoroughly testedto ensure proper draft with the correct size chimney fl
Resumo do conteúdo contido na página número 19
Do’s and Don’ts DO NOT: Install or operatethis stove before reading this manual. DO NOT: Close the draft beyond the point at which the flames are completely extinguished. DO NOT: Open the stove door without fully opening the draft first. DO NOT: Burn driftwood or wood that has been in salt water. This includes some mill ends and scrap lumber that has been floatedin salt water on the wayto the mill. (This will void your warranty). DO NOT: Handle the Nickel or Goldfaceplate
Resumo do conteúdo contido na página número 20
(RR) Remove H5515 H5558 is replaced by 70003 H5619 is replaced by 70008 H5620 is replaced by 70007 H5621 is replaced by 70002 H5622 is replaced by 70001 H5669 is replaced by 70000 Add 4 per pkg (done 5-2-08) Replacement Parts - Models SS10 HANDLES H5654 Spring Handle / Nickel Contact an Authorized Lennox Hearth Products dealer to obtain any of these parts. Never use substitute materials. Use of H565 Spring Handle / Gold non-approved parts can result in poor per
