Resumo do conteúdo contido na página número 1
INSTALLATION AND OPERATION
MANUAL
EPA CERTIFIED
WOOD BURNING
STOVE
Model CI2000HT Shown
RETAIN THESE
INSTRUCTIONS
Spectra Series Wood Stoves
FOR FUTURE
MODELS CI1000HT and CI2000HT
REFERENCE
THIS APPLIANCE MUST BE INSTALLED BY A QUALIFIED INSTALLER. READ
ENTIRE MANUAL THOROUGHLY BEFORE INSTALLATION.
P/N 775,080M; Rev. F,
Resumo do conteúdo contido na página número 2
IMPORTANT WARNINGS PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW ROOM HEATER. FOR YOUR SAFETY, FOLLOW THE INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS EXACTLY, WITHOUT DEVIATION. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH. IF THIS APPLIANCE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. CONTACT YOUR LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLA- TION INSPECTION REQUIREMENTS IN YOUR
Resumo do conteúdo contido na página número 3
TABLE OF CONTENTS Important Warnings ................................................ 2 CONGRATULATIONS ON THE PURCHASE OF YOUR Testing/Listing, EPA, Using this Manual.................. 3 NEW WOODSTOVE MANUFACTURED BY LENNOX HEARTH PRODUCTS. Planning Your Installation ..................................... 4-9 When you purchased your new woodstove, you Installation ........................................................ 10-14 joined the ranks of thousands of concerned indi- vidu
Resumo do conteúdo contido na página número 4
PLANNING YOUR INSTALLATION QUESTIONS TO ASK LOCAL BUILDING OFFICIAL ♦ Existing Chimneys A correct installation is critical and imperative for reduc- ♦ Wood Storage ing fire hazards and perilous conditions that can arise ♦ Aesthetic Considerations when wood burning appliances are improperly installed. ♦ Roof Design (Rafter Locations & Roof Pitch) The installer must follow all of the manufacturers’ in- ♦ Room Traffic structions. These models are designed as radiant room ♦ Proximity to
Resumo do conteúdo contido na página número 5
PLANNING YOUR INSTALLATION – Model CI1000HT T (inches) = 1.92 x 1/2” M FLOOR PROTECTION .84 FOR INSTALLATIONS IN THE USA Answer using k: 2.286 x 0.50” = 1.143 = ~ 1 9/64” MODEL CI1000HT 1 9/64” thickness Durock Cement Board will be required. The floor protector must meet or exceed the minimum ther- mal requirements as defined on this page (see Floor Protec- Using the r formula: tion Using Alternate Material As Floor Protector). If the floor protection is to be ston
Resumo do conteúdo contido na página número 6
PLANNING YOUR INSTALLATION – Model CI1000HT T (inches) = 1.92 x .1.45” M FLOOR PROTECTION .84 FOR INSTALLATIONS IN CANADA Answer using k: ~2.287 x ~1.45” = ~ 3.316” = ~ 3 5/16” MODEL CI1000HT ~ 3 5/16” thickness Durock Cement Board will be required. The floor protector must meet or exceed the minimum ther- Using the r formula: mal requirements as defined on this page (see Floor Pro- tection Using Alternate Material As Floor Protector). If the T (inches) = 1.19 x T
Resumo do conteúdo contido na página número 7
PLANNING YOUR INSTALLATION– Model CI2000HT T (inches) = 1.92 x 1/2” M FLOOR PROTECTION .84 FOR INSTALLATIONS IN THE USA & CANADA Answer using k: 2.286 x 0.50” = 1.143 = ~ 1 9/64” ~1 9/64” thickness Durock Cement Board will be required. MODEL CI2000HT The floor protector must meet or exceed the minimum ther- Using the r formula: mal requirements as defined on this page (see Floor Protec- tion Using Alternate Material As Floor Protector). If the floor T (inches) = 1.1
Resumo do conteúdo contido na página número 8
PLANNING YOUR INSTALLATION– Model CI1000HT MODEL CI1000HT Parallel Installation COMBUSTIBLE WALL CLEARANCE – USA & Canada WARNING: It is very important that you observe the D minimum clearances. A E There are listed clearances for your stove which were determined in a Laboratory test using various "classes" B of stove pipe or chimney. Minimums are first estab- lished for the stove itself and increased based on how much heat is transferred by each class of pipe. Pos
Resumo do conteúdo contido na página número 9
PLANNING YOUR INSTALLATION– Model CI2000HT MODEL CI2000HT Parallel & Alcove Installations COMBUSTIBLE WALL CLEARANCE – USA & Canada WARNING: It is very important that you observe the D A minimum clearances. There are listed clearances for your stove which were determined in a Laboratory test using various "classes" of stove pipe or chimney. Minimums are first established B E for the stove itself and increased based on how much heat is transferred by each class of pipe.
Resumo do conteúdo contido na página número 10
INSTALLATION When Using Approved Double Wall Pipe (Approved INSTALLING LEG PADS for Model CI2000HT Only): Type L and listed double The four leg pads (included in accessory package), are wall connector pipe is acceptable. Install any factory-built provided for placement under the four legs. brand of pipe according to the manufacturer's instruc- tions. All pipe connections must be sealed (ie. high tem- TYPES OF CHIMNEYS perature silicone). The unit must be connected to either a code-
Resumo do conteúdo contido na página número 11
INSTALLATION CHIMNEY INSPECTION SPECIAL NOTE: Existing chimneys must be inspected before installing The installation of a barometric damper is recommended your stove. Consult your local building department for for all freestanding stoves in areas that may have high chimney code requirements. A masonry chimney must winds, which can effect the draft. The installation must be have a code approved liner. This liner must not have only in units with a newly constructed chimney, free of broken
Resumo do conteúdo contido na página número 12
INSTALLATION DRAFT REQUIREMENTS 3) Drill a hole in the vent pipe per the draft gauge manu- facturers instructions (to create a draft test port). Note: The appliance is merely one component of a larger system. The other equally important component is the Hole location should be a minimum of 1 foot above flue outlet collar. venting system which is necessary for achieving the required flow of combustion air to the fire chamber and 4) Start a fire (See How To Start And Maintain A Fire on pa
Resumo do conteúdo contido na página número 13
INSTALLATION See Pipe Manufacturers Instructions For Installation Requirements Of Venting Components And Vent Clearances. SINGLE WALL PIPE DOUBLE WALL PIPE Using 6” Diameter Single Wall Connector Pipe (Approved for Model CI2000HT Only) Using 6” Diameter Type L-Vent Connector Pipe Chimney Termination Cap Termination Cap with Spark Arrestor Storm Collar 3 Feet Minimum Storm Collar Roof Flashing Flashing Ceiling Support Assembly Support Box Minimum of 12-15' of Slip Flue
Resumo do conteúdo contido na página número 14
INSTALLATION – Combustible Wall Chimney Connector Pass-Throughs Min. Chimney Clearance to Brick & A Method A. 12” (305 mm) Clearance to Combustible Wall Mem- Combustibles – 2 in. (51mm) ber: Using a minimum thickness 3.5” (89 mm) brick and a 5/8” (16 mm) minimum wall thickness clay liner, construct a wall pass- Min. Clearance 12 in. (304.8mm) of Brick through. The clay liner must conform to ASTM C315 (Standard Specification for Clay Fire Linings) or its equivalent. Keep a mini- mum o
Resumo do conteúdo contido na página número 15
CARE AND OPERATION PRIMARY AIR DRAFT CONTROL Adjusting Burn Rate: Use the air control adjustment tool (provided) to adjust The primary air draft control located above the front door the air controls per the following instructions. can be adjusted to the right for higher temperatures and to the left for lower temperatures. Air Control / Ash Pan Removal Tool Generally, you will want to set the draft control some- where in the low or medium range Tips - Adjust the primary air co
Resumo do conteúdo contido na página número 16
CARE AND OPERATION HOW TO START AND MAINTAIN A FIRE CI1000HT 1. Using the Air Control Tool (provided), open the Side Cut-A-Way View Start-Up Air Control (see Start-Up Air Control, on page 15). 2. Adjust the primary air draft control to the full open Primary Air position (see Primary Air Draft Control on page 15). Control 3. Open the side fuel loading door and build your fire directly on the grate in the firebox. a. Place five or six loosely crumpled sheets of newspaper
Resumo do conteúdo contido na página número 17
CARE AND OPERATION FRONT ASH REMOVAL DOOR AND SIDE FUEL LOAD- REPLENISH HUMIDITY LEVEL OF DWELLING ING DOOR Heating the air in a closed building decreases the relative humidity of the air, which will dry wood and other com- CAUTION: When opening the doors, do not extend bustible materials. This drying lowers the ignition tem- them beyond their normal travel. Overextending the perature of these materials, thus increasing the fire haz- doors to a further open position can put excessive a
Resumo do conteúdo contido na página número 18
CARE AND OPERATION FIRST FIRE To prevent smoke blowing into the room follow these recommendations: NOTE: There is often an unpleasant odor and non- toxic fumes during the first initial burns (this is a 1. Using the air control tool adjust the primary air draft natural result of the paint curing). We recommend control and start-up air control to the full open posi- that a window should be left open near the appliance tion and let the fire "liven up" for about one minute before opening
Resumo do conteúdo contido na página número 19
CARE AND OPERATION BURN RECOMMENDED FUEL When loading wood, add one or two logs at a time, This appliance is designed for use with natural well- depending on size. Loading the appliance full of seasoned wood. Do not burn particleboard scraps or damp wood on a low fire is certain to cause poor pressed logs because they can produce conditions which combustion efficiency resulting in creosote and dirty will deteriorate metal. Green or uncured wood does not glass. work well as fuel, and ca
Resumo do conteúdo contido na página número 20
CARE AND OPERATION SEASONING GUIDE WOOD STORAGE Softwoods – 18 months Wood to be seasoned should be stacked in an area open Hardwoods – 18 months to 24 months enough to ensure good air circulation on both sides – leaving adequate space between woodpiles to walk com- This period can be shortened (12 to 15 months) if the fortable. Do not stack wood against a wall or building. It wood is cut to the right length and immediately stored helps to elevate the woodpiles off the ground (two 2
