Resumo do conteúdo contido na página número 1
SAFETY PRECAUTIONS 1
ECO - 65
OWNER’S MANUAL
Warning: If your appliance is not properly installed a house fire may result. For your safety, follow the
installation directions. Contact local building or fire officials about restrictions and installation inspection
requirements in your area. These authorities should be consulted to determine if there is a need to obtain a
permit.
PLEASE read this entire manual before
Resumo do conteúdo contido na página número 2
SAFETY PRECAUTIONS 2 INTRODUCTION Thank you for purchasing the ECO-65 pellet stove. You are now prepared to burn pellet in the most efficient, convenient way possible. To achieve the safest, most efficient and most enjoyable performance from your stove, you must do three things: 1) Install it properly; 2) Operate it correctly; and 3) Maintain it regularly. The purpose of this manual is to help you do all three. PLEASE read this entire manual before installation and use of this pel
Resumo do conteúdo contido na página número 3
SAFETY PRECAUTIONS 3 SAFETY PRECAUTIONS DO NOT OPERATE YOUR STOVE IF KEEP FOREIGN OBJECTS OUT OF YOU SMELL SMOKE COMING FROM IT. THE HOPPER. TURN IT OFF, MONITOR IT, AND CALL YOUR DEALER. NEVER USE GASOLINE, DO NOT THROW THIS MANUAL GASOLINE-TYPE LANTERN FUEL, AWAY. THIS MANUAL HAS IMPORTANT KEROSENE, CHARCOAL LIGHTER OPERATING AND MAINTENANCE FLUID, GARBAGE, NAPHTA, ENGINE INSTRUCTIONS THAT YOU WILL NEED AT OIL OR SIMILAR LIQUIDS TO START A LATER TIME. ALWAYS FOLLOW THE
Resumo do conteúdo contido na página número 4
SAFETY PRECAUTIONS 4 THIS UNIT MUST BE PROPERLY YOUR STOVE REQUIRES PERIODIC INSTALLED TO PREVENT THE MAINTENANCE AND CLEANING. FAILURE POSSIBILITY OF A HOUSE FIRE. THE TO MAINTAIN YOUR STOVE MAY LEAD INSTRUCTIONS MUST BE STRICTLY TO SMOKE SPILLAGE IN YOUR HOME. ADHERED TO. DO NOT USE MAKESHIFT METHODS OR COMPROMISE IN THE INSTALLATION. ALLOW THE STOVE TO COOL THIS APPLIANCE IS DESIGNED AND BEFORE CARRYING OUT ANY TESTED SPECIFICALLY FOR USE ONLY MAINTENANCE OR CLEANING. ASHE
Resumo do conteúdo contido na página número 5
TABLE OF CONTENTS SAFETY PRECAUTIONS ....................................................................................................................................... 3 1. INSTALLATION ......................................................................................................................................... 7 1.1. FEATURES ..............................................................................................................................................
Resumo do conteúdo contido na página número 6
4. TROUBLESHOOTING GUIDE ................................................................................................................ 30 5. ELECTRICAL DIAGRAM ........................................................................................................................ 36 5.1. FUSE ACCESS ........................................................................................................................................ 37 6. REPLACEMENT PARTS ..............
Resumo do conteúdo contido na página número 7
1. INSTALLATION 1.1. FEATURES DROLET ECO-65 FREESTANDING PELLET STOVE Width: 24” Height: 41” Depth: 30” Weight: 375 lbs. Flue size: 4” Hopper Capacity: Up to 125 lbs. (This can vary depending on pellet size, length, and diameter) FIGURE 1 EPA status: < 4.5 g/h. Back wall installation Burn rate: 1.3 lbs to 7.9 lbs. per hour BTU range: 10,500 to 65,000 Electrical consumption: o 5 Amps lighting cycle o 2.5 Amps. continuous duty Control board fuse
Resumo do conteúdo contido na página número 8
CAUTION: DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE INSTALLATION OF THIS UNIT. CAUTION: INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. This heating unit must serve as a supplementary heat source. An alternative heat source should be available in the home if needed. The manufacturer cannot be responsible for additional heating costs associated with the use of an alternative heat source. It is highly recommended that the user buys this product fro
Resumo do conteúdo contido na página número 9
FIGURE 6. The fresh air intake damper FIGURE 8 FIGURE 7 Fresh air supply Fresh air supply
Resumo do conteúdo contido na página número 10
1.5. ANCHOR THE STOVE The stove must be anchored to the floor with screws. Please use the two holes located on each side of the pedestal. (See Fig. 9) FIGURE 9 Anchor 1.6. VENTING In Canada, we recommend that you use a listed pellet vent that meets the ULC S-609-M89/ORD C441-M90 Standard. For the United States, we recommend that you use a listed pellet vent that meets the UL-641Standard. This unit can be vented in an existing factory-built or masonry chimney wi
Resumo do conteúdo contido na página número 11
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT. INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. WARNING: DO NOT INSTALL IN BEDROOM CAUTION: THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED CAUTION: THE CHIMNEY CONNECTOR SHALL NOT PASS TROUGH AN ATTIC OR ROOF SPACE, CLOSET OR SIMILAR CONCEALED SPACE, OR A FLOOR, OR
Resumo do conteúdo contido na página número 12
4. Install Vent wall thimble per Vent manufacturer‟s instructions. 5. Attach enough piping to penetrate and extend at least 6 inches beyond the exterior wall. There should always be at least one foot of vertical rise for each foot of horizontal run (see Appendix A). At least 3 feet of vertical rise are needed in all cases. A longer vertical rise will favour a better exhaust. FIGURE 11 Venting through wall 6. To reduce the risk of smoke spill
Resumo do conteúdo contido na página número 13
In the US: a) less than 3 feet above any forced air inlet located within 10 feet; b) less than 4 feet below or horizontally from, or one foot above, any door, window or gravity air inlet into any building; c) less than two feet from an adjacent building and not less than 7 feet above grade when located adjacent to a public walkway. Mobile home installations must use a spark arrester. Other restrictions may apply, such as the need to maintain a minimum distance to a gas meter. See NFP
Resumo do conteúdo contido na página número 14
FIGURE 13 Venting through roof c) VERTICALLY INTO EXISTING CHIMNEY SYSTEM (Refer to Figure 14) As an alternative, 4” Vent can be run inside existing chimney to termination (Figure 12). This is the preferred method. Follow guidelines for equivalent vent length. FIGURE 14 Venting through existing chimney
Resumo do conteúdo contido na página número 15
d) VERTICALLY INTO EXISTING MASONRY FIREPLACE (Refer to figure 15) NOTE: Follow Vent chimney manufacturer‟s instructions. 1. Have the masonry chimney inspected by a qualified chimney sweep or installer to determine its structural condition. 2. You will need a pipe length equal to the chimney height from the hearth. If outside combustion air is to be used, you will need a pipe length equal to the chimney height plus 18 inches. 3. Install a blanking plate and the chimney pip
Resumo do conteúdo contido na página número 16
7. If desired, once the horizontal pipe is in place, the space between the pipe and masonry may be filled with high-temperature grout. Install the trim collar. An adjustable pipe length and adapter may be needed to finish the connection to the stove. Figure 16 Venting through side of masonry chimney
Resumo do conteúdo contido na página número 17
2. OPERATION 2.1. PROPER FUEL THIS STOVE IS APPROVED FOR BURNING four different types of pellets: standard wood pellets, 100% bark pellets, sawdust/hay mix pellets, and switch grass pellets! Each type of pellet has its properties and will burn differently. The ash produced can also vary greatly. Factory-approved pellets are those ¼” or 5/16” in diameter and not over 1” long. Longer or thicker pellets sometimes bridge the auger flights, which prevents proper pellet feed. Burning
Resumo do conteúdo contido na página número 18
2.5. LIGHTING PROCEDURE a. Fill hopper and clean burn pot. b. Press “MODE” button to select the desired setting “MANUAL” or “THERMOSTAT” c. Adjust feed rate to desired setting by pressing “-” or “+” button. If fire doesn‟t start in 35 minutes, a warning code will appear. Refer to troubleshooting section for more details. 2.6. UNIT CONTROLS (See Figure 16) The blowers and automatic fuel supply are controlled from a panel on the right-hand side of the ECO-65. The control panel fun
Resumo do conteúdo contido na página número 19
c. CONVECTION BLOWER SPEED CONTROL The convection blower speed varies directly with the fuel feed rate. Reducing the blower speed will also reduce the noise. When the “CONVECTION BLOWER SPEED CONTROL” button is pushed, the convection blower will switch to its lowest speed. The convection blower will remain at its lowest speed unless the stove reaches a certain temperature. If this occurs, the convection blower will go back to its highest setting to cool down the stove. The “CO
Resumo do conteúdo contido na página número 20
2.10. REFUELING We recommend that you do not let the hopper drop below ¼ full. If the reload lid stays open for more than 3 minutes, a warning will appear. To restart, press the “RESET” button, and then press the “MODE” button to start the unit on Manual or Thermostatic mode. KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING. THE HOPPER MAY BE FILLED WHILE THE STOVE IS OPERATING. DO NOT OVERFILL HOPPER. 2.11. SHUTDOWN PROCEDURE Turning your Drolet stove off is
